Microchip MIC7400 Handleiding

Microchip Niet gecategoriseerd MIC7400

Lees hieronder de 📖 handleiding in het Nederlandse voor Microchip MIC7400 (62 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 18 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/62
2017 Microchip Technology Inc. DS20005887A-page 1
MIC7400
Features
• Input Voltage: 2.4V to 5.5V
• Five Independent Synchronous Bucks up to 3A
• One Independent Non-Synchronous Boost
200 mA
• 200 µA Quiescent Current (All Regulators On)
• 93% Peak Buck Efficiency, 85% Typical Efficiency
at 1 mA
• Dual Power Modes: Stand-by and Normal Mode
• I2C Interface up to 3.4 MHz
• I2C On-the-Fly EEPROM Programmability,
Featuring:
- Buck and Boost Output Voltage Scaling
- Power-on-Reset Threshold and Delay
- Power-Up Sequencing/Sequencing Delay
- Buck and Boost Current-Limit
- Buck and Boost Pull-Down when Disabled
- Individual ON, OFF, and Stand-by Modes
- Soft-Start and Global Power-Good Masking
• 23 µA Buck Typical Quiescent Current
• 70 µA Boost Typical Quiescent Current
• 1.5% Output Accuracy over
Temperature/Line/Load
• 2.0 MHz Boost Switching Frequency
• 1.3 MHz Buck Operation in Continuous Mode
• Ultra-Fast Buck Transient Response
• 15 mm x 15 mm x 1.25 mm Solution Size
• Thermal Shutdown and Current-Limit Protection
• 36-Pin 4.5 mm x 4.5 mm x 0.85 mm FQFN
Package (0.4 mm Pitch)
• –40°C to +125°C Junction Temperature Range
Applications
• Client and Enterprise Solid State Drives (SSD)
• Consumer and In-Vehicle Infotainment Devices
• Multimedia Devices
• Portable Handheld Devices
• Security Cameras
• Gaming Machines
• Service Provider Gateways
General Description
The MIC7400 is a powerful, highly integrated,
configurable, power management IC (PMIC) featuring
five synchronous buck regulators, one boost regulator
and high-speed I2C interface with an internal
EEPROM.
The device offers two distinct modes of operation—
“stand-by mode” and “normal mode”—intended to
provide an energy-optimized solution suitable for
portable handheld, and infotainment applications.
In normal mode, the programmable switching
converters can be configured to support a variety of
features, including start-up sequencing, timing,
soft-start ramp, output voltage levels, current-limit
levels and output discharge for each channel.
In stand-by mode the PMIC can be configured in a low
power state by either disabling an output or by
changing the output voltage to another voltage level,
either lower or higher than normal-mode. In general, it's
assumed that the voltage in standby mode is lower than
the one in normal mode. Independent exit from
stand-by mode can be achieved either by I
2C
communication or the external STBY pin.
The device has five synchronous buck regulators with
high-speed adaptive on-time control supporting even
the challenging ultra-fast transient requirement for
Core supplies. One boost regulator provides a flash
memory programming supply that delivers up to
200 mA of output current. The boost is equipped with
an output disconnect switch that opens if a
short-to-ground fault is detected.
An internal EEPROM enables a single-chip solution
across many platforms by allowing the designer to
customize the PMIC for their design. Modifications can
be made without the need to re-approve a new PMIC,
saving valuable design resources and time.
All switchers provide light load efficiency with
HyperLight Load® mode for buck and PFM mode for
boost. An additional benefit of this proprietary
architecture is very low output ripple voltage throughout
the entire load range with the use of small output
capacitors. The MIC7400 is designed for use with a
small inductors (down to 0.47 µH for buck, 1.5 µH for
boost), and an output capacitor as small as 10 µF for
buck, enabling a total solution size of 15 mm x 15 mm
and less than 1 mm height.
Configurable PMIC, Five Channel Buck Regulator Plus One Boost
with HyperLight Load® and I2C Control
MIC7400
DS20005887A-page 2 2017 Microchip Technology Inc.
Typical Application Circuit
MIC7400
DAC
10μF
22μF
2.2μH
OUT2PGND2SW2
PVIN2
ISNS ZC
SYNC
BUCK2
ON-TIME
CONTROL
DAC
ISNS
ZC
SYNC
BUCK3
ON-TIME
CONTROL
DAC
10μF
22μF
2.2μH
OUT3
PGND3
SW3
PVIN3
10μF
22μF
2.2μH
OUT4
PGND4
SW4
PVIN4
I
SNS
ZC
SYNC
BUCK4
ON-TIME
CONTROL
DAC
EEPROM I2C
INTERFACE
DIG CTRL
SDA
SCL
PG
VSLT
STBY
10μF
22μF
OUT5
PGND5
SW5
PVIN5
ISNS ZC
SYNC
BUCK5
ON-TIME
CONTROL
DAC
2.2μH
SEQUENCY
CONTROL
ANALOG
CONTROL
BIASING
CIRCUIT
DIGITAL
CONTROL
FAULT
MONITOR
(OTP, OCP)
STAND-BY
POWER
MANAGEMENT
DAC ARRAY
AND
SOFT-START
OSC
DIG CTRL
ANALOG CTRL
DIG CTRL
ANALOG CTRL
UVLO
AND BG
POR
COMPARATOR
AVIN
AGND
POR
10μF
22μF
OUT6
2.2μH
PVIN6O
SW6
PGND6
PVIN6
ISNS
ON/OFF
BOOST
ISNS
PWM
CONTROL
ISNS
ZC
SYNC
BUCK1
ON-TIME
CONTROL
DAC
10μF
22μF
2.2μH
PGND1
SW1
PVIN1
OUT1
2017 Microchip Technology Inc. DS20005887A-page 3
MIC7400
Block Diagram
SYNC
BUCK
SW2
OUT2
PGND2
PVIN2
ON-TIME
CONTROL
ZC
SYNC
BUCK
SW3
OUT3
ON-TIME
CONTROL
ISNS
PGND3
PVIN3
SYNC
BUCK
SW4
OUT4
ON-TIME
CONTROL
PGND4
PVIN4
SYNC
BUCK
ON-TIME
CONTROL
PVIN1
SW1
OUT1
PGND1
SYNC
BUCK
ON-TIME
CONTROL
PVIN5
SW5
OUT5
PGND5
ZC
ZC
BOOST
PWM
CONTROL
PVIN6O
OUT6
PGND6
PVIN6
SW6
ON/OFF
FAULT MONITOR
DAC ARRAY
SEQUENCE
CONTROLLER
INPUT LEVEL DETECT
UVLO
VOTLAGE REFERENCE AGND
AVIN
I2C INTERFACE
REGISTERS
(REFERENCED TO AVIN) SCL
SDA
PG
POR
VSLT
STBY
THERMAL
SENSOR SLOW
OSC
ISNS
ZC
ZC
MIC7400
EEPROM
ISNS
ISNS
ISNS
ISNS
ISNS
AGND

Product specificaties

Merk: Microchip
Categorie: Niet gecategoriseerd
Model: MIC7400

Heb je hulp nodig?

Als je hulp nodig hebt met Microchip MIC7400 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd Microchip

Microchip

Microchip EVB-USB2504 Handleiding

17 November 2024
Microchip

Microchip AT97SC3204 Handleiding

17 November 2024
Microchip

Microchip ATECC608B Handleiding

16 Juli 2024
Microchip

Microchip HV860 Handleiding

16 Juli 2024
Microchip

Microchip EVB-LAN9255 Handleiding

16 Juli 2024
Microchip

Microchip LX4580 Handleiding

16 Juli 2024
Microchip

Microchip LX7720 Handleiding

16 Juli 2024
Microchip

Microchip AT32UC3C0128C Handleiding

10 April 2024
Microchip

Microchip AT32UC3C1512C Handleiding

10 April 2024
Microchip

Microchip AT32UC3A3256 Handleiding

10 April 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Livarno Lux

Livarno Lux IAN 071407 Handleiding

29 November 2024
Livarno Lux

Livarno Lux IAN 317128 Handleiding

29 November 2024
Livarno Lux

Livarno Lux IAN 049213 Handleiding

29 November 2024
Livarno Lux

Livarno Lux ST-1002 Handleiding

29 November 2024
Livarno Lux

Livarno Lux HG02489 Handleiding

29 November 2024
Livarno Lux

Livarno Lux HG02189 Handleiding

29 November 2024
Livarno Lux

Livarno Lux IAN 365198 Handleiding

29 November 2024
Livarno Lux

Livarno Lux IAN 367074 Handleiding

29 November 2024
Livarno Lux

Livarno Lux HG00701 Handleiding

29 November 2024
Livarno Lux

Livarno Lux IAN 337273 Handleiding

29 November 2024