Microchip MIC4801YM Handleiding

Microchip Niet gecategoriseerd MIC4801YM

Lees hieronder de 📖 handleiding in het Nederlandse voor Microchip MIC4801YM (5 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 205 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/5
MIC4801 Evaluation Board
High Efficiency 600mA Single Channel
Linear WLED Driver with
Ultra Fast PWM™ Control
Ultra Fast PWM is a trademark of Micrel, Inc.
Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1 (408) 944-0800 • fax + 1 (408) 474-1000 • http://www.micrel.com
General Description
The MIC4801 is a high efficiency, single channel, White
LED (WLED) driver. This constant current linear device is
designed to drive a single high power WLED up to 600mA
and features a low dropout of 130mV at 400mA (typical).
Brightness is controlled through an Ultra Fast PWM™
interface which can operate from 1% to 100% duty cycle.
The MIC4801 is available in an 8-pin SOIC leaded
package with a junction temperature range of -40°C to
+125°C
Requirements
The MIC4801 evaluation board requires a power supply
that is capable of delivering at least 1A while providing an
input voltage between 3.0V and 5.5V.
Precautions
The MIC4801 evaluation board is designed for an input
voltage no greater than 6V. This evaluation board does not
have reverse polarity protection; hence, applying a
negative voltage to the VIN terminal may damage the
device.
Getting Started
1. Connect an external supply to VIN. Apply the
desired input voltage across VIN and ground
terminals, J2 and J3, respectively, paying careful
attention to polarity and supply voltage
(3.0VVIN5.5V). An ammeter may be placed
between the input supply and the VIN terminal to
the evaluation board. Ensure that the supply
voltage is monitored at the VIN terminal. The
ammeter and/or power lead resistance can reduce
the voltage supplied to the input. VBAT is
connected to VIN through a 0 resistor, R1.
2. Enable/Disable the MIC4801
To enable the device, apply a DC voltage of 1.2V or
greater to the EN pin. This allows for full brightness of
the WLED (100% duty cycle). The EN pin can also be
used for dimming by connecting a PWM signal and
varying its duty cycle (please refer to the Ultra Fast
PWM™ Dimming Interface Section in datasheet).
Pulling EN low for more than 40ms forces the
MIC4801 into a low IQ sleep mode. Do not leave the
EN pin floating as this may cause an indeterminate output
state. A pull up resistor of 10k is placed from EN (JP1)
to VIN to ensure that the WLED is ON when an input signal
is applied.
3. Setting LED current with RSET resistor.
The average LED current may be calculated using the
equation below:
( )
140.0)(
4920
)(
140.0
)(
4920
)(
−Ω
⋅
=
+
⋅
=Ω
kR
D
mAI
mAI
D
kR
SET
LED
LED
SET
D is the duty cycle of the LED current during PWM
dimming; D=1 when device is fully ON. The stock
evaluation board uses an RSET value of 12.1k which
corresponds to ILED of 411mA.
4. Measuring WLED current.
To measure WLED current, simply insert an ammeter
in series with the WLED(s). Keep in mind that a series
ammeter will add a small voltage drop, so the voltage
at the WLED terminal, D1, should be used when
making dropout measurements with a series ammeter.
Ordering Information
Part Number Description
MIC4801YM EV Evaluation board with the Single
Channel MIC4801 device
March 2011 M9999-032111-B
Micrel, Inc. MIC4801 Evaluation Board
March 2011 2 M9999-032111-B
MIC4801 Evaluation Board Schematic
MIC4801
C1
2.2µF
VIN
RSET
EN
D1
GND
VB
A
T
J1
LED1
R1
0Ω
R2
open
R3
10kΩ
R4
12.1kΩ
VIN
J2
RSET
J4 D1
J6
GND
J5
GND
J3
C2
open
JP1
Bill of Materials
Item Part Number Manufacturer Description Qty.
C1608X5R0J225K TDK(1)
06036D225KAT2A AVX
(2)
GRM188R60J225KE19D Murata(3)
VJ0603G225KXYAT Vishay(4)
C1
CL10B225KQ8NNNC Samsung(5)
Ceramic Capacitor, 2.2µF, 6.3V, X5R, Size 0603 1
C2 Open 1
R1 CRCW06030000FKEA Vishay
Resistor, 0Ω, 1%, 1/16W, Size 0603 1
R2 open
R3 CRCW060310K0FKEA Vishay
Resistor, 10kΩ, 1%, 1/16W, Size 0603 1
R4 CRCW060312K1FKEA Vishay Resistor, 12.1kΩ, 1%, 1/16W, Size 0603 1
LED1 W42180 Seoul Semiconductor(6) 3.8W High Power WLED 1
U1 MIC4801YM Micrel, Inc.(7) 600mA Single Channel Ultra Fast PWM™
Linear WLED Driver 1
Notes:
1. TDK: www.tdk.com
2. AVX: www.avx.com
3. Murata: www.murata.com
4. Vishay: www.vishay.com
5. Samsung: www.samsung.com
6. Seoul Semiconductor: www.seoulsemicon.com
7. Micrel, Inc.: www.micrel.com
Micrel, Inc. MIC4801 Evaluation Board
March 2011 3 M9999-032111-B
PCB Layout Recommendations
Top Layer
Bottom Layer

Product specificaties

Merk: Microchip
Categorie: Niet gecategoriseerd
Model: MIC4801YM

Heb je hulp nodig?

Als je hulp nodig hebt met Microchip MIC4801YM stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd Microchip

Microchip

Microchip EVB-USB2504 Handleiding

17 November 2024
Microchip

Microchip AT97SC3204 Handleiding

17 November 2024
Microchip

Microchip ATECC608B Handleiding

16 Juli 2024
Microchip

Microchip HV860 Handleiding

16 Juli 2024
Microchip

Microchip EVB-LAN9255 Handleiding

16 Juli 2024
Microchip

Microchip LX4580 Handleiding

16 Juli 2024
Microchip

Microchip LX7720 Handleiding

16 Juli 2024
Microchip

Microchip AT32UC3C0128C Handleiding

10 April 2024
Microchip

Microchip AT32UC3C1512C Handleiding

10 April 2024
Microchip

Microchip AT32UC3A3256 Handleiding

10 April 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Livarno Lux

Livarno Lux IAN 071407 Handleiding

29 November 2024
Livarno Lux

Livarno Lux IAN 317128 Handleiding

29 November 2024
Livarno Lux

Livarno Lux IAN 049213 Handleiding

29 November 2024
Livarno Lux

Livarno Lux ST-1002 Handleiding

29 November 2024
Livarno Lux

Livarno Lux HG02489 Handleiding

29 November 2024
Livarno Lux

Livarno Lux HG02189 Handleiding

29 November 2024
Livarno Lux

Livarno Lux IAN 365198 Handleiding

29 November 2024
Livarno Lux

Livarno Lux IAN 367074 Handleiding

29 November 2024
Livarno Lux

Livarno Lux HG00701 Handleiding

29 November 2024
Livarno Lux

Livarno Lux IAN 337273 Handleiding

29 November 2024