Microchip HV861 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Microchip HV861 (18 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 25 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/18
 2023 Microchip Technology Inc. and its subsidiaries DS20005911A-page 1
HV861
Features
• Adjustable Output Regulation for Dimming
• Lamp Fade-in/Fade-out Capability
• Low Audible Noise
• 180 VPP Output Voltage for Higher Brightness
• 1.5V Enable Input Logic High
• Single-cell Lithium Ion-compatible
• One Miniature Inductor to Power both Lamps
• Separately Adjustable Lamp and Converter
Frequencies
• Split Supply Capability
Applications
• Dual Display Cellular Phones
• Keypad and LCD Backlighting
• Personal Digital Assistant (PDA)
• Handheld Wireless Communication Products
• Global Positioning Systems (GPS)
General Description
The HV861 is a low-noise dimmable high-voltage dual EL
lamp driver designed for driving two electroluminescent
(EL) lamps with a combined area of 5 in2. The input
supply voltage range is from 2.5V to 4.5V. Enable input
logic high can go as low as 1.5V, which allows logic
interface operating from typical 1.8V supplies. The
device is designed to minimize audible noise emitted by
the EL lamps.
The device uses a single inductor and a minimum
number of passive components. With the internal
reference voltage, the regulated output voltage is at a
nominal value of 90V. The EL lamps therefore see ±90V.
The two EL lamps can be turned on and turned off using
two CMOS logic inputs, EN1 and EN2. The driver is
disabled when both EN1 and EN2 are at logic low.
The HV861 has two internal oscillators, a switching
MOSFET, and two high-voltage EL lamp driver
H-bridges. Each driver has its own half-bridge common
output, COM1 and COM2, which significantly minimizes
the DC offset seen by the EL lamp. The frequency for the
switching MOSFET is set by an external resistor
connected between the R SW-Osc pin and the supply pin,
VDD. The EL lamp driver frequency is set by an external
resistor connected between the REL-Osc pin and the VDD
pin. An external inductor is connected between the L X
and VDD pins or VIN for split supply applications.
Depending upon the EL lamp sizes, a 1 nF to 10 nF
capacitor is connected between the C S and ground. As
the switching MOSFET charges the external inductor
and discharges it into the capacitor at CS, the voltage at
CS starts to increase. Once the voltage at C S reaches a
nominal value of 90V, the switching MOSFET is turned
off to conserve power.
EL lamp dimming can be accomplished by applying a
PWM logic signal to the PWM pin. The EL lamp
brightness will be inversely proportional to the PWM duty
cycle. The HV861 can also slowly turn on or turn off the
EL lamp, giving a fade on/off appearance.
Package Type
See Table 2-1 for pin information.
16-lead WQFN
(Top view)
1 12
2
3
4
5 6 7 8
9
10
11
13141516
VREF VREG VOUT PWM
EL1
COM1
COM2
EL2
REL-Osc
RSW-Osc
VDD
EN1
EN2 GND LX CS
Low-Noise Dimmable Dual EL Lamp Driver
HV861
DS20005911A-page 2 2023 Microchip Technology Inc. and its subsidiaries 
Functional Block Diagram
VCS
VCS
VCS
EL1
COM1
EL2
COM2
Output
Drivers
VSENSE
1.26V
VREF
PWM Switch
Oscillator
0 to 88%
2 x EL Freq.
1 x EL Freq.
CS
LXVDD
EN1
EN2
RSW-Osc
VREG
VOUT
GND
REL-Osc
PWM VREF
EL1 Enable
EL2 Enable
60pF
C
+
-
 2023 Microchip Technology Inc. and its subsidiaries DS20005911A-page 3
HV861
Typical Application Circuit
100μH
3.3MΩ
2.0MΩ
825kΩ
VDD = 3.0V
0.1μF
2.2μF
Input Logic Control:
ON = 1.5 to VDD
OFF = 0 to 0.2V
GND
EN1
VDD
1
2
3
4
87
6
5
9
10
11
12
14
15
16 13
PWMVREF
EN2
RSW-Osc
REL-Osc
VREG VOUT LX CS
EL1
COM1
EL2
COM2
HV861
EL1
EL2
3.3nF
100V NPO
1N4148
4.7μF
VIN = 3.2 to 4.2V


Product specificaties

Merk: Microchip
Categorie: Niet gecategoriseerd
Model: HV861

Heb je hulp nodig?

Als je hulp nodig hebt met Microchip HV861 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Microchip

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd