Microchip ATSAMR34J17 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Microchip ATSAMR34J17 (62 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 21 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/62
SAM R34/R35
SAM R34/R35 Low Power LoRa® Sub-GHz SiP Datasheet
Introduction
The SAM R34/R35 is a family of ultra-low power microcontrollers combined with a UHF transceiver
communication interface. It uses a 32-bit ARM® Cortex® -M0+ processor and offers up to 256 KB of
Flash and 40 KB of SRAM, including an area of battery backed-up SRAM. The UHF transceiver supports
LoRa® and FSK modulation. LoRa technology is a spread spectrum protocol optimized for low data-rate,
ultra-long range signaling. It is ideal for battery-powered remote sensors and controls.
The SAM R34 includes an integrated microcontroller with USB and the UHF transceiver, making it
suitable for USB dongle applications or for software updates via USB. The SAM R35 offers the same
microcontroller functions along with the UHF transceiver without the USB interface.
Features
Operational Features
• Processor:
– ARM Cortex -M0+ CPU running at up to 48 MHz (2.46CoreMark®/MHz)
– Single-Cycle Hardware Multiplier
– Micro Trace Buffer (MTB)
• Memory:
– In-System Self-Programmable Flash Memory, with options for sizes - 256 KB, 128 KB or 64 KB
– Static Random Access Memory (SRAM) with options for sizes - 32 KB, 16 KB or 8 KB
– Low power SRAM Memory with option for sizes - 4 KB or 8 KB
• System:
– Power-on Reset (POR) and Brown-out Reset
– Internal and External Clock Options with 48 MHz Digital Frequency Locked Loop (DFLL48M)
and 48 MHz to 96 MHz Fractional Digital Phase Locked Loop (FDPLL96M)
– External Interrupt Controller (EIC)
– Up to 16 External Interrupts
– One Non-Maskable Interrupt
– Two Pin Serial Wire Debug (SWD) Programming, Test and Debugging Interfaces
• Operating Voltage: 1.8V- 3.6V
• Low Power Consumption
– Transceiver:
• RX = 16 mA (typical)
• RFO_HF = 33 mA (typical)
• PA_BOOST = 95 mA (typical)
© 2019 Microchip Technology Inc. Datasheet DS70005356C-page 1
– MCU:
• Idle, Standby, and Backup Sleep Modes
• SleepWalking peripherals
• Temperature Range: -40°C to +85°C (Industrial)
RF/Analog Features
• Integrated LoRa Technology Transceiver:
– Tri-band Coverage
• 137 MHz to 175 MHz
• 410 MHz to 525 MHz
• 862 MHz to 1020 MHz
– +20 dBm (100 mW) Max Power (VDDANA > 2.4 VDC)
– +17 dBm (50 mW) Max Power (Regulated PA)
– +13 dBm (20 mW) High-efficency PA
• High Sensitivity:
– Down to -136 dBm (LoRaWAN™ protocol compliant modes)
– Down to -148 dBm (proprietary narrowband modes)
• Up to 168 dB Maximum Link Budget
• Robust Front-End: IIp3 = -11 dBm
• Excellent Blocking Immunity
• Low RX Current of 17 mA (typical)
• Fully Integrated Synthesizer with a Resolution of 61 Hz
• LoRa Technology, (G)FSK, (G)MSK and OOK Modulation
• Preamble Detection
• 127 dB Dynamic Range RSSI
• Automatic RF Sense and CAD with Ultra-Fast Automatic Frequency Control (AFC) Packet Engine up
to 256 bytes with Cyclic Redundancy Check (CRC)
Peripheral Information
• 16-Channel Direct Memory Access Controller (DMAC)
• 12-Channel Event System
• Three 16-bit Timer/Counters (TC), configurable as either of the following:
– One 8-bit TC with compare/capture channels
– One 16-bit TC with compare/capture channels
– One 32-bit TC with compare/capture channels, by using two TCs
• Two 24-bit and one 16-bit Timer/Counters for Control (TCC), with Extended Functions:
– Up to four compare channels with optional complementary output
– Generation of synchronized Pulse Width Modulation (PWM) pattern across port pins
– Deterministic fault protection, fast decay and configurable dead-time between complementary
output
– Dithering that increases resolution with up to five bit and reduces quantization error
• 32-bit Real Time Counter (RTC) with Clock/Calendar Function
• Watchdog Timer (WDT)
SAM R34/R35
© 2019 Microchip Technology Inc. Datasheet DS70005356C-page 2
• CRC-32 Generator
• One Full-Speed (12 Mbps) Universal Serial Bus (USB) 2.0 Interface:
– Embedded host and device function
– Eight endpoints
• Up to Five Serial Communication Interfaces (SERCOM), each configurable to operate as either of the
following:
– USART with full-duplex and single-wire half-duplex configuration
– I2C up to 3.4 MHz
– Serial Peripheral Interface (SPI)
– Local Interconnect Network (LIN) Slave
• One 12-bit, 1 Msps Analog-to-Digital Converter (ADC) with up to Eight External Channels:
– Differential and single-ended input
– Automatic offset and gain error compensation
– Oversampling and decimation in hardware to support 13-, 14-, 15-, or 16-bit resolution
• Two Analog Comparators (AC) with Window Compare Function
• Peripheral Touch Controller (PTC):
– 18-channel capacitive touch and proximity sensing
Package Information
• 27 Programmable I/O Pins
• 64 Lead Ball Grid Array (BGA)
SAM R34/R35
© 2019 Microchip Technology Inc. Datasheet DS70005356C-page 3


Product specificaties

Merk: Microchip
Categorie: Niet gecategoriseerd
Model: ATSAMR34J17

Heb je hulp nodig?

Als je hulp nodig hebt met Microchip ATSAMR34J17 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Microchip

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd