Metra 99-6531HG Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor Metra 99-6531HG (8 pagina's) in de categorie Carkit. Deze handleiding was nuttig voor 16 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/8
METRA. The World’s best kits.™metraonline.com © COPYRIGHT 2016 METRA ELECTRONICS CORPORATION
REV. 1/6/2016 INST99-6531HG
CAUTION: Metra recommends disconnecting the negative battery
terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your
local Dealership for more information. All accessories, switches,
climate controls panels, and especially air bag indicator lights
must be connected before reconnecting the battery or cycling
the ignition. Also, do not remove the factory radio with the key
in the on position, or the vehicle running. It would be best to
remove the key from the ignition and then wait a few seconds
before removing the factory radio.
Installation instructions for part 99-6531HG
• ISO DIN radio provision with pocket
• Painted high gloss black
• A) Radio trim panel • B) Radio brackets • C) Radio mounting brackets • D) Pocket • E) (4) Panel clips
• F) (2) #8 x 3/8” Phillips screws • G) (4) 12 mm x 5 mm Phillips screws
KIT FEATURES
KIT COMPONENTS
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • XSVI-6523-NAV Antenna Adapter: • 40-EU55
• Panel removal tool • Phillips screwdriver
• 86-3528 radio removal tool • Cutting tool
• Torx T-25 driver
TOOLS REQUIRED
ADC E F
G
B
Dash Disassembly ................................................. 2
Kit Assembly
– ISO DIN radio provision with pocket 3 ......................
Table of Contents
99-6531HG
Dash Disassembly
1. Using Metra’s 86-3528 radio
removal tools, pull the factory radio
from the dash. (Figure A)
2. Remove (2) T-25 Torx screws from
the top of the factory radio trim
panel opening, and (2) T-25 Torx
screws from the bottom of the
opening. (Figure B)
3. Pull down slightly on the top center
of the panel, and then unclip and
remove the panel. (Figure C)
4. Remove (4) T-10 Torx screws
securing the factory radio clip
brackets to the panel. (Figure D)
5. In the sub-dash cavity of the
vehicle, grind or cut the (2) silver
rivets from the left and right side.
(Figure E)
6. Cut and remove the shaded portion
of the sub-dash cavity as shown.
(Figure F)
Note: Take caution not to cut
the vent ducts.
Continue to kit assembly.
(Figure A) (Figure D)
(Figure C) (Figure F)
(Figure B) (Figure E)
Remove
shaded
area
99-6531HG
Kit Assembly
(Figure C)
(Figure B) (Figure D)
(Figure A)
ISO DIN radio provision with pocket
1. Secure the to the pocket radio
brackets with (2) #8 x 3/8” screws
supplied. Note: The pins on the
brackets will align with the front
mounting hole of the pocket.
(Figure A)
2. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
3. Slide the radio in the pocket/bracket
assembly, and then secure to the
assembly using screws provided
with the radio, or the (4) 12mm x
5mm Phillips screws included in
this kit. Note: The screws must
be flush in the radio brackets
to slide into the radio mounting
brackets. Most radios will mount
best with the radio brackets
slid to the front edge, and the
radio’s mounting position behind
the arrow on the radio bracket.
(Figure B)
4. Position the radio mounting
brackets into the factory radio trim
panel, and then secure with the (4)
T-25 Torx screws removed during
step four of dash disassembly.
(Figure C)
5. Reassemble the panel back into
the vehicle, in reverse order of
dash disassembly in step 2.
6. Locate the factory wiring harness
and antenna plug in the dash.
Metra recommends using the
proper mating adapters from
Metra and/or AXXESS. Re-connect
the negative battery terminal and
test the radio for proper operation.
7. Slide the completed assembly into
the radio opening between the
radio mounting brackets until it
clips into the opening.
8. Attach the (4) to the panel clips
6531 radio trim panel. (Figure D)
9. Snap the into radio trim panel
the opening around the radio.
Product specificaties
| Merk: | Metra |
| Categorie: | Carkit |
| Model: | 99-6531HG |
Heb je hulp nodig?
Als je hulp nodig hebt met Metra 99-6531HG stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Carkit Metra
17 November 2024
17 November 2024
17 November 2024
17 November 2024
17 November 2024
17 November 2024
23 Augustus 2024
23 Augustus 2024
23 Augustus 2024
23 Augustus 2024
Handleiding Carkit
- Carkit JVC
- Carkit Kenwood
- Carkit Motorola
- Carkit Medion
- Carkit Nokia
- Carkit Pioneer
- Carkit Siemens
- Carkit Alpine
- Carkit Belkin
- Carkit Blaupunkt
- Carkit Boss
- Carkit Brigmton
- Carkit Brodit
- Carkit Bury
- Carkit Dymond
- Carkit Einhell
- Carkit Envivo
- Carkit Gembird
- Carkit Hama
- Carkit HQ
- Carkit HTC
- Carkit Iluv
- Carkit Kensington
- Carkit Kogan
- Carkit Lenco
- Carkit Livoo
- Carkit Manhattan
- Carkit Manta
- Carkit Mr Handsfree
- Carkit MT Logic
- Carkit Nedis
- Carkit Parrot
- Carkit Pyle
- Carkit Renegade
- Carkit Renkforce
- Carkit Silvercrest
- Carkit Sony Ericsson
- Carkit SuperTooth
- Carkit Technaxx
- Carkit Thule
- Carkit TomTom
- Carkit Trust
- Carkit Uniden
- Carkit Veho
- Carkit Jabra
- Carkit Jensen
- Carkit B-Speech
- Carkit BeeWi
- Carkit Caliber
- Carkit Exibel
- Carkit T'nB
- Carkit Hamron
- Carkit Clarion
- Carkit Cobra
- Carkit Arkon
- Carkit Scosche
- Carkit WAGAN
- Carkit Havis
- Carkit I-Tec
- Carkit BlueAnt
- Carkit SBS
- Carkit Cellular Line
- Carkit PAC
- Carkit KRAM
- Carkit NAV-TV
- Carkit Ergotron
- Carkit Konig & Meyer
- Carkit Alpin
- Carkit Novus
- Carkit Foliatec
- Carkit THB
- Carkit Perfect Choice
- Carkit SiriusXM
Nieuwste handleidingen voor Carkit
30 November 2024
17 November 2024
15 November 2024
30 Juli 2024
30 Juli 2024
19 Juni 2024
27 Mei 2024
27 Mei 2024
27 Mei 2024
27 Mei 2024