Maytag W10315283RP Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Maytag W10315283RP (9 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 26 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/9
W10315279C
DOOR REVERSAL KIT
TROUSSE POUR L’INVERSION DE LA PORTE
DRYER SAFETY
TOOLS AND PARTS
Tools and Parts
Gather required tools and parts before starting installation.
Cover strip
Parts included:
#2 Phillips screwdriver
Min. 8" long Torx®† T25
screwdriver
Tools needed:
† ® TORX is a registered trademark of Saturn Fasteners, Inc.
INSTALLATION INSTRUCTIONS
1. Remove door from dryer
Using a Torx®† T25 screwdriver, remove the 4 screws securing
the door hinge to the dryer and lift up and out to remove the
door. Place the door on a soft towel or other non-scratch
surface. Reinstall the 4 screws.
2
2. Move the door strike
Using a Torx®† T25 screwdriver, remove the 2 screws securing
the door strike to the door frame of the dryer. Remove the 4
screws above and below the door strike and set aside for later
use. Rotate the strike 180° and attach to the opposite side of
dryer door frame, as shown.
† ® TORX is a registered trademark of Saturn Fasteners, Inc.
Not used on all models
3. Remove inner door from outer door
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 13 screws (17 screws
on some models) securing the inner door to the outer door.
Lift off the inner door and set aside.
NOTE: There is a small release tab on each side of the door.
If the inner and outer door do not separate easily, slide a
credit card, putty knife, or similar at object between the inner
and outer doors at the locations shown to release the tab.
Not used on all models
4. Remove outer door trim
On some models, you will need to use a Phillips screwdriver
to remove 4 screws attaching the outer door trim to the outer
door liner/window assembly. Lift off trim.
5. Remove door handle screws
Using a Phillips screwdriver, remove the 2 screws attaching
the outer window and door handle to the outer door liner and
remove.
Release tab
Release tab
3
6. Remove cover strip
Using a Phillips screwdriver, remove the 2 screws attaching
the cover strip to the outer door liner and remove.
7. Install cover strip from kit
Using the 2 screws removed earlier, install the new cover strip
(included with kit) on the opposite side.
8. Rotate outer window and reattach
door handle
Rotate the outer window and door handle 180° and lower
outer door liner back onto the outer window, securing the
door handle with the 2 screws removed earlier.
Not used on all models
9. Reattach outer door trim
Place the outer door trim on the outer door assembly. If you
removed 4 screws earlier, use a Phillips screwdriver to secure
trim in place using those screws.


Product specificaties

Merk: Maytag
Categorie: Niet gecategoriseerd
Model: W10315283RP

Heb je hulp nodig?

Als je hulp nodig hebt met Maytag W10315283RP stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Maytag

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd