Marshall 1962 BLUESBREAKER Handleiding
Marshall
Gitaarversterkers
1962 BLUESBREAKER
Lees hieronder de š handleiding in het Nederlandse voor Marshall 1962 BLUESBREAKER (84 pagina's) in de categorie Gitaarversterkers. Deze handleiding was nuttig voor 44 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/84
OWNERāS MANUAL
1959SLP
1987X
2245 JTM45
1962 BLUESBREAKER
WARNING! IMPORTANT SAFETY INSTRUCTIONS
ENGLISH
WARNING:
Before going any further, make sure that
your ampliīer is compaī¦ble with your
mains electricity supply (for 1959SLP
& 1987X only, please refer to MAINS
SELECTOR [Rear Panel Funcī¢¼on #16]).
If you have any doubt, please seek
help from a qualiīed technician ā your
Marshall dealer can help you in this
respect.
MAINS INPUT & FUSE:
The speciīc mains input voltage
raī¦ng that your ampliīer has been
manufactured for is indicated on
the rear panel of the ampliīer. Your
ampliīer is provided with a detachable
mains (power) lead, which should be
connected to the MAINS INPUT socket
on the rear panel of the ampliīer
(1959SLP & 1987X Rear Panel Funcī¢¼on
#17, 1962 Bluesbreaker Rear Panel
Funcī¢¼on #20, 2245 JTM45 Rear Panel
Funcī¢¼on #17). The correct value and
type of mains fuse is speciīed on the
rear panel of the ampliīer.
NEVER aīempt to bypass the fuse or īt
one of the incorrect value or type.
TRANSPORTING YOUR EQUIPMENT:
Please ensure that your ampliīer is
switched oī, unplugged from the mains
electricity supply and that all removable
cables have been disconnected from
your equipment before aīempī¦ng to
move it.
IMPORTANT SET UP INFORMATION:
1. Before connecī¦ng a speaker
cabinet(s), make sure the OUTPUT
SELECTOR (1959SLP & 1987X
Rear Panel Funcī¢¼on #15, 1962
Bluesbreaker Rear Panel Funcī¢¼on
#18, 2245 JTM45 Rear Panel
Funcī¢¼on #15) is set to the correct
impedance.
WARNING: Failure to select the correct
impedance may damage your ampliīer.
When connecī¦ng a speaker cabinet(s)
make sure that you use a proper speaker
cable. Never use a screened (shielded)
guitar cable for this purpose.
2. Ensure that the MAINS (power)
switch is set to the OFF posiī¦on
(Front Panel Funcī¢¼on #1).
3. Connect the supplied mains (power)
lead into the MAINS INPUT īrst
and then into the mains electricity
supply.
4. Ensure that the LOUDNESS or
VOLUME controls on the front
panel are set to zero (1959SLP &
1987X Front Panel Funcī¢¼ons #8 &
9, 1962 Bluesbreaker Front Panel
Funcī¢¼ons #10 & 11, 2245 JTM45
Front Panel Funcī¢¼ons #8 & 9).
5. Plug your guitar into an INPUT
jack socket (Front Panel Funcī¢¼on:
1959SLP, 1987X & 2245 JTM45
Front Panel Funcī¢¼ons #10, 1962
Bluesbreaker Front Panel Funcī¢¼ons
#12).
6. Ensure that the STANDBY switch is
in the āstandbyā posiī¦on (Front Panel
Funcī¢¼on #2).
7. Turn the front panel MAINS switch
to the ON posiī¦on and wait for a
few minutes before going to point 8.
8. Engage the ampliīer by switching
STANDBY to the ON posiī¦on.
9. Turn the LOUDNESS or VOLUME
up to your preferred level and your
ampliīer is ready to play.
PLEASE READ THIS MANUAL CAREFULLY BEFORE
PLUGGING IN.
FOLLOW ALL INSTRUCTIONS AND HEED ALL
WARNINGS.
KEEP THESE INSTRUCTIONS.
ENGLISH
This device complies with part 15 of the FCC Rules. Operaī¦on is subject to the
following two condiī¦ons:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operaī¦on.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protecī¦on against harmful interference in a residenī¦al
installaī¦on.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instrucī¦ons, may cause harmful
interference to radio communicaī¦ons.
However, there is no guarantee that interference will not occur in a parī¦cular
installaī¦on. If this equipment does cause harmful interference to radio or
television recepī¦on, which can be determined by turning the equipment oī and on,
the user is encouraged to try to correct the interference by one or more of the
following measures:
ā¢ Reorient or relocate the receiving antenna.
ā¢ Increase the separaī¦on between the equipment and the receiver.
ā¢ Connect the equipment into an outlet on a circuit diīerent from that to
which the receiver is connected.
ā¢ Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes or modiīcaī¦ons not expressly approved by the party
responsible for compliance may void the users authority to operate the equipment.
This device complies with CAN ICES-3(B)/NMB-3(B)
COMPLIANCE STATEMENT
Product specificaties
| Merk: | Marshall |
| Categorie: | Gitaarversterkers |
| Model: | 1962 BLUESBREAKER |
Heb je hulp nodig?
Als je hulp nodig hebt met Marshall 1962 BLUESBREAKER stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Gitaarversterkers Marshall
16 September 2023
16 September 2023
16 September 2023
16 September 2023
16 September 2023
16 September 2023
16 September 2023
16 September 2023
16 September 2023
16 September 2023
Andere handleidingen Marshall
6 September 2024
19 Februari 2024
22 November 2023
16 September 2023
16 September 2023
16 September 2023
16 September 2023
16 September 2023
16 September 2023
16 September 2023