Lowrance LDT3200 Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor Lowrance LDT3200 (12 pagina's) in de categorie Navigator. Deze handleiding was nuttig voor 44 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/12
1
Pub. 988-0099-071
LDT-3200
Digital Temperature Gauge
Installation & Operation Instructions
The LDT-3200 combines a temperature gauge, voltmeter and clock in one
housing. It displays the temperature in either Fahrenheit °F or Celsius
°C and may be set to rotate between four gauge displays or "pages." The
unit fits in a standard 2-1/8" (54 mm) hole used by most marine equip-
ment manufacturers.
The gauge and its temperature sensor are designed to show surface water
temperature in a transom installation, but the sensor can be installed to
monitor the temperature elsewhere, such as in a live well.
LDT-3200 temperature gauge.
Mounting Preparations
When installed, the gauge will cover an area on the dash 2-3/8" (60.3 mm)
in diameter. To mount the unit, first make sure there is at least 2-3/4"
(70 mm) from the front of the dash to any obstruction behind the dash.
The maximum usable dash thickness is 1-1/8" (28.5 mm). Also, be sure
there is room to route the power and sensor cables. The following figure
shows gauge dimensions.
2
Dash installation, cross-section view.
Caution:
You should read over the entire installation section before drilling
any holes in your vessel!
You can install this gauge in some other order if you prefer, but we rec-
ommend this installation sequence, which is summarized below:
1. Determine the location for the gauge so you can plan how and where to
route the cables. This will help you make sure you have enough cable
length for the desired configuration.
2. Determine the location of your battery or other power connections,
along with the power cable route.
3. Determine the location for the temperature sensor and its cable route.
4. Determine the location for the alarm buzzer and its wire route.
5. If you want to turn on the gauge backlights whenever you turn on your
dashboard lights, locate your boat's dash light switch and determine how
to route the dash light wires to it.
6. Install the temp sensor, connect power wires to the battery and route
the power/sensor cable to the gauge location.
7. Install the gauge, and connect the power/sensor cable.
8. Connect the buzzer wires and install the buzzer. If desired, connect the
dash light wires to the boat's dash light switch.
2-3/4"
(70 mm)
2-3/8"
(60.3 mm)
Gasket
Threaded mounting collar
Dash
Cables
3
Recommended Tools and Supplies
Supplies are not included, unless otherwise indicated. A transom mount
requires one #8 stainless steel screw (3/4" long) and a high quality, ma-
rine-grade above- or below-waterline sealant/adhesive compound. If you
want to make a pilot hole for the screw, use a drill and a 1/8" drill bit. If
you prefer the option of routing the temp sensor cable through the tran-
som (instead of over it), you will also need a 1/2" drill bit.
If the dash does not have a standard 2-1/8" (54 mm) hole, you will need a
drill or saw to make the hole. Carefully measure the dash thickness and
the hole area before cutting or drilling.
A screwdriver is needed for mounting the temp sensor. The buzzer in-
stallation requires two cable ties.
If you need to extend any of the wires, use a minimum of 24 gauge wire
and wire connectors of your choice. Wire nuts or electrical tape are re-
quired to cap any unused bare wires.
Mounting
The temperature sensor can be mounted in any convenient location.
However, make sure it is placed on the transom where it will be in con-
tact with the water at all times. Make sure the location does not interfere
with the boat's trailer.
Temp sensor on transom, with cable routed through the transom.
After determining the location, use the sensor as a template and mark
the hull for the screw's pilot hole, if desired. Route the sensor and cable
over or through the transom to the mounting location. If routing through
the transom, drill a 1/2" hole to accommodate the sensor. Attach the sen-
sor to the hull with one #8 stainless steel screw, then seal the screw with
the below-waterline sealant compound.
Caution:
If you drill a hole in the transom for the cable, make sure it is lo-
cated above the waterline. After installation, be sure to seal the ca-
ble hole with the same marine grade above-or below-waterline
sealant used for the screw.
Product specificaties
| Merk: | Lowrance |
| Categorie: | Navigator |
| Model: | LDT3200 |
Heb je hulp nodig?
Als je hulp nodig hebt met Lowrance LDT3200 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Navigator Lowrance
7 Augustus 2024
7 Augustus 2024
13 Juni 2023
12 Juni 2023
28 Mei 2023
4 Mei 2023
30 April 2023
27 April 2023
23 April 2023
22 April 2023
Handleiding Navigator
- Navigator Philips
- Navigator Sony
- Navigator Asus
- Navigator Garmin
- Navigator Grundig
- Navigator JVC
- Navigator Kenwood
- Navigator Motorola
- Navigator Medion
- Navigator Nokia
- Navigator Pioneer
- Navigator Acer
- Navigator Airis
- Navigator Alfa Romeo
- Navigator Alpine
- Navigator Audi
- Navigator Audiovox
- Navigator Autovision
- Navigator Becker
- Navigator Binatone
- Navigator Blaupunkt
- Navigator BMW
- Navigator Boss
- Navigator Bushnell
- Navigator Danew
- Navigator Dual
- Navigator Dynavin
- Navigator Eagle
- Navigator Eclipse
- Navigator ESX
- Navigator Falk
- Navigator Furuno
- Navigator Goclever
- Navigator Harman Kardon
- Navigator Hitachi
- Navigator Honda
- Navigator Humminbird
- Navigator Igo
- Navigator Insignia
- Navigator Kalkhoff
- Navigator Kapsys
- Navigator Kia
- Navigator Lanzar
- Navigator Lenco
- Navigator Magellan
- Navigator Marquant
- Navigator Maxcom
- Navigator Mazda
- Navigator Midland
- Navigator Mio
- Navigator Nav N Go
- Navigator Navigon
- Navigator Navitel
- Navigator Navman
- Navigator Parrot
- Navigator Polaroid
- Navigator Pyle
- Navigator Raymarine
- Navigator Route 66
- Navigator Sanyo
- Navigator Seecode
- Navigator Silvercrest
- Navigator Simrad
- Navigator Skoda
- Navigator Soundstream
- Navigator Sygic
- Navigator Sylvania
- Navigator Teasi
- Navigator Thomson
- Navigator TomTom
- Navigator Toyota
- Navigator Uniden
- Navigator VDO
- Navigator VDO Dayton
- Navigator Viamichelin
- Navigator Volkswagen
- Navigator Xzent
- Navigator Zebra
- Navigator Zenec
- Navigator Jensen
- Navigator Overmax
- Navigator Caliber
- Navigator Chrysler
- Navigator Clarion
- Navigator Conrad
- Navigator Cobra
- Navigator Celestron
- Navigator Scosche
- Navigator IZZO Golf
- Navigator Rand McNally
- Navigator Lark
- Navigator Whistler
- Navigator CarTrek
- Navigator GlobalSat
- Navigator Wahoo Fitness
- Navigator Coyote Systems
- Navigator GolfBuddy
- Navigator ModeCom
- Navigator Pharos
- Navigator V7
- Navigator Cheetah
- Navigator Cydle
- Navigator LXNAV
- Navigator Planet Audio
- Navigator Voice Caddie
- Navigator SkyCaddie
- Navigator TELE System
- Navigator Zoleo
- Navigator Dashmate
Nieuwste handleidingen voor Navigator
24 November 2024
16 November 2024
16 November 2024
15 November 2024
14 November 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024