Louroe Electronics Verifact K Handleiding

Louroe Electronics Microfoon Verifact K

Lees hieronder de 📖 handleiding in het Nederlandse voor Louroe Electronics Verifact K (4 pagina's) in de categorie Microfoon. Deze handleiding was nuttig voor 3 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

VERIFACT K

MICROPHONE

INSTALLATION AND OPERATING INSTRUCTIONS

Page 1 of 4 K_mic_inst_12/14

6955 VALJEAN AVE, VAN NUYS, CA 91406

PH: (818)994-6498 / FAX: (818)994-6458

/ www.louroe.com

techsupport@louroe.com

® ®

DESCRIPTION

The Verifact Model K is a dynamic line level microphone

with a directional pattern. The modified pattern is one in

which the audio pick up is more from the front of the

microphone and less from the sides and back. It is especially

designed for areas with excessive background noise or

where the ambient sound level is high. The V ®

erifact Model

K is pre-amplified, produces line level output and is

compatible with all Louroe audio base stations and interface

adapters.

When mounting, position the V ®

erifact K so that microphone

element is facing the desired area of coverage. Microphone

functions best when it is mounted close to the area to the

monitored, 3’ - 8’ away. A vibration pad is included and may

the use if the microphone wii be subject to vibration (eg:

transportation vehicles)

SPECIFICATIONS

Frequency Response

Output

Current Drain

100 Hz to 15 kHz

Line Level (0 dB, 600W @1kHz)

10 mA

Supply voltage 12 Vdc

Weight

Shipping Weight

2.5 oz

1 lb

Dimensions 4 3/8”L x 2 “W x 1 3/4”H

Type Dynamic, -58dBV@ 94dB SPL

Polar Pattern Modified Directional

IMPORTANT NOTICE

When this equipment is used as part of an

audio monitoring system, the law requires

that the public be given notice of AUDIO

MONITORING ON THE PREMISES. A

decal notice is included with each

microphone shipped.

Federal Law References:

Federal Regulations, US Code, Title 18.

Crime and Criminal Procedure, Sec 2510.

AUDIO

MONIT ORING

Th ese P remises

LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458

website: www.louroe.com e-mail: sales@louroe.com

(818)

WARRANTY

LOUROE ELECTRONICS warrants that at the time of shipment products manufactured by LOUROE ELECTRONICS to be free of defects in material and workmanship.

Should a defect appear within two year (24 months) from date of shipment, LOUROE ELECTRONICS will, at its sole discretion, repair or replace the defective equipment.

This equipment shall not be accepted for repair or return without prior notification by LOUROE ELECTRONICS .

This warranty does not extend to any Louroe product that has been subjected to improper or incorrect installation, misuse, accident, or in violation of installation

instructions provided by LOUROE ELECTRONICS.

Returned shipments to LOUROE ELECTRONICS shall be at customer’s expense. LOUROE ELECTRONICS will return the equipment prepaid via best way.

CONNECTION TO A LOUROE BASE STATION OR TO IF-1, IF-4, IF-8 INTERFACE ADAPTER

After microphone connection has been made, run cable to the Louroe Base Station or Interface Adapter. All

Louroe Base Stations and Interface Adapters have a corresponding terminal block (A, B, C) for each zone.

Make connections to the terminal block from microphone wire, matching A to A, B to B and C to C. If using

cable from other manufacturers with a different color code, make certain that wire colors are properly matched

between microphone and base station.

CONNECTION TO A LOUROE MICROPHONE MIXER (RN-2 or MLA-6)

Refer to Installation Instructions for the specified mixer.

IF VERIFACT K MICROPHONE IS BEING CONNECTED DIRECTLY TO AN AUDIO RECEIVER

OTHER THAN A LOUROE BASE STATION OR (DVR, IP NETWORK

CAMERA, ETC), CONNECT AS FOLLOWS (See interconnection diagram on the last page)

1. Apply 12Vdc power to terminals A and C.

(A is positive, C is negative)

2. Connect Terminal B (audio out) and Terminal C of Verifact K Microphone to the recorder or audio receiving

device using single conductor cable, 22 gauge with a drain wire. See interconnection diagramshielded

using different types of plugs on last page. The black wire is used instead of the drain wire (bare) for color

coding purposes only.

INTERFACE ADAPTER

MICROPHONE CONNECTION

On the bottom of the Verifact K housing is a 3- pin terminal block

marked A, B, C:

A = 12Vdc (positive) Red Wire

B = Audio Out Black Wire

C = Ground (negative) Bare Wire

Using recommended wiring:

1 - Connect RED wire to terminal A

2 - Connect BLACK wire to terminal B

3 - Connect Bare wire to terminal C

INSTALLATION AND OPERATING INSTRUCTIONS

Page 2 of 4

LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458

website: www.louroe.com e-mail: sales@louroe.com

(818)

USING THE VIBRATION PAD

Remove sensitivity switch cover from the vibration pad. Peel off the paper from the adhesive back of the pad.

Before sticking the pad to the back to the Verifact K. make sure it is position so that the Sensitivity switch

opening lines up with the switch cutout on the pad. See the picture below for proper mounting of pad.

VERIFACT K

WITH

VIBRATION PAD

SENSITIVITY SWITCH OPENING

K_mic_inst_12/14

VERIFACT K MICROPHONE CONNECTION

TO A LOUROE™ BASE STATION

IF-1, IF-4, IF-8 AUDIO INTERFACE ADAPTER

SENSITIVITY SWITCH

N = Normal

L = Low

Position L lowers the gain by 11dB

and is used when there is excessive

background noise, or if less audio

output is desired.

To Receiving Device

(Base Station, Interface Adapter or Mixer)

INSTALLATION AND OPERATING INSTRUCTIONS

Page 3 of 4

LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458

website: www.louroe.com e-mail: sales@louroe.com

(818)

A B C

L N

VERIFACT K

BARE

BAREBARE

BLACK

BLACKBLACK

RED

REDRED

AA B

BB C

BLACK

BLACKBLACK BARE

BARE

BAREBARE

RED

REDRED

2 Conductor cable, 22 shielded

gauge with a 24 gauge drain wire

NOTE: Unshielded cable is not

satisfactory for audio systems

WIRING REQUIREMENTS

West Penn 452 or equivalent

SENSITIVITY SWITCH CUTOUT

K_mic_inst_12/14

Product specificaties

Merk:	Louroe Electronics
Categorie:	Microfoon
Model:	Verifact K
Kleur van het product:	Wit
Breedte:	2 "
Hoogte:	1.75 "
Soort:	Microfoon voor beveiligingscamera's
Connectiviteitstechnologie:	Bedraad
Land van herkomst:	Verenigde Staten
Stroomverbruik:	10 mA
Gevoeligheid microfoon:	-58 dB
Operating voltage:	12 V
Spreekspoel types:	Dynamisch
Frequentie microfoon:	100 - 15000 Hz
Diepte (imperiaal):	4.375 "
Aantal producten inbegrepen:	1 stuk(s)
Gewicht microfoon:	70.9 g