Louroe Electronics LE-084 Handleiding

Louroe Electronics Speaker LE-084

Lees hieronder de 📖 handleiding in het Nederlandse voor Louroe Electronics LE-084 (4 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 2 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

DESCRIPTION

SPEAKER CONNECTION OF TLO

MICROPHONE CONNECTION OF TLO

The TLO is a two-way speaker with microphone and re-entry horn for high volume

penetration. Weatherized for outdoor use, it is a microphone and speaker within one

housing. In operation, the TLO provides both listen and talkback capabilities

between the remote zone and Louroe base station, or with other compatible audio

receiving devices such as Louroe AOP-SP70.

MODEL TLO

Speaker connection is located near the rear of the TLO and has a plexiglass window. Remove window and connect the

speaker portion of West Penn 356 (green and white wires) to the two terminal screws marked 1 and 2.

Green speaker wire goes to position 2 (positive)

White speaker wire goes to position 1 (negative)

The short cable extending from the back of the TLO is the microphone connection and consists of three wires: red, black

and bare. Using recommended wiring (West Penn 356 or equivalent), make microphone connections using 20 gauge

wire nuts, and matching wire with , with and wire with wire. See diagram page 2. black black

red red bare

bare

bare bare

bare

see diagram below

POWER TAP SETTINGS

Located above the speaker connection is a set screw with a dial numbered 1 through 7. Using a small screw

driver, adjust the set screw to correspond to the proper power tap setting with the following Louroe audio base

stations.

IF TLO IS CONNECTED TO BASE STATION MODELS:

AP-1TB through AP-16TB #1 1.8W

DG 12 and DG 25 1 TLO per zone #4 15.0WII III

2-4 TLO’s per zone using MLA-6 Mixer #2 3.7W

If TLO is to be connected to Louroe AOP-SP70 conversion unit #2 3.7W

for interfacing with a DVR or PC Soundcard, use setting

Setting Wattage

3 5

Speaker connection

(WHITE-negative)

Speaker connection

(GREEN-positive)

1 through 7

power tap settings

set screw

WIRING REQUIREMENTS

4 Conductor consisting of:

+2 Conductor , shielded

20 gauge with 22 gauge drain

(microphone connection)

+2 Conductor

unshielded, 18 gauge (speaker

connection)

West Penn 356 or equivalent

TLO

OUTDOOR SPEAKER/MICROPHONE

INSTALLATION AND OPERATING INSTRUCTIONS

Page 1 of 4 tlo inst 3/15

6955 VALJEAN AVE, VAN NUYS, CA 91406

PH: (818)994-6498 / FAX: (818)994-6458

/ www.louroe.com

techsupport@louroe.com

CONNECTING TLO TO A LOUROE BASE STATION

POSITIONING TLO

Model TLO is compatible with all Louroe™ audio base stations that feature two-way talk/listen communication. All

Louroe™ base stations contain terminal blocks for receiving both microphone and speaker connections from Model

TLO. For wiring and installation instructions, please refer to the specific Louroe™ Base Station being used.

After TLO has been mounted to desired structure (wall, pole, etc.), horn should be tilted in a downward position.

This will protect the microphone element from water damage.

3 5

Speaker terminal screws

green wire to #2 (positive +)

white wire to #1 (ground -)

to Louroe base station

Refer to the specific base station instructions for connections

(A) RED

(B) BLACK

MICROPHONE

CONNECTION

Connects to

Terminals A, B, C

of Louroe Base

Station

{Green = speaker (positive)

connects to terminal “SP” of base station

White = speaker (negative)

connects to terminal “G” of base station

MICROPHONE

CABLE

MICROPHONE

HOUSING

WHITE

(GROUND)

Microphone connection

using three wire nuts

Red = 12Vdc

Black = Audio Output

Bare = Ground

RED

SPEAKER

BLACK

BARE

GROUND (-) POSITIVE (+)

GREEN

(POSITIVE)

Page 2 of 4

LOUROE ELECTRONICS™ 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458

website: www.louroe.com e-mail: sales@louroe.com

(818)

INSTALLATION AND OPERATING INSTRUCTIONS

tlo inst 3/15

EXT

SPKR SPKR

SPKR

EXT

A B C CBA SP Vdc+12

GND

INTERCONNECTION DIAGRAM

LOUROE MODEL AOP-SP70 SPEAKERPHONE CONVERSION UNIT,

AND LOUROE MODEL TLO SPEAKER/MICROPHONE

CONNECTION TO

DVR, IP NETWORK CAMERAS OR VIDEO SERVER

(BI-DIRECTIONAL AUDIO)

For connection to DVR, IP Network Camera, etc., solder the appropriate plug (RCA, 3.5mm

mono or 3.5mm stereo) to match the audio inputs of the receiving device as shown below.

Refer to IP Camera’s instruction to determine if 3.5mm audio is mono or stereo

Model TLO is Designed For Outdoor

or Moist Applications

WHITE (SP)

BLACK (C)

(B) RED

TO AUDIO OUT OF DVR, ETC.

TO AUDIO IN OF DVR, ETC.

West Penn 358

or equivalent

BARE (C)

BLACK (B)

RED (A)

WHITE

WIRE NUTS

GREEN

4 Conductor shielded cable

2 shielded 20 gauge and

2 unshielded 18 gauge,

20 gauge drain wire

West Penn 356 or equivalent

WIRING REQUIREMENTS FOR TLO

MICROPHONE

CABLE

Microphone connection

using three wire nuts

Red = 12Vdc

Black = Audio Output

Bare = Ground

RED BLACK

BARE

WHITE SPEAKER

(GROUND)

GREEN SPEAKER

(POSITIVE)

Audio Out

Audio Out Audio In

Audio In

Bare Wire

Red Wire

RCA CONNECTION

3.5mm MONO CONNECTION 3.5mm STEREO CONNECTION

White Wire

Black Wire

White Wire

Red Wire

Bare Wire

Audio Out

Audio In

Red Wire

Black Wire

White WireBare Wire

SPB

INSTALLATION AND OPERATING INSTRUCTIONS

LOUROE ELECTRONICS® 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458

website: www.louroe.com e-mail: sales@louroe.com

(818)

Using power supply (included), connect as

follows:

Positive 12Vdc connects to terminal marked

“+”

Negative 12Vdc or ground connects to

terminal marked “GND”(wire with white

stripes)

LOUROE MODEL AOP-SP70

tlo inst 3/15

Product specificaties

Merk:	Louroe Electronics
Categorie:	Speaker
Model:	LE-084
Kleur van het product:	Grijs
Gewicht:	2494 g
Breedte:	279.4 mm
Diepte:	323.8 mm
Hoogte:	168.2 mm
Gemiddeld vermogen:	30 W
Aantal per verpakking:	1 stuk(s)
Geschikt voor buitengebruik:	Ja
Speaker plaatsing:	Inbouw in de muur/plafond
Frequentiebereik:	350 - 14000 Hz
AC-ingangsspanning:	70.7 V