Louroe Electronics AOP-SP70 Handleiding

Louroe Electronics Audio/video-converter AOP-SP70

Lees hieronder de 📖 handleiding in het Nederlandse voor Louroe Electronics AOP-SP70 (8 pagina's) in de categorie Audio/video-converter. Deze handleiding was nuttig voor 2 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/8

Page 1 of 8 aopsp70_ inst_3/15

DESCRIPTION

MODEL AOP-SP70 AUDIO CONVERSION UNIT

Model AOP-SP70 is usually paired with the TLO to convert the signals of Model

TLO for compatibility with the receiving device for providing two-way audio. The

AOP-SP70 drives the audio signals into the audio input and output of the IP

Camera, etc, for transmission over the network and to an existing computer (or

other devices) at the receiving site. Person at the receiving site hears the audio

through the computer speaker or through a headphone. For talkback to the

remote site (TLO location), the computer’s microphone is used to transmit audio

back through the network to the AOP-SP70. It is then amplified and sent out to

the speaker portion of the remote TLO. The AOP-SP70 provides power to the

TLO and contains adjustments for microphone gain and speaker volume. A 12Vdc

power supply is included with the AOP-SP70.

MODEL TLO OUTDOOR SPEAKER/MICROPHONE

Model TLO is a two-way speaker and microphone and re-entry horn for high

volume penetration. Weatherized for outdoor applications, the microphone and

speaker horn are all within one housing. In operation, the TLO together with the

AOP-SP70 provides hands-free bi-directional audio communication with the audio

receiving device (DVR, IP Camera, etc.).

MODEL AOP-SP70

Speakerphone Conversion Unit MODEL TLO

Outdoor Speaker/Microphone

WIRING REQUIREMENTS

3 Conductor consisting of:

2 Conductor , 20 gauge shielded

with 22 gauge drain

1 Conductor , 20 gauge unshielded

All in the same jacket

West Penn 358 or equivalent

WIRING REQUIREMENTS

4 Conductor consisting of:

2 Conductor , 20 gauge shielded

with 22 gauge drain (microphone

connection)

2 Conductor , 18 gauge unshielded

(speaker connection)

All in the same jacket

West Penn 356 or equivalent

FOR AOP-SP70

FOR TLO

AOP-SP70

SPEAKERPHONE CONVERTER

INSTALLATION AND OPERATING INSTRUCTIONS

6955 VALJEAN AVE, VAN NUYS, CA 91406

PH: (818)994-6498 / FAX: (818)994-6458

/ www.louroe.com

techsupport@louroe.com

LOUROE ELECTRONICS® 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458

website: www.louroe.com e-mail: sales@louroe.com

(818)

WIRING REQUIREMENTS

4 Conductor consisting of:

2 Conductor , 20 gauge shielded

with 22 gauge drain (microphone

connection)

2 Conductor , 18 gauge unshielded

(speaker connection)

All in the same jacket

West Penn 356 or equivalent

SPEAKER CONNECTION OF TLO

MICROPHONE CONNECTION OF TLO

Speaker connection is located near the rear of the TLO and has a plexiglass window. Remove window and

connect the speaker portion of West Penn 356 ( and wires) to the two terminal screws marked 1 green white

and 2.

Green speaker wire goes to position 1 (positive)

White speaker wire goes to position 2 (negative)

The short cable extending from the back of the TLO is the microphone connection and consists of three wires:

red, black bare and . Using recommended wiring (West Penn 356 or equivalent), make microphone

connections using 20 gauge wire nuts and matching wire with , with and wire with red red black black bare

bare wire. See diagram next page.

see diagram below

Color code may vary if using wiring from other manufacturers

POWER TAP SETTINGS OF TLO

Located above the speaker connection of TLO is a set screw with a dial numbered 1 through 7. Using a small

screw driver, adjust the set screw to correspond to the proper power tap as shown below.

I Louroe Model TLO connected to Louroe AOP-SP70

conversion unit for interfacing with a DVR or IP Network Camera, use: #2 3.8W

Setting Wattage

3 5

Speaker connection

(WHITE-negative)

Speaker connection

(GREEN-positive)

1 through 7

power tap settings

set screw

WIRING CONNECTIONS TO MODEL TLO

COLOR CODE FOR RECOMMENDED CABLE

Red - 12Vdc Power

Black - Audio Output

Bare - Ground

Green - Speaker Positive

White - Speaker Ground

}

Microphone Portion

Speaker Portion

INSTALLATION AND OPERATING INSTRUCTIONS

Page 2 of 8

LOUROE ELECTRONICS® 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458

website: www.louroe.com e-mail: sales@louroe.com

(818)

aopsp70_ inst_3/15

WIRING DIAGRAM OF MODEL TLO OUTDOOR SPEAKER/MICROPHONE

POSITIONING TLO

After TLO has been mounted to desired structure (wall, pole, etc.), horn should be tilted in a downward position.

This will protect the microphone element from water damage.

See page 5

for connection diagram

3 5

RED

(12Vdc)

BLACK

(audio output)

BARE

(ground) MOUNTING

ARM

WEST PENN 356

MICROPHONE

CONNECTION {

Microphone connection

using three wire nuts

Red wire to red = 12Vdc

Black wire to black = Audio Output

Bare wire to bare = Ground

(A) RED

(B) BLACK

Louroe AOP-SP70

Audio Conversion Unit

Green = speaker (positive)

White = speaker (negative)

Speaker terminal screws

green wire to #1 (positive)

white wire to #2 (ground)

Speaker Connections

green - positive

white - ground

MICROPHONE

CABLE

MICROPHONE PC BOARD

AND HOUSING

INSTALLATION AND OPERATING INSTRUCTIONS

Page 3 of 8

LOUROE ELECTRONICS® 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458

website: www.louroe.com e-mail: sales@louroe.com

(818)

aopsp70_ inst_3/15

Product specificaties

Merk:	Louroe Electronics
Categorie:	Audio/video-converter
Model:	AOP-SP70
Kleur van het product:	Roestvrijstaal
Gewicht:	1601 g
Breedte:	187.3 mm
Diepte:	212.7 mm
Hoogte:	69.85 mm
Gewicht verpakking:	2721.5 g
Aantal:	1
Stroomverbruik:	500 mA
Operating voltage:	12 V