Lorus RW633AX9 Sports Handleiding

Lorus Horloges RW633AX9 Sports

Lees hieronder de 📖 handleiding in het Nederlandse voor Lorus RW633AX9 Sports (2 pagina's) in de categorie Horloges. Deze handleiding was nuttig voor 58 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
S3
C H A R A C T E R I S T I C S
1. Analog u e & digit a l t i me displays: Hour,
Minute, Second, Month, Date and Day of the
week.
2. Daily alarm and hourly chime: The alar m
can be set to sound at the designated time
on a 24-hour basis and the chime can be set
to sound every hour on the hour with a single
beep.
3. S t o p wat ch : T he st o pwa t c h c a n me asure
up to 23 hour s 59 minutes and 59 seconds
i n 1 / 1 0 0 - s e c o n d i n c r e m e n t s . S p l i t t i m e
measurement is available.
4. Selection of 12 or 24-hour for mat: The time
display format in either 12-hour indication or
24-hour indication can be selected.
5. EL backlight: The built-in electro-luminescent
(EL) backlight illuminates the display for easy
viewing in darkness.
D I S P L AY A N D B U T T O N F U N C T I O N
H O W T O S E T T I M E / C A L E N D AR
H O W T O S ET A L A R M T I M E
H O W T O C H A N G E T H E D I S P L AY
MO D E
S E T T I N G T H E T I ME ( A N A L O G U E)
1. Pull the crown out one step, the second hand
will stop.
2. Set the correct time by turning the crown.
3. Push the crown back to the original position.
The watch will start running again.
* The analogue indication and digital display of
the time setting can be adjusted separately.
STOPWATCH mode
1. From NORMAL T IME mode,
press S3 butt on
twice to enter the ALARM mode.
2. Press S2 button to begin setting procedure.
The hours digit starts flashing.
3. Press S1 button to set HOURS setting.
4. Press S2 button to move on to MINUTES setting.
Press S1 button to set MINUTES setting.
5. Press S2 button to confirm the settings.
6. Pre ss S3 b ut t on t o ret urn t o NORM AL T IME
mode.
*
Press S3 but ton to show the
NORMAL TIME
mode.
* If the mode is shown already on NORMAL TIME
the display, skip the above operation.
* in Press S3 button to change the display mode
the following order.
NREZ021 3-2013
CAL. Z021 (RW6 SERIES)
1.
From NORMAL T IME mode, p
ress S3 button
three times to begin setting procedure.
The second digits start flashing.
2. Press S1 button to reset the second digits to
zero.
* If S1 button is pressed when the second digits
are in a range between 30 and 59, the second
digits will be reset to 00 and one minute will be
added. If S1 button is pressed when the second
digits are in a range between 00 and 29, the
second digits will be reset to 00 and the minute
digits will be unchanged.
3. Press S2 button to move on to HOURS setting.
* Selection of the digits to be adjusted is made in
the following order by pressing S2 button. Press
S1 button to adjust the value.
* When setting HOURS,H stands for 24-hour
format, A or P stands for 12-hour format.
4. Press S3 button after completing the setting.
C RO W N
NORMAL TIME mode
S3
ALARM mode
S3
S3
S2
HOURS SETTING BY
PRESSING S1
MINUTES SETTING BY
PRESSING S1
S2
NORMAL TIME
MINUTES SETTING BY
PRESSING S1
HOURS SETTING BY
PRESSING S1
SECONDS SETTING
BY PRESSING S1
PRESS
S3
3 t im es
S2
S2
MONTH SETTING BY
PRESSING S1
DATE SETTING BY
PRESSING S1
S3
SECONDS
DATE
DAY OF
THE WEEK MONTH
MINUTESHOURS
S2
S2
S2
S2
S2
12/24H-
FORMAT
S2
TIME SETTING mode
ALARM modeNORMAL TIME mode
S2
DAY OF WEEK SETTING
BY PRESSING S1
S2
S3
S4 (L IGHT )
HO U R S
DAY O F W E E K
CHIM E
DAT E
M IN UT ES S EC O ND S
A L AR M
S3 (M O D E ) S2 (R ES E T )
M O NT H
S 1(S T A RT / ST O P )
S2
S2
PRESS
S3
t w ic e
S2
f o r c onf ir ma t ion
Engagement/Disengagement of ALARM &
CHIME
* In the ALARM setting mode, with each press
of S1 button, the ALARM and CHIME can be
engaged or disengaged in the following order.
The ALARM signal and/or CHIME signal appear
or disappear on the display accordingly.
S1
S1
S3
NORMAL TIME
S1
ALARM ON
CHIME ONALARM/CHIME ON
S1
ALARM MODE
How to stop the alarm sound
Press S3 t o t ur n the snooze funct ion on or off
alternately. When the snooze function is enabled,
the alar m will stop sounding temporarily and
go off again 5 minutes later for 20 seconds and
automatically stop.
Press S1 or S2 to stop the alarm while it is sounding.
Snooze function
PRESS
S3
t w ic e
T h i s w a t c h c o n t a i n s p r e c i s e e l e c t r o n i c
components. Never attempt to open the case or
remove the back cover.
• BATTERY
CAUTION
Do not expose the old battery to re
or recharge it. Keep it at a place
beyond the reach of chil dren. If a
child swallows it, consult a doctor
immediately.
• WATERRESISTANT
Con d i t i o n
of u s e Acci d e n t a l
con t a c t
wi t h w a t e r,
s u c h a s
s p l a s h es
a n d r a i n
Swim m i n g
a n d t a ki n g
a s h o we r
Skin
d i v i n g
Sc u ba
d i v i n g
Indication
on the dial/
case back
No
I nd ic a t io n
* If your watch is 200 M/20 BAR, 100 M/10 BAR or
50 M/5 BAR water resistant, it is so indicated on
the dial/case back.
• Donotoperate the buttons when the watch is
wet.
Ifthe watchisexposedto saltwater,rinse itin
fresh water and then wipe it thoroughly dry.
• Should you find any water or condensation
inside the watch, immediately have it checked.
Water can corrode electr ic parts inside the
case.
NO NO NO
YE S YE S NO NO
YE S YE S NO
NO NO NO
YE S
WA T E R
R E SI ST A N T
WA T E R
R E SI ST A N T
( 5 0 M / 5  B A R
)
WA T E R
R E SI ST A N T
1 0 0M / 10  BA R 
or abo ve
(
NO
Caution:
Leath er straps are not water resistant except
so indicated, even if the watch head is water
resistant.
• ALLERGICREACTION
Be cause t he c ase a n d b a nd t o uch t h e s k i n
directly, it is important to clean them regularly. If
not, shirt sleeves may be stained and those with
delicate skin may develop a rash. Please wear
the watch with some play to avoid any possible
allergic reaction. If you develop a rash on your
wrist, stop wearing and consult a physician.
• MAGNETISM
Your watch will be adversely affected by strong
magnetism. Keep it away from close contact with
magnetic objects.
• SHOCKSANDVIBRATIONS
Yo u r wa t ch m a y b e w o r n fo r n o r m a l s po r t s
activities, but be careful not to drop it or hit it on
hard surfaces.
• TEMPERATURE
Your wa t c h is p re adj u s t e d so t h a t co nst ant
accuracy may be insured at normal tem pera ture.
• CLEANING
U s e o n l y a s o f t c l o t h a n d c l e a n w a t e r fo r
cleaning your watch. Never use chemicals, as the
waterproof gasket will corrode.
P r i n t e d i n C h i n a
YE S
C A R E O F Y O U R L O R U S WA T C H
S E R V I C E
W he n y o u r L OR U S wa t c h re q u i r e s r e p a i r o r
ser vicing, please see the enclosed WARRANTY/
GUARANTEE.
* From NORMAL T IME mode , Pre ss S3 but ton
once to enter the STOPWATCH mode.
H O W T O U S E S T O P W AT C H
Standard Measurement
S1
Start Stop Reset
S1 S2
1. Press S1 button alternately to star t and stop
the STOPWATCH.
2. Press S2 but t on to reset the STOPWATCH t o
"00:00:00."
START/STOP
RESET/SPLIT
S2
S1
STOPWATCH
MODE
H O W T O U S E EL B A C K L I G H T
Note:
1. T he b a c k l i g h t o f t h e w a t ch e m p l o y s a n
electro-luminescent (EL) light, which tends to
lose illuminating power after very long use.
2. The illumination provided by backlight may be
hard to see when viewed under direct sunlight.
* When t he illuminat ing lig ht be comes dim,
replace the battery with new one.
* Pr e s s S 4 b u t t o n i n a ny m o d e t o t u r n t he
illuminating light on.
S4
LIGHT ON
Split Time Measurement
1. Press S1 to start counting first split time.
2. Press S2 button, the STOPWATCH keeps
counting first split time and showing it on the
display.
3. Press S1 button to stop counting first time.split
4. Press S2 button to release first time.split
5. Press S1 button to start counting second split
time. The STOPWATCH shows second time.split
* This operation can be repeated and the split
time can be read.
6. Press S2 to finish counting the time.split
7. Press S2 again to reset the STOPWATCH to
"00:00:00."
Start Split 1 ResetSplit 2 Stop
S1 S2 S2 S2S1
* Press S3 button return to NORMAL TIME display.
This watch is powered by two batteries, one for
the analogue movement and the other for the
digital movement.
An a lo g ue q u a r t z m o v e m e n t : T h e m in i at u r e
battery SEIKO SR626SW, Maxell SR626SW or SONY
SR626SW.
D i g i t a l q u a r t z m o v e m e n t : T h e m i n i a t u r e
batter y SEIKO CR2025, Maxell CR2025 or SONY
CR2025 w hich powers your watch should last
approximately 2 years each.  However, because
it is inserted at the factory, the actual life of the
battery once in your possession may be less than
2 years.
Be sure to replace the batteries to prevent any
possible malfunction as soon as they run down.
To replace the batteries, we recommend taking
the watch to a local watch repair shop.
Note: I f t he a l a r m i s us e d f o r m o r e t h a n 6 0
seconds a day, the battery life may be less
than the specified period.
After the batteries are replaced with new
ones, set the time, calendar and alarm.
B AT T E RY C H A N G E
(


Product specificaties

Merk: Lorus
Categorie: Horloges
Model: RW633AX9 Sports

Heb je hulp nodig?

Als je hulp nodig hebt met Lorus RW633AX9 Sports stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Horloges Lorus

Handleiding Horloges

Nieuwste handleidingen voor Horloges