Lindy NC-60 Handleiding

Lindy Headset NC-60

Lees hieronder de 📖 handleiding in het Nederlandse voor Lindy NC-60 (12 pagina's) in de categorie Headset. Deze handleiding was nuttig voor 33 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/12

NC-60

ACTIVE NOISE CANCELLING

These headphones have been developed to deliver superb quality Hi-Fi sound without the distraction of annoying

background noise. NC-60 beneﬁts from both a Lindy two year warranty and free lifetime technical support. To

ensure correct use, please read this manual carefully and retain for future use.

Thank you for purchasing these NC-60 Noise Cancelling Headphones.

Product Contents

NC-60 Headphones 3.5mm audio cable, 1.5m 1/4’’ stereo-plug adapter

Dual-plug ﬂight adapter 2 x AAA Batteries Carry case with mesh pouch

40mm high output

drivers with

neodymium magnets

Battery compartment,

remove to install

2 x AAA batteries

Volume control

Selectable active noise

cancellation removes up

to 85% of external noise

Lightweight design

for optimum comfort

Features and Beneﬁts

Introduction

The NC-60 has been designed to be used for active noise cancelling and so audio performance has been optimised

for this mode. For your convenience, when the batteries become ﬂat or are removed, the headphones will continue to

operate in passive mode.

Operation

1. Adjust the volume of the NC-60 using the Volume Control (3)

2. Switch on the Noise Cancelling feature by sliding the On/Off Switch (4) to On; the Noise Cancelling Indicator (5) will

illuminate Blue

3. After you turn the Noise Cancelling feature on you may hear a slight hissing noise, this is completely normal and will

reduce after a few seconds and become inaudible during audio playback

4. When using the Noise Cancelling feature, if the battery level becomes low the Noise Cancelling Indicator will become

dim. If you continue to use the Noise Cancelling feature the battery will eventually drain, but the headphones will

continue to operate passively

Noise Cancelling

Battery Installation

1. Push the battery cover cap inward and downward in a single motion to remove the cap

2. Install 2 x AAA batteries (alkaline are recommended) into the battery compartment taking care to match the indicated

battery polarity.

3. Replace the cap, ensuring it is in the correct orientation and that the small plastic lugs on the back are aligned with the

corresponding holes in the earpiece

4. Finally slide the cap upward until it clicks into position

Overview

Left

1. 3.5mm Audio Socket

2. Removable Battery Compartment

Right

3. Volume Control

4. Noise Cancelling On/Off Switch

5. Noise Cancelling Indicator

Left Right

Check the volume level before placing the headphones over your ears

Do not listen to the headphones at high volume for excessive periods as this may damage your hearing

Discontinue use if you experience any discomfort or irritation from using the headphones

These headphones must not be worn whilst driving a motor vehicle

Safety

Product specificaties

Merk:	Lindy
Categorie:	Headset
Model:	NC-60
Soort bediening:	Buttons, Lever, Rotary
Kleur van het product:	Zwart
Gewicht:	203 g
Breedte:	196 mm
Diepte:	160 mm
Hoogte:	45 mm
Snoerlengte:	1.5 m
Connectiviteitstechnologie:	Bedraad
Volumeregeling:	Draaiknop
Plug and play:	Ja
Ruisonderdrukking:	Ja
Opbergetui:	Ja
Aantal:	1
Draagwijze:	Hoofdband
Aanbevolen gebruik:	Muziek
Headset type:	Stereofonisch
Impedantie:	32 Ohm
Positie speakers koptelefoon:	Circumaural
Frequentiebereik koptelefoon:	20 - 20000 Hz
3,5mm-connector:	Ja
Microfoontype:	Niet beschikbaar
Gevoeligheid koptelefoon:	93 dB
Inklapbaar:	Ja
Bedieningstoetsen:	Play/pause, Track <, Track >
Diameter van de luidspreker:	40 mm
Soort magneet:	Neodymium
Afneembare kabel:	Ja
Type regeleenheid:	Lijnbesturingseenheid
Totale harmonische vervorming (THD):	0.5 procent
Type product:	Headset
Ruisonderdrukking microfoon:	Ja
Handleidingtalen:	Engels