LG GSA-H50L Handleiding


Lees hieronder de đź“– handleiding in het Nederlandse voor LG GSA-H50L (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 14 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
Before installing the drive, turn off
the system power.
Disconnect the power cord,
and remove the cover.
• Remove a vacant 5.25” drive bay panel from
the computer. Slide the drive into the drive
bay.
Set the jumper on the rear of
the drive as necessary.
A. When using a Primary IDE port
If you need to connect your drive to the same
primary IDE channel as the hard drive, the drive
should be set to SLAVE position.
B. When using a Secondary IDE port
❶ If there is no device connected to the
secondary IDE channel, connect the
drive to this channel and set the jumper
to MASTER.
âť· When two drives are connected, set one
drive to MASTER and the other drive to
SLAVE. If your operating system encounters
interface problems after installing the new
drive, try swapping the jumpers or move
one drive to another IDE channel.
Installing the Drive
Method A
Method B
D
IGIT AL AN
AL OG
INTE
RFACE OWER
DRCSM
SLA
GL
G39
1
+
+12
GN D
4
0
2
A
UD IO A
UD IO
Super Multi DVD Rewriter
Super Multi DVD Rewriter
DIGIT AL ANAL OG
INTERFACE POW ER
DRCSM
SLA
GL
G39 +5 +
12
GN D
40
AUD IO A
UD IO
Super Multi DVD Rewriter
DT AL AN ALOG
INTERFACE POW ER
DRCS M
SL A
G
L
G39
1
+5 +12GND
4
0
2
AD IO A
U
DIO
DIGITA LAN
ALOG
INTERFACE PO WER
DRCSM
SLA
GL
G39
1
5+12
GN D
4
0
2
AUDIO A U
DIO
First Drive
Second Recorder
Super Multi DVD Rewriter
Super Multi DVD Rewriter
Connect the IDE data
cable/DC power cable
to the drive.
❶ Connect the IDE data cable to the back of
the drive.
* Using a 40-pin IDE cable might bring the '04/08/03
error (LOGICAL UNIT COMMUNICATION CRC
ERROR (ULTRA-DMA/32))'.
In this case, substitute to 80-pin type IDE cable is
highly recommended.
This kind of error is hardly detected from some
specific motherboard.
âť· Connect a 4-pin power supply cable from
the computer to the drive.
Replace the cover,
connect the power cord
and restart your computer.
• Your computer configuration may different
from the illustrations.
❶ IDE Cable
Reserved âť·DC Power
Cable
Features
• Enhanced-IDE (ATAPI) interface.
• Power tray loading and ejection of disc.
(The disc can also be ejected manually.)
• Combination CD-R/RW, DVD-R/RW, DVD-R DL, DVD+R/RW,
DVD+R DL, DVD-RAM functions into one drive.
• Supports Region playback control Phase II.
• Automatic buffer underrun error prevention technology.
• Supports LightScribe Direct Label Printing Technology -
*Optional.
* You can use a variety of Drive
Package Items
System Environment
Computer
This unit can be operated in the system environment explained here.
* Compatibility problem in write/read function may occur with media depending on the media
manufacturing quality.
*
For DVD±R 18x support media: Mitsubishi Kagaku Media, That’s, Maxell (MID: MAXELL 003, MXL
RG04) are recommended.
* Upon the media condition or some of user’s enviroment the maximum speed sometimes could not
be guarantee.
Specifications
CPU: Pentium III 1.0GHz (Recommanded system
requirements for optimal performance, CPU: Pentium IV
2.4GHz or faster, Memory: 512MB or greater)
128MB or greater.
20GB or more free space. (The free space needed for
writing depends on the quantity of data.)
Enhanced-IDE interface (as Primary Slave, Secondary
Master or Slave)
5.25-inch half-height bay required
+5V/+12V power socket required
Windows ME (Not supported in LightScribe).
Windows 2000 Professional/XP(Home Edition/Professional),
Direct X 9.0 or Higher is required.
CD-R : LG, Mitsubishi Kagaku Media, Verbatim, That’s,
TDK, Ritek or HP discs are recommended.
CD-RW : LG, Mitsubishi Kagaku Media, Verbatim are
recommended.
DVD-R : Mitsubishi Kagaku Media, Maxell, That’s are
recommended.
DVD-RW : Victor. JVC, Mitsubishi Kagaku Media, TDK are
recommended.
DVD+R : Mitsubishi Kagaku Media, That’s, Maxell are
recommended.
DVD+RW : TDK, Mitsubishi Kagaku Media, Ricoh are
recommended.
DVD±R DL :
Mitsubishi Kagaku Media, Verbatim are recommended.
DVD-RAM :
Maxell, Mitsubishi Kagaku Media are recommended.
System
requirements
VGA Card Memory
Hard disk
Interface
Drive bay
Power
Software Required
OS
CD-R, CD-RW,
DVD-R, DVD-RW,
DVD+R, DVD+RW,
DVD±R DL,
DVD-RAM media
❋ The drive’s appearance and specifications may change without
prior notice.
Software
Install the supplied CD/DVD Recording Authoring Software before using this unit.
* Please uninstall any previous CD burning software you may have loaded on your PC
in order to prevent possible compatibility issues.
Once you have installed the supplied software, you may (if you wish) begin to reinstall
previous software, taking note for errors.
Please visit www.lgservice.com and install the program,
“LG ODD Online F/W update.” By using the program,
you can automatically check the latest information about FirmWares and
update the FirmWare.
Worldwide support ; http://www.LGservice.com
Worldwide corporate site : http://www.LGE.com
Items
General
Host Interface E-IDE/ATAPI
Supported Discs DVD-ROM(Single/Dual), DVD-RW, DVD-R, DVD-R
DL, DVD+RW, DVD+R, DVD+R Double layer,
DVD-RAM, CD-Digital Audio & CD-Extra, CD-Plus,
CD-ROM, CD-ROM XA-Ready, CD-I FMV, CD-TEXT,
CD-Bridge, CD-R, CD-RW, Photo-CD (Single &
Multi-Session), Video CD, DVD-Video
Disc Diameter 12cm/ 8cm
(8cm disc can be used only with drive placed horizontally.)
Mounting direction
Horizontal/Vertical
Read/Write Speed
Write : (CD-R) : 16X, 24X, 40X, 48X
(CD-RW) : 4X, 10X, 16X, 24X, 32X
(DVD-R) : 2X, 4X, 8X, 12X, 16X, 18X
(DVD-RW) : 1X, 2X, 4X, 6X
(DVD+R) : 2.4X, 4X, 8X, 12X, 16X, 18X
(DVD+RW) : 2.4X, 4X, 6X, 8X
(DVD-RAM): 2X, 3X, 5X, 6X, 8X, 12X (Ver. 2.0 & higher)
(DVD+R Double layer): 2.4X, 4X, 6X, 8X, 10X
(DVD-R Dual layer): 4X, 6X, 8X, 10X
Read : (CD-ROM/R) : 48X max
(CD-RW) : 40X max
(DVD-ROM)(Single/Dual) :16X/12X max
(DVD+/-RW) : 12X max
(DVD+/-R) : 16X max
(DVD-VIDEO) : 8X max
(DVD+R Double layer): 12X max
(DVD-R Dual layer): 12X max
(DVD-RAM): 12X max
Items
Performance
Data transfer rate
*Sustained CD-ROM : 7200 Kbytes/s (48X max)
DVD-ROM : 22160 Kbytes/s (16X max)
*Burst(ATAPI)
16.6 Mbytes/s (PIO Mode 4), (MULTI-DMA Mode 2)
66.6 Mbytes/s (Ultra-DMA Mode 4)
Average Access CD-ROM: 120msec (Typical)
DVD-ROM : 140msec (Typical)
Buffer capacity 2 Mbytes
MTBF 125,000 Power On Hours (Duty Cycle 10%)
Environmental
Level
When operating Temperature: 5 °C to 45 °C
Humidity: 15% to 85% R.H.
When not operating
Temperature: -30 °C to 60 °C
Humidity: 10% to 90% R.H.
Electrical
Power
DC 5V, DC 12V
Item Quantity
- Internal Super Multi DVD Rewriter 1
- Recording & Authoring Software
[Nero, InCD, Power Producer,
MPEG-2 Software (PowerDVD)]
1
- Quick Set-up Guide for Drive 1
Quick Set-up Guide Super Multi DVD Rewriter GSA-H50N
GSA-H50L
To install of your product, please read this guide manual carefully and completely. For the detailed owner’s manual of the drive,
please refer to the CD manual.
P/NO. 3828HN1011U Ver. A
Time (
1/3Stroke
)
GSA-H50L GSA-H50N
LightScribe Supported Not Supported
* For Optimal 18x writing, 80 pin E-IDE cable and Pentium IV 2.4GHz or faster are
recommended.


Product specificaties

Merk: LG
Categorie: Niet gecategoriseerd
Model: GSA-H50L

Heb je hulp nodig?

Als je hulp nodig hebt met LG GSA-H50L stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd LG

LG

LG FFH-976AD Handleiding

25 November 2024
LG

LG LX-330 Handleiding

23 November 2024
LG

LG LRE3027ST Handleiding

22 November 2024
LG

LG LDG3015SW Handleiding

22 November 2024
LG

LG ST-750X Handleiding

4 November 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd