LG AJ-LAN1 Handleiding

LG Niet gecategoriseerd AJ-LAN1

Lees hieronder de 📖 handleiding in het Nederlandse voor LG AJ-LAN1 (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 22 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

LAMP OWNER’S MANUAL

P/N : 3828VA0584D

AJ-LAN1

* Contact your dealer for replacing a new lamp.

The projector lamp usually lasts for about 4000 hours. You can see the used lamp time in the Selecting Function

section. You must replace the lamp when:

●

The projected image gets darker or starts to be deteriorated.

●

The lamp indicator is red.

●

The message “Replace the lamp” appears on the screen

when turning the projector lamp on.

Press the POWER button on the control panel or remote control to cut off the power.

- If the operation indicator LED is orange and blinking, do not disconnect the mains supply until the operation

indicator LED is lit up constantly (orange).

- Allow the lamp to cool for 1 hour before replacing it.

- Replace only with the same type lamp from a LG Electronics Service Center using and other lamp may cause

damage to the Projector and lamp.

- Pull out the lamp only when replacing the lamp.

- Keep the lamp unit out of reach of children or and heat sources such as radiators, stoves.

- To reduce the risk of fire, lamp shall not be exposed to liquids or foreign material.

- Do not place the lamp near any heat source.

- Make sure the new lamp is securely tightened with screws. If not, the image may be dark or there could be a risk

of fire.

- Never touch the lamp unit glass or otherwise image quality may be worse or lamp life may be reduced.

Be careful when replacing lamp

Lamp indicators

Replacing the Lamp

Turn off the projector and unplug the power cable.

Carefully place the lens side down on a cushioned

surface that will protect the lens from damage.

(Allow the lamp to cool for 1 hour before replacing it.)

Remove the retaining screw on the lamp cover with a

screwdriver or similar objects and then lift off the lamp

cover.

Lamp case bolt

After lifting the lamp cover off, remove the two

retaining screws on the lamp case with a screw-driver

or similar objects.

Bolt

Lift up the fixed wire knob on the lamp.

Knob

Pull out the handle slowly and remove the lamp case.

Insert the new lamp gently into the correct position.

Make sure it is inserted correctly.

Product specificaties

Merk:	LG
Categorie:	Niet gecategoriseerd
Model:	AJ-LAN1
Soort lamp:	NSH
Vermogen lamp:	200 W
Merkcompatibiliteit:	LG
Levensduur lamp:	4000 uur
Compatibiliteit:	AN110W