Kohler Gilford K-12700 Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor Kohler Gilford K-12700 (8 pagina's) in de categorie Spoelbak. Deze handleiding was nuttig voor 2 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/8

1017834-2-A Kohler Co.
Español, Página 3
Français, Page 5
BEFORE YOU BEGIN
Observe all local plumbing
and building codes.
Inspect the waste and supply
tubing; replace if necessary.
Provide sucient wall
reinforcement to support at
least 300 lbs. (136.1 kg).
Prior to installation, unpack the
new sink and inspect it for
damage. Return the sink to its
protective carton until you are
ready to install it.
INSTALL THE NEW SINK
Rough-in the supplies and
drain according to the
roughing-in information
packed with the sink.
Install the wall brackets to the
reinforced wall according to
the roughing-in information
packed with the sink. Level
the wall brackets.
From the underside, install a
toggle bolt, metal washer,
rubber washer, and toggle to
each of the rear bracket
slots.
Position a washer over each
front bracket slot. Position
the tie bar across the front of
the wall bracket sections so it
rests on both washers.
Secure the tie bar in place
from the underside with a
bolt, nut, and washer through
each front bracket slot.
Toggle
Rubber
Washer
Wall
Bracket
Washer
Tie Bar
Washer
Bolt
Nut
Toggle Bolt
Metal
Washer
GILFORD VITREOUS
CHINA SCRUB-UP SINK
INSTALLATION
INSTRUCTIONS

2
Kohler Co. 1017834-2-A
CAUTION: Risk of personal
injury or product damage.
Handle with care. Vitreous
china can break or chip if the
hardware is overtightened, or if
the product is handled
carelessly.
CAUTION: Risk of personal
injury or property damage.
Large vitreous china sinks are
very heavy. Get help lifting the
sink.
Position the sink on the wall
brackets, and insert the toggles
into the rear sink holes. Do not
tighten at this time.
Check the level of the sink, and
adjust by turning the bolts up or
down, as necessary.
Carefully tighten the toggle
bolts until secure. Do not
overtighten.
Insert
Toggle Bolt
in Sink Hole
Turn Bolts to
Adjust Level
Install the sink strainer, and
connect to the drain
assembly.
Install the faucet. Be sure to
follow all instructions packed
with the faucet.
Clean up with a
non-abrasive cleaner.
CALL US FOR HELP
Here’s what you need to do if you require service:
First review the installation instructions to ensure correct installation. For
additional assistance in the USA, call our Customer Service Department
for direct help. You may also contact us at our web site listed below.
Call 1-800-4-KOHLER within the U.S.
Call 001-877-680-1310 within Mexico
Call 1-800-964-5590 within Canada

3
Kohler Co. 1017834-2-A
ANTES DE COMENZAR
Cumpla con todos los códigos
locales de plomería y de
construcción.
Revise atentamente las
tuberías de alimentación y de
desagüe para ver si están
dañadas. Cámbielas de ser
necesario.
Suministre suficiente refuerzo
en la pared para soportar al
menos 300 libras (136,1 kg).
Antes de la instalación, verifique
que las piezas no estén dañadas.
Devuelva el fregadero a su caja
como protección hasta el
momento de la instalación.
INSTALACIÓN DEL NUEVO
FREGADERO
Realice el tendido de los
suministros y del desagüe de
acuerdo a la información
contenida con el fregadero.
Instale los soportes murales a
la pared reforzada, de acuerdo
a la información contenida con
el producto. Nivele los
soportes de la pared.
Desde abajo, instale un perno
articulado, una arandela de
metal, una arandela de goma
y un fiador en cada una de las
ranuras de los soportes
posteriores.
Coloque una arandela sobre la
ranura de cada soporte
delantero. Coloque la barra de
unión sobre las secciones
delanteras de los soportes, de
manera que se apoye sobre
ambas arandelas. Asegure la
barra de unión desde abajo
con un perno, una tuerca y
una arandela, a través de
cada ranura de soporte.
Palanca
acodada
Arandela de
goma
Abrazadera
mural Arandela
Barra de
unión
Arandela
Perno
Tuerca
Perno articulado
Arandela
de metal
GILFORD
FREGADERO DE
LAVADO PARA CIRUJÍA
INSTRUCCIONES DE
INSTALACIÓN
Product specificaties
Merk: | Kohler |
Categorie: | Spoelbak |
Model: | Gilford K-12700 |
Heb je hulp nodig?
Als je hulp nodig hebt met Kohler Gilford K-12700 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Spoelbak Kohler

29 Maart 2025

25 Maart 2025
Handleiding Spoelbak
- Spoelbak Bartscher
- Spoelbak Blaupunkt
- Spoelbak Franke
- Spoelbak Hendi
- Spoelbak Hotpoint-Ariston
- Spoelbak Leisure
- Spoelbak Rangemaster
- Spoelbak Saro
- Spoelbak Smeg
- Spoelbak Teka
- Spoelbak Concept
- Spoelbak Blanco
- Spoelbak Caple
- Spoelbak CDA
- Spoelbak Kernau
- Spoelbak Artusi
- Spoelbak Foster
- Spoelbak Nodor
- Spoelbak Elkay
- Spoelbak Gustavsberg
- Spoelbak Schock
- Spoelbak Roca
- Spoelbak Physa
- Spoelbak Advance Tabco
- Spoelbak Eagle Group
- Spoelbak Sani-Lav
- Spoelbak Fulgor Milano
- Spoelbak Laveo
- Spoelbak Deante
- Spoelbak Tot Mate
- Spoelbak Atosa
- Spoelbak Kuchinox
- Spoelbak Oliveri
- Spoelbak Shaws
- Spoelbak Seima
Nieuwste handleidingen voor Spoelbak

1 April 2025

31 Maart 2025

3 Maart 2025

28 Januari 2025

27 Januari 2025

17 December 2024

17 December 2024

16 December 2024

16 December 2024

6 December 2024