Kingston HyperX FURY Handleiding
Kingston
Flashgeheugen
HyperX FURY
Lees hieronder de 📖 handleiding in het Nederlandse voor Kingston HyperX FURY (2 pagina's) in de categorie Flashgeheugen. Deze handleiding was nuttig voor 45 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/2
DESCRIPTION
HyperX HX316C10FB/8 is a 1G x 64-bit (8GB) DDR3-1600
CL10 SDRAM (Synchronous DRAM) 2Rx8 memory module,
based on sixteen 512M x 8-bit DDR3 FBGA components. This
module has been tested to run at DDR3-1600 at a low latency
timing of 10-10-10 at 1.5V. Additional timing parameters are
shown in the PnP Timing Parameters section below. The
JEDEC standard electrical and mechanical specifications are
as follows:
Document No. 4807007-001.B00 04/23/15 Page 1
SPECIFICATIONS
selcyc 01)DDI(LC
Row Cycle Time (tRCmin) 48.125ns (min.)
Refresh to Active/Refresh 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 37.5ns (min.)
Maximum Operating Power TBD W*
0 - V 49gnitaR LU
Operating Temperature 0o C to 85o C
Storage Temperature -55o C to +100o C
*Power will vary depending on the SDRAM used.
FEATURES
•JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
•VDDQ = 1.5V (1.425V ~ 1.575V)
•800MHz fCK for 1600Mb/sec/pin
•8 independent internal bank
•Programmable CAS Latency: 11, 10, 9, 8, 7, 6
•Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
•8-bit pre-fetch
•Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
•Bi-directional Differential Data Strobe
•Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
•On Die Termination using ODT pin
•Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
•Asynchronous Reset
•Height 1.291” (32.80mm) w/heatsink, double sided
component
HX316C10FB/8
8GB 1G x 64-Bit DDR3-1600
CL10 240-Pin DIMM
Continued >>
kingston.com/hyperx
PnP JEDEC TIMING PARAMETERS:
•DDR3-1600 CL10-10-10 @1.5V
•DDR3-1333 CL9-9-9 @1.5V
•DDR3-1066 CL7-7-7 @1.5V
Note: The PnP feature offers a range of speed and timing options to support
the widest variety of processors and chipsets. Your maximum speed will
be determined by your BIOS.
Document No. 4807007-001.B00 Page 2
continued HyperX
All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at
the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers
faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.
FOR MORE INFORMATION, GO TO WWW.KINGSTON.COM/HYPERX
kingston.com/hyperx
7.08 mm
133.35 mm
32.8 mm
MODULE DIMENSIONS
MODULE WITH HEAT SPREADER
Product specificaties
| Merk: | Kingston |
| Categorie: | Flashgeheugen |
| Model: | HyperX FURY |
Heb je hulp nodig?
Als je hulp nodig hebt met Kingston HyperX FURY stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Flashgeheugen Kingston
9 Juli 2023
7 Juli 2023
28 April 2023
Handleiding Flashgeheugen
- Flashgeheugen Philips
- Flashgeheugen Sony
- Flashgeheugen Panasonic
- Flashgeheugen Toshiba
- Flashgeheugen Gigabyte
- Flashgeheugen Hama
- Flashgeheugen Hikvision
- Flashgeheugen Maxell
- Flashgeheugen Pentax
- Flashgeheugen SanDisk
- Flashgeheugen Transcend
- Flashgeheugen Western Digital
- Flashgeheugen Thermaltake
- Flashgeheugen Goodram
- Flashgeheugen ADATA
- Flashgeheugen Corsair
- Flashgeheugen Lexar
- Flashgeheugen Advantech
- Flashgeheugen Vimar
- Flashgeheugen Silicon Power
- Flashgeheugen Cactus
- Flashgeheugen Kingston Technology
- Flashgeheugen Delkin Devices
Nieuwste handleidingen voor Flashgeheugen
18 December 2024
1 December 2024
1 Oktober 2024
1 Oktober 2024
30 September 2024
30 September 2024
30 September 2024
30 September 2024
30 September 2024
30 September 2024