Kathrein UWS 24 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Kathrein UWS 24 (4 pagina's) in de categorie Schakelaar. Deze handleiding was nuttig voor 44 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
1 / 4
UWS 24 20550001
Wideband to Quatro Converter
About this Manual
This document is part of the product.
Read this manual carefully before using the converter
for the rst time.
Keep this document for reference throughout the
service life of the device and pass it on to any new
owner or user.
For the most up-to-date version of this manual, go to
www.kathrein-ds.com.
Keep this manual in a safe place for future
reference and include it with the unit when
passing it on to the next user.
Features
Converter for converting two wideband signals to four SAT-IF levels
The use of terminating resistor EMK 03 (order no. 237169) enables the adaptation to the LNB‘s oscillator frequency
(10.40 GHz or 10.41 GHz)
Power supply via “horizontal low” trunk
Terrestrial signals in the 5–862 MHz band can be received even when the satellite receiver is switched off
Installation on EXR 2508 (order no. 20510095) or EXR 2558 (order no. 20510096) possible using EMU 250 coupler
(order no. 20510044)
Kathrein Power Saving:
If no receiver is active in a system using Kathrein Power Saving, both the LNB and the converter are switched off
Scope of Supply
UWS 24
Instructions for use for UWS 24
Transport and Storage
Use the original packaging for transporting the device; store it in a dry place
Make sure there is no water condensation build-up.
Intended Use
The device described in this manual is only intended for the installation of satellite reception systems and may only
be installed by trained specialists
Any other use or the non-observance of these instructions will result in the loss of the warranty and guarantee
The manufacturer accepts no liability for accidents caused by the user opening the unit
Opening the unit and attempting to repair it yourself voids all warranty claims
suitable for DVB-T/T2
44,1 63,45
111,5
148
134
205500001
UWS 24
Made in Germany
H Wideband
Config
V Wideband
Terr.
H low
V low
V high
H high
Open: LNB 10,40 GHz
Term:
18 V 18 V
Wideband - Quatro - Converter
Digital Systems GmbH
LNB
10,4 GHz1
2 / 4
Safety Precautions
Installation Instructions
Risk of damage to property!
Use a coaxial cable with an inner conductor diameter
of 1.2 mm max. and without any burrs. Ensure short-
circuit-free installation.
Connectors for coaxial cables: 75 Ω RF connectors
(F series) according to EN 61169-24
Use wood screws (max. Ø 4 mm) for fastening
May not be installed in damp rooms
Use recommended accessories only
Max. 2 mm
excess length
Clamping torque
max. 3.4 Nm
(danger of over-
winding)
Diameter
0.6 - 1.2 mm free of burrs
Improper intervention can endanger the electrical safety of the device.
Do not open or tamper with the unit
Always disconnect the mains plug from the socket when working on the system
Ensure adequate clearance: at least 5 cm to all sides
Ensure free circulation of air to dissipate the heat from the unit
Do not place any liquid-fi lled items on top of the device
Do not expose the device to dripping or splashing water
Admissible ambient temperature: -20 to +55°C
The device may only be installed in dry indoor areas
Do not install the device on or against easily combustible material
The device is intended for wall mounting only! All other installation positions are prohibited
Comply with the safety regulations set out in the current EN 60728-11 and EN 62368-1 standards
The equipment must be provided with an equipotential bonding wire (Cu, at least 4 mm
2)
Input level:
To prevent overloading of the inputs, the level must not exceed 80 dBµV per transponder.
For higher input levels (> 80 dBµV) we recommend to use an attenuator (e.g. ERE 01 with 6 dB, order no.
274854).
Observe the oscillator frequency of the LNB:
Wideband feed systems using an oscillator frequency of 10.41 GHz are available on the market. To be able
to use these, screw an EMK 03 terminating resistor onto the “confi g” socket. The change is eff ective imme-
diately.
This is not required when using the Kathrein feed system UAS 582 (order no 20110032.
3 / 4
Example of Use
2
T
err.
V
high
H
high
V
low
H
low
1
4
3
6
5
8
7
20510095
230V~ 50-60Hz 17W
Power
OFF
Saving
ON
H low:
ma x.
800mA
2
T
err.
V
high
H
high
V
low
H
low
1
4
3
6
5
8
7
Power
Saving
20510096
ESD..
ESC..
ESD..
ESC..
KAZ 11/12*
UAS
582
KA Z 12
21810002
A
KAZ 11
507205
A
T
err.
V
Wideband
Config
H
Wideband
205500001
V
high
H
high
V
low
H
low
18V
18V
Open: LNB 10,40 G Hz
Term: LNB 10,41 G Hz
Wideband - Quatr o - Converte
Made in Ge rmany
UWS 24 | EXR 2558 | EXR 2508
Technical Data
Type | Order No. UWS 24
205500001
Frequency range Terrestrial SAT
Input MHz 5–862 290–2350
Output MHz 5–862 950–2150
LNB oscillator frequency
Without confi g resistance GHz - 10.40
With confi g resistance GHz - 10.41
Throughloss dB -0.5 0
Max. input level dBµV - 80
Permissible supply voltage on horiz. low V 12–19
Current drain at 18 V mA 150
Max. remote feed current mA 800
Protection class IP 30
Permissible ambient temperature °C -20 to +55
Connections F connectors
Dimensions (W x H x D) mm 159 x 148 x 43
Packing unit/weight pc./kg 1 (10)/0.45


Product specificaties

Merk: Kathrein
Categorie: Schakelaar
Model: UWS 24
Kleur van het product: Grey, White
Gewicht: 450 g
Breedte: 159 mm
Diepte: 148 mm
Hoogte: 43 mm
Soort: Kabelsplitter
Aantal: 1
Aantal connectors: 9
Aansluiting(en): F
Frequentie bereik: 5 - 862 MHz
Geslacht connector: Vrouwelijk

Heb je hulp nodig?

Als je hulp nodig hebt met Kathrein UWS 24 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Schakelaar Kathrein

Handleiding Schakelaar

Nieuwste handleidingen voor Schakelaar