JVC HZ-HM600VZR Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor JVC HZ-HM600VZR (1 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 8 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/1
HZ-HM600VZR OPERATING INSTRUCTIONS
-DO NOT PLUG THE UNIT INTO ANY PANASONIC CAMERA OR DAMAGE MAY RESULT!!!
-NEVER EXPOSE THE UNIT TO WATER OR LIQUIDS, AND NEVER EXPOSE IT TO EXCESSIVE HEAT,
PRESSURE OR SHOCK – DOING SO MAY RESULT IN DAMAGE NOT COVERED BY THE FACTORY
WARRANTY (2 YEARS)
-DO NOT ATTEMPT TO OPEN THE UNIT. DOING SO MAY VOID YOUR FACTORY WARRANTY.
-DO NOT SUBJECT THE VARIABLE ZOOM ROCKER OR THE LANC CABLE TO UNNECESSARY STRESS.
ABUSE OF THE ZOOM ROCKER OR LANC CABLE MAY RESULT IN DAMAGE NOT COVERED BY YOUR
WARRANTY!
Your HZ-HM600VZR controller is equipped with the following features: pressure-sensitive variable speed zoom
control; manual focus control; record start/stop “R”; auto/manual iris toggle “ON”; iris open “F-“; iris close
“F+”; LED record status indicator; onscreen “DATA” on/off; autofocus on/off A”.
1. Plug the controller into the “Remote” jack on your camcorder. DO NOT PLUG THE
CONTROLLER INTO ANY OTHER JACK OR DAMAGE MAY RESULT!!! DO NOT PLUG
IT INTO ANY PANASONIC CAMERA!!! If you are not sure about the location of the
Remote jack, consult the camcorder owner’s manual.
2. You can attach the controller to your tripod handle, monopod, shoulder support, or stabilizer
with the adjustable clamp (do not overtighten). The controller doesn’t require any external
power or setup. Once connected, the HZ-HM600VZR is ready to perform.
3. The rocker switch at the bottom is for . Since it is a variable rocker, the farther you zooming
press it right the faster it will zoom in (telephoto), and the farther you press it left the faster it
will zoom out (wide). You should practice a bit before shooting so that you acquire a good
sense of the rocker’s characteristics.
4. The small button marked with a red “ ” is the button. The button marked R record start/stop
ON will toggle the camera between auto iris and manual iris modes.
5. You can also control the of your lens manually using the HZ-HM600VZR. You can focus
toggle between Auto and Manual modes using the ** (marked “ ”). Once autofocus button A
you are in Manual Focus mode, you can use the switch on the controller marked “ ” to FOCUS
precisely adjust the focal plane. Pressing the up arrow ( ) will move the focal plane away
while pressing the down arrow ( ) will move the focal plane closer.
6. data manual iris DATA You also have access to two other control functions, and . The
button toggles the on-screen data (record time, settings, etc.) on and off ***. The F+ / F-
buttons allow you to adjust the iris setting for exposure.
7. Finally, the will turn red when you are recording. LED indicator light
Troubleshooting: 1) Zoom Creeping (unwanted zooming): Recalibrating the zoom center is easy. With the
controller connected to your camera, loosen the set screw on the underside of the rocker with a 5/64” hex key (alan
wrench), holding the rocker firmly in place. On the backside of the rocker is a hole with a slotted shaft, and this is
where you adjust the zoom center with a flat screwdriver. Turn it slightly left and right and you’ll see the camera
zoom in and out – find the centermost point between the zoom in/out start positions, then tighten the set screw
(don’t overcrank it). Controller not responding: Unplug the unit and plug it back in after a few seconds. 2)
512-219-7722 / www.varizoom.com


Product specificaties

Merk: JVC
Categorie: Niet gecategoriseerd
Model: HZ-HM600VZR

Heb je hulp nodig?

Als je hulp nodig hebt met JVC HZ-HM600VZR stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd JVC

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Festo

Festo VPPI Handleiding

21 November 2024
Festo

Festo SFAB Handleiding

21 November 2024
Festo

Festo SFAH Handleiding

21 November 2024
Festo

Festo DRRD-12 Handleiding

21 November 2024
Festo

Festo SDE3 Handleiding

21 November 2024
Festo

Festo SFTE Handleiding

21 November 2024
Festo

Festo CRVZS-5 Handleiding

21 November 2024