Invicta Subaqua 12880 Handleiding

Invicta Horloge Subaqua 12880

Lees hieronder de 📖 handleiding in het Nederlandse voor Invicta Subaqua 12880 (31 pagina's) in de categorie Horloge. Deze handleiding was nuttig voor 11 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/31
INSTRUCT ON MANUALI AND WARRANTY
THANK YOU FOR CHOOSING AN I TNVIC A TIMEPIECE
Long ago, we set out to continue Invicta’s original 1837 mission – to offer
magnificent Swiss timepieces at modest prices. In doing so, we gave birth
to a movement in the watch industry that is turning the balance of power
over to the consumer.
We hope you enjoy your new timepiece and carefully read the easy-to-use
instructions pertaining to it. By doing so, you will help give it a long life and
keep it operating at the high quality standards by which it was crafted.
These timepieces have been tested for water resistance. In order to maintain
the water resistance, be sure to always close the crown tightly after setting.
We also recommend having your timepiece checked every year by a certified
watchmaker to ensure the gaskets are in proper condition. This will help to
assure the precise operation and longevity of the piece. Please refer to our
Service Center information on our web site www.invictawatch.com.
QUARTZ, A MUTO AT
QUARTZ, A M IC, UTO AT
AN IND W MANUAL D WATCHES
A Quartz Watch is battery powered and does not require winding.
Eventually the battery will need to be replaced.
An Automatic Watch is a mechanical watch that winds itself and does
not require a battery. When worn daily, the movement of your wrist causes
the mainspring to wind progressively, eliminating the need for additional
winding. To start your automatic, you can hand wind it by rotating the
crown clockwise a number of turns while in its normal operating position
(screw down crowns will need to be unscrewedrst), or by swinging it side
to side for 30 seconds. We recommend housing an automatic in a watch
winder box.
A Manual Wind Watch is a mechanical watch that does not require a
battery, but can only be wound by hand. To wind it, turn the crown clock-
wise while it is in its normal operating position until you feel resistance.
This type of watch should be wound daily.
2
WATCHES WITH TIME ONLY
Setting the imeT
1. Pull out the crown to position 1. The watch stops.
2. Turn the crown until the correct time appears.
3. Push the crown back into position 0. The watch will begin running again.
10
WATCHES WITH ALARM
Setting the ime and ateT D
1. Pull out the crown to position 1. The watch continues to run.
2. Turn the crown until yesterday’s date appears.
3. Pull out the crown to position 2. The second hand stops. The display
changes from alarm time to reference time.
4. Turn the crown until the correct date appears. Observe A PM clock M/
rhythm.
5. Continue to turn the crown until the correct time appears.
6. Push the crown back into position 0. The display changes from
reference to alarm time.
! PLE NOTE . ASE Resetting the time also requires the identical correction of
the reference time. Please refer to setting the reference time”.
16
CHRONOGRAPHS
Built-in stopwatch feature
A chronograph is a timepiece with a built-in stopwatch feature. With few
exceptions, Invicta chronographs tell the time, date and include three
subsidiary dials. These dials are often referred to as sub-dials, indicators,
counters, eyes or zones. Typically, they measure minutes, seconds and
tenths of a second.
The sub-dials that measure minutes and tenths of a second are part of the
stopwatch feature. The sub-dial that measures 60 seconds is in a constant
rotation and is also known as the small seconds.
22
CHRONOGRAPHS
Adjusting the Chronograph Hands to Zero Position
1. Pull out the crown to position 2. All three chronograph hands are in
their correct or incorrect zero position.
2. Keep push-button A and B depressed simultaneously for at least 2
seconds. The center stop-second rotates 360º and corrective mode is
activated.
Adjusting the center stop second
S Pingle step: ress push-button A 1 x short
C Pontinuous: ress push-button A 1 x long
26
CHRONOGRAPHS
Measuring ccumulated imeA T
1. Start: Press push-button A Start timing..
2. Stop: Press push-button A.
3. Restart: Press push-button A. Timing is resumed.
4. Stop: Press push-button A Final time is displayed. Accumulation of .
timing can be continued by pressing push-button A.
5. Reset: Press push-button B. The chronograph hands will be reset to their
zero positions.
28
CHRONOGRAPHS
Setting the imeT
1. Pull out the crown to position 2.
To set the time to the exact second, it must be pulled out when the second
hand is in position 0. The watch stops.
2. Turn the crown until you reach the correct time.
3. Push the crown back into position 0.
To set the time to the exact second, it must be pushed back into position
0 at the exact second.
30
CHRONOG
CHRONOGRAPHS WITH BIG DATE DAYAND
Invicta is one of the first companies to use the Swiss-made Startech
5050.C, the worlds first big date and day chronograph with three eyes. It
features small seconds at 3 o’clock, tenths of a second at 6 o’clock, and
30 minutes and, in some, 12 hours at 9 o’clock.
32
CHRONOG
CHRONOGRAPHS WITH BIG DATE DAYAND
Setting the Time, D Day and ate
1. Pull out the crown to position 1.
2. Turn the crown until you reach the correct date. If you change the date
between 9:00pm and 12:00pm, it must be set to the following day as
dates set between these hours do not automatically change at midnight.
3. Pull out the crown to position 2.
4. Turn the crown clockwise until you reach the correct time.
5. Turn the crown counterclockwise until you reach the correct day.
6.
Push the crown back into position 0.
The watch will begin running again.
34
CHRONOG
CHRONOGRAPHS WITH BIG DATE DAYAND
Adjusting the Chronograph Hands to Zero Position
Before using the chronograph functions, please ensure that the crown is
in position 0 and the 4 chronograph hands are precisely at zero position
following activation of push-button B. Should this not be the case, the
positions of the hands must be adjusted.
1. Pull out the crown to position 1. All three chronograph hands are in
their correct or incorrect zero position.
2. Keep push-button A and B depressed simultaneously for at least 2
seconds. The center stop-second rotates 360º and corrective mode is
activated.
Adjusting the center stop second
S Pingle step: ress push-button A 1 x short
C Pontinuous: ress push-button A 1 x long
36
CHRONOGRAP
CHRONOGRAPHS WITH DATE DAY M, AND ONTH
Adjusting the Chronograph Hands to Zero Position
Before using the chronograph functions, please ensure that the crown is
in position 0 and the 4 chronograph hands are precisely at zero position
following activation of push-button B. Should this not be the case, the
positions of the hands must be adjusted.
1. Pull out the crown to position 1. All three chronograph hands are in
their correct or incorrect zero position.
2. Keep push-button A and B depressed simultaneously for at least 2
seconds. The center stop-second rotates 360º and corrective mode is
activated.
Adjusting the center stop second
S Pingle step: ress push-button A 1 x short
C Pontinuous: ress push-button A 1 x long
46
WARRANTY
INFOR IONMAT
Your Invicta timepiece is backed by a comprehensive 1-year Warranty from
date of purchase. This covers repairs due to failure or breakdown of the
movement and all its components, as well as the crown, dial, markers, hands
and water resistant pressure. It does not cover scratches to the crystal, case,
metal band, leather, microfiber, or rubber straps or any damage that results
from normal wear and tear.
You also have the option of purchasing our Invicta P Plan extended latinum
4-year Warranty. The information for both warranties can be found in your
gift box or by calling 1-866- TA.INVIC
Each genuine Invicta timepiece purchased from an E Invicta Retailer is lite
in its original and tested condition and should only be serviced by qualified
professionals at the place of purchase or at the Invicta Service Center in
accordance with the terms of the Invicta Warranties.
50
SHIPPING
INFOR IONMAT
! P ASE NO E:LE T
If you are sending your watch to the Invicta Service C and it has an enter
exotic strap, you must remove the strap first, or we cannot accept the
shipment. It will be returned to you.
The strict laws of the U.S. Government Fish and W Service prohibit ildlife
the shipping of exotic species without proper documentation. This includes
alligator, crocodile, snake, Ostrich, and fish, such as stingrays or Salmon.
Please note that genuine leather straps, synthetic straps, leather embossed
straps, and metal bands are excluded from this policy and you may keep
those straps attached.
Your watch may be forwarded to one of many Invicta Service Centers around
the world according to the origin of your watch. In order to avoid any delays
we request that you REMOVE ANY TIC STRAPS MAIL ONLY THEXO and E
WATCH FOR SERV E. CASE IC
54
SHIPPING INFOR IONMAT
! P ASE NO E:LE T
The owner will be responsible for shipping the watch to and from us for
service. A flat rate of $25 will be charged, which should be submitted as a
money order.
MAIL TO: Invicta Service Center
1 Invicta Way (3069 Taft St.)
Hollywood Florida, 33021
U.S.A.
As part of our commitment to superior service, once your watch is received,
we will mail you a postcard advising you of your service case number.
This will give you the ability to refer to your particular case, as well as track
the progress online at www.invictawatch.com.
56
© Invicta Watch Company of America, Inc., 2008. All rights reserved.
w w w. i n vi c t awa t c h. c o m


Product specificaties

Merk: Invicta
Categorie: Horloge
Model: Subaqua 12880

Heb je hulp nodig?

Als je hulp nodig hebt met Invicta Subaqua 12880 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Horloge Invicta

Handleiding Horloge

Nieuwste handleidingen voor Horloge