Infinity IMS Handleiding

Infinity Niet gecategoriseerd IMS

Lees hieronder de 📖 handleiding in het Nederlandse voor Infinity IMS (12 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 5 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/12
I N F I N I T Y
®
IMS
Input Management System
Système de Gestion des Entrées
Sistema de Gestión de Entrada
I M S
2
THANK YOU
for purchasing
the Infinity®IMS Input Management
System. So that you may be better served
should your new product require service,
please retain your original purchase
receipt and read the enclosed warranty
registration card.
BOX CONTENTS
Your IMS package should contain all the
items shown in Figure 1:
Figure 1. Contents
WARNING
Playing loud music in an automobile can
hinder your ability to hear traffic and
permanently damage your hearing.
Listening at low or moderate levels while
driving your car is recommended. Infinity
Systems accepts no responsibility for
hearing loss, bodily injury or property
damage resulting from the use or misuse
of this product.
INSTALLATION
IMPORTANT
To get the most out of your IMS’s features,
it is strongly recommended that installation
be entrusted to a qualified professional.
Although these instructions explain how
to install, connect and set up the IMS, they
cannot show all of the different possible
systems that can be assembled using the
IMS. Please ask your authorized Infinity car
audio dealer about professional installation.
INSTALLATION ARNINGS AND IPSW T
• Always use protective eyewear when
using tools.
• Turn OFF the vehicle’s audio system and
other electrical devices before beginning
installation. Disconnect the (–) negative
lead from the vehicle’s battery.
• Check clearances on both sides of any
planned mounting surface befor drillinge
any holes or installing any screws.
Remember that the screws can extend
behind the mounting surface.
• At the installation locations, locate and
make a note of all fuel lines, hydraulic
brake lines, vacuum lines and electrical
wiring. Use extreme caution when cutting
or drilling in and around these areas.
• Before drilling or cutting holes, use a
utility knife to remove unwanted fabric
or vinyl to keep material from snagging
in the drill bit.
• When routing cables, keep input-signal
cables away from power cables and
speaker wires to minimize noise.
• When making connections, make certain
they are secure operl insulated.and pr y
• If the IMS’s fuse must be replaced, use
only the same type and rating as the
original. Do not substitute another kind.
Junction Box
Hands-Free
Microphone
Flush-Mount Ring
Wiring Harness Adhesive Strip
Bag with Installation Screws:
4x #8 x 1" Screws for Junction Box
2x #6 Screws for Control Head
2x 3mm Machine Screws for U-Bracket
Owner’s Manual
and Warranty Card
VELCRO
®
Strip
U-Bracket
Hands-Free Microphone
Surface-Mount Holder
Control Head
3
INSTALLING THE ONTROL EADC H
It is recommended that you find a location
for the Control Head first, and then find a
location for the Junction Box that is within
a distance of 4m, the length of the Control
Head’s integral cable.
IMPORTANT NSTALLATIONI WARNINGS:
• Do not install the Control Head where
it may obstruct your view through
the windshield or your view of your
vehicle’s indicator displays.
• Do not install the Control Head where it
may hinder the function of safety devices
such as an airbag. Doing so may prevent
the airbag from functioning properly,
in the event of an accident.
• Mount the Contr Head in a location thatol
is easily accessible.
The Control Head can be surface-mounted
using the included U-Bracket, VELCRO strip,
or adhesive strip, or it can be flush-mounted
using the included Flush-Mount Ring.
U U-BSING THE RACKET
1. Determine the location for the Control
Head. Be sure to leave room to route
the integral cable.
2. Attach the U-Bracket to the mounting
location using fasteners that are
appropriate for the mounting surface,
as shown in Figure 2.
3. Attach the Control Head to the
U-Bracket, as shown in Figure 2.
Figur 2. Attace hing the U-Bracket
U V SSING THE ELCRO TRIP
1. Determine the location for the Control
Head. Be sure to leave room to route the
integral cable.
2. Clean the mounting location with an
alcohol swab or something similar.
3. Remove the protective strip from
the hook side of the VELCRO strip
and adhere the strip to the mounting
location.
4. Remove the protective strip from
the loop side of the VELCRO strip
and adhere the strip to the back of
the Control Head.
U A SSING THE DHESIVE TRIP
1. Determine the location for the Control
Head. Be sure to leave room to route the
integral cable.
IMPORTANT:
Select the
mounting location carefully – once the
adhesive strip has been adhered to the
surface, it is not possible to remove it
and readhere it elsewhere.
2. Clean the mounting location with an
alcohol swab or something similar.
3. Remove the protective strip from one
side of the adhesive strip and adhere it
to the back of the Control Head.
4. Remove the remaining protective strip
from the adhesive strip and adhere the
Control Head to the mounting surface.
Fasteners appropriate for mounting surface
A
B
C
3mm Machine Screws
(included)

Product specificaties

Merk: Infinity
Categorie: Niet gecategoriseerd
Model: IMS

Heb je hulp nodig?

Als je hulp nodig hebt met Infinity IMS stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd Infinity

Infinity

Infinity IMS Handleiding

16 December 2024
Infinity

Infinity BassLink 4SC Handleiding

16 December 2024
Infinity

Infinity Kappa Nucleus FC-1 Handleiding

26 November 2024
Infinity

Infinity S401 Handleiding

19 Maart 2024
Infinity

Infinity iW-1941 RDM Handleiding

19 Maart 2024
Infinity

Infinity iW-1915 Pixel Handleiding

19 Maart 2024
Infinity

Infinity B401 Handleiding

18 Maart 2024
Infinity

Infinity iFX-640 Handleiding

18 Maart 2024
Infinity

Infinity INFKPNTCKIT Handleiding

14 November 2023
Infinity

Infinity INF-BC4 Handleiding

16 Juni 2023

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Cateye

Cateye PW-TR100 Handleiding

16 December 2024
Cateye

Cateye OS1.1 Handleiding

16 December 2024
Cateye

Cateye Strada Double Wireless CC-RD400DW Handleiding

16 December 2024
Cateye

Cateye Strada Wireless CC-RD310W-U Handleiding

16 December 2024
Cateye

Cateye OS1.0 Handleiding

16 December 2024
Cateye

Cateye MSC-2Dx Handleiding

16 December 2024
Ledlenser

Ledlenser Flexible Wallet Handleiding

16 December 2024
Growatt

Growatt TPM-CT-E-EU Handleiding

16 December 2024
Cateye

Cateye MSC-HR10 Handleiding

16 December 2024
Cateye

Cateye MSC-3Dx Handleiding

16 December 2024