Indesit WIDXE 146 S (UK) Handleiding
Indesit
Was-droog combinaties
WIDXE 146 S (UK)
Lees hieronder de 📖 handleiding in het Nederlandse voor Indesit WIDXE 146 S (UK) (16 pagina's) in de categorie Was-droog combinaties. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/16
1
GB
English, 1
Contents
Installation, 2-3-4-5
Unpacking and levelling
Electric and water connections
The first wash cycle
Technical details
Washer-dryer description, 6-7
Control panel
Display
MEMO Programme
Starting and Programmes, 8
Briefly: how to start a programme
Programme table
Personalisations, 9-10
Setting the spin cycle
Setting the delay timer
Setting the temperature
Setting the drying cycle
Functions
Detergents and laundry, 11
Detergent dispenser
Preparing your laundry
Special items
Woolmark
Precautions and advice, 12
General safety
Disposal
Saving energy and respecting the environment
Care and maintenance, 13
Cutting off the water or electricity supply
Cleaning your appliance
Cleaning the detergent dispenser
Caring for your appliance door and drum
Cleaning the pump
Checking the water inlet hose
Troubleshooting, 14
Service, 15
Before calling for Assistance
WASHER-DRYER
WIDXE 146 S
Instructions for use
GB
2
GB
Installation
Keep this instruction manual in a safe place for
future reference. Should the appliance be sold,
transferred or moved, make sure the instruction
manual accompanies the washer-dryer to inform the
new owner as to its operation and features.
Read these instructions carefully: they contain vital
information on installation, use and safety.
Unpacking and levelling
Unpacking
1. Unpack the washer-dryer.
2. Check whether the washer-dryer has been
damaged during transport. If this is the case, do not
install it and contact your retailer.
3. Remove the four
protective screws and
the rubber bush with
the respective spacer,
situated on the rear of
the appliance (see also
the installation leaflet).
NB:The plastic spacers
may fall down inside the
machine once the bolt
has been removed, and will not interfere with the
operation of the machine.
4. Seal the gaps using the plastic plugs provided.
5. Keep all the parts: you will need them again if the
washing machine needs to be moved to another
location.
Packaging materials are not children's toys.
Levelling
Your machine may make a considerable amount of noise
if the two front feet have not been adjusted correctly.
1. Install the washer-dryer on a flat sturdy floor,
without resting it up against walls, furniture cabinets
or other.
2. If the floor is not
perfectly level, compen-
sate for any unevenness
by tightening or
loosening the adjustable
front feet (see figure);
the angle of inclination,
measured according to
the worktop, must not
exceed 2°.
Levelling your appliance correctly will provide it with
stability and avoid any vibrations, noise and shifting
during operation. If it is placed on a fitted or loose
carpet, adjust the feet in such a way as to allow
enough room for ventilation beneath the washer-dryer.
Electric and water connections
Connecting the water inlet hose
1. Insert seal A into the
end of the inlet hose
and screw the latter
onto a cold water tap
with a 3/4 gas threaded
mouth (see figure).
Before making the
connection, allow the
water to run freely until
it is perfectly clear.
2. Connect the other end
of the water inlet hose to
the washer-dryer,
screwing it onto the
appliance's cold water
inlet, situated on the top
right-hand side on the
rear of the appliance
(see figure).
3. Make sure there are no kinks or bends in the hose.
The water pressure at the tap must be within the
values indicated in the Technical details table
(on the next page).
If the water inlet hose is not long enough, contact
a specialist store or an authorised serviceman.
Ensure that the supply taps are allowing water
through. Old taps may seize in the closed position
and thus prevent water reaching the machine.
Never use hoses that have already been used.
A
3
GB
Connecting the drain hose
Connect the drain hose,
without bending it, to a
draining duct or a wall
drain situated between
65 and 100 cm from
the floor;
The drain hose may be
connected to an
under-sink trap. Before
connecting the drain
hose from the machine
ensure that any blanks
or removable ends
have been taken off
the spigot.
If it is place over the
edge of a basin or sink
be sure the free end of
the hose should not be
underwater.
We advise against the use of hose extensions; in
case of absolute need, the extension must have the
same diameter as the original hose and must not
exceed 150 cm in length.
Ensure that if the drain hose is pushed into a
standpipe, that the end does not go down more
than 15cms (6 inches). If the hose is pushed down
too far, this may cause the machine to self -syphon
ie. continuously empty as it is filling.
Electric connection
Before plugging the appliance into the mains
socket, make sure that:
the socket is earthed and in compliance with the
applicable law;
the socket is able to sustain the appliance's
maximum power load indicated in the Technical
details table (see page 5);
the supply voltage is included within the values
indicated on the Technical details table
(see page 5);
the socket is compatible with the washer-dryer's
plug. If this is not the case, replace
the socket or the plug.
Your appliance is now supplied with a 13 amp fused
plug it can be plugged into a 13 amp socket for
immediate use. Before using the appliance please
read the instructions below.
WARNING - THIS APPLIANCE MUST BE EARTHED.
THE FOLLOWING OPERATIONS SHOULD BE
CARRIED OUT BY A QUALIFIED ELECTRICIAN.
Replacing the fuse:
When replacing a faulty fuse, a 13 amp ASTA
approved fuse to BS 1362 should always be used,
and the fuse cover re-fitted. If the fuse cover is lost,
the plug must not be used until a replacement is
obtained.
Replacement fuse covers:
If a replacement fuse cover is fitted, it must be of
the correct colour as indicated by the coloured
marking or the colour that is embossed in words on
the base of the plug. Replacements can be obtained
directly from your nearest Service Depot.
Removing the plug:
If your appliance has a non-rewireable moulded plug
and you should wish to re-route the mains cable
through partitions, units etc., please ensure that
either:
the plug is replaced by a fused 13 ampere re-
wearable plug bearing the BSI mark of approval.
or:
the mains cable is wired directly into a 13 amp cable
outlet, controlled by a switch, (in compliance with
BS 5733) which is accessible without moving the
appliance.
Disposing of the plug:
Ensure that before disposing of the plug itself, you
make the pins unusable so that it cannot be
accidentally inserted into a socket.
Instructions for connecting cable to an alternative plug:
Important: the wires in the mains lead are coloured
in accordance with the following code:
Green & Yellow Earth
Blue Neutral
Brown Live
65 - 100 cm
Where it connects
to the waste water
pipe cut end off
spigot or remove the
blanking cap
Product specificaties
| Merk: | Indesit |
| Categorie: | Was-droog combinaties |
| Model: | WIDXE 146 S (UK) |
Heb je hulp nodig?
Als je hulp nodig hebt met Indesit WIDXE 146 S (UK) stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Was-droog combinaties Indesit
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
Handleiding Was-droog combinaties
- Was-droog combinaties Electrolux
- Was-droog combinaties Bosch
- Was-droog combinaties Candy
- Was-droog combinaties Samsung
- Was-droog combinaties LG
- Was-droog combinaties Bauknecht
- Was-droog combinaties BEKO
- Was-droog combinaties Miele
- Was-droog combinaties Siemens
- Was-droog combinaties Whirlpool
- Was-droog combinaties Zanussi
- Was-droog combinaties Hoover
- Was-droog combinaties Amica
- Was-droog combinaties Belling
- Was-droog combinaties Blomberg
- Was-droog combinaties Brandt
- Was-droog combinaties Edy
- Was-droog combinaties Fagor
- Was-droog combinaties Frilec
- Was-droog combinaties Haier
- Was-droog combinaties Hotpoint
- Was-droog combinaties Hotpoint-Ariston
- Was-droog combinaties Neff
- Was-droog combinaties Nordland
- Was-droog combinaties Philco
- Was-droog combinaties Rosieres
- Was-droog combinaties Sanyo
- Was-droog combinaties Sharp
- Was-droog combinaties Zanussi-electrolux
- Was-droog combinaties Elba
- Was-droog combinaties Euromaid
- Was-droog combinaties Infiniton
- Was-droog combinaties Servis
- Was-droog combinaties Summit
- Was-droog combinaties Tricity Bendix
- Was-droog combinaties Voltas BEKO
- Was-droog combinaties Lamona
- Was-droog combinaties Creda
Nieuwste handleidingen voor Was-droog combinaties
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022