Indesit pwde 7145 w Handleiding

Indesit Was/Droogcombi pwde 7145 w

Lees hieronder de ๐Ÿ“– handleiding in het Nederlandse voor Indesit pwde 7145 w (36 pagina's) in de categorie Was/Droogcombi. Deze handleiding was nuttig voor 45 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/36
1
GB
English,1
GB
WASHER-DRYER
Contents
Installation, 2-3
Unpacking and levelling
Connecting the electricity and water supplies
The first wash cycle
Technical data
Description of the washer-dryer, 4-5
Control panel
Display
How to run a wash cycle or a drying cycle, 6
Wash cycles and options, 7
Table of programmes and wash cycles
Wash options
Detergents and laundry, 8
Detergent dispenser drawer
Preparing the laundry
Special wash cycles
Precautions and advice, 9
General safety
Disposal
Opening the porthole door manually
Care and maintenance, 10
Cutting off the water and electricity supplies
Cleaning the washer-dryer
Cleaning the detergent dispenser drawer
Cleaning the pump
Checking the water inlet hose
Troubleshooting, 11
Service, 12
PWDE 7145 W
Instructions for use
Franรงais,13
F
Nederlands,25
NL
2
GB
Installation
๎€ This instruction manual should be kept in a safe place
for future reference. If the washer-dryer is sold,
transferred or moved, make sure that the instruction
manual remains with the machine so that the new
owner is able to familiarise himself/herself with its
operation and features.
๎€๎€€Read these instructions carefully: they contain vital
information relating to the safe installation and operation
of the appliance.
Unpacking and levelling
Unpacking
1. Remove the washer-dryer from its packaging.
2. Make sure that the washer-dryer has not been
damaged during the transportation process. If it has
been damaged, contact the retailer and do not proceed
any further with the installation process.
3. Remove the 4
protective screws (used
during transportation) and
the rubber washer with
the corresponding spacer,
located on the rear part of
the appliance (see figure).
4. Close off the holes using the plastic plugs provided.
5. Keep all the parts in a safe place: you will need them
again if the washer-dryer needs to be moved to another
location.
๎€ Packaging materials should not be used as toys for
children.
Levelling
1. Install the washer-dryer on a flat sturdy floor, without
resting it up against walls, furniture cabinets or anything
else.
2. If the floor is not
perfectly level,
compensate for any
unevenness by tightening
or loosening the adjustable
front feet (see figure); the
angle of inclination,
measured in relation to the
worktop, must not exceed
2ยฐ.
Levelling the machine correctly will provide it with
stability, help to avoid vibrations and excessive noise and
prevent it from shifting while it is operating. If it is placed
on carpet or a rug, adjust the feet in such a way as to
allow a sufficient ventilation space underneath the
washer-dryer.
Connecting the electricity and water
supplies
Connecting the water inlet hose
1. Connect the inlet hose
by screwing it to a cold
water tab using a 3/4 gas
threaded connection (see
figure).
Before performing the
connection, allow the
water to run freely until it is
perfectly clear.
2. Connect the inlet hose
to the washer-dryer by
screwing it onto the
corresponding water inlet
of the appliance, which is
situated on the top right-
hand side of the rear part
of the appliance (see
figure).
3. Make sure that the hose is not folded over or bent.
๎€ The water pressure at the tap must fall within the
range of values indicated in the Technical data table (see
next page).
๎€ If the inlet hose is not long enough, contact a
specialised shop or an authorised technician.
๎€๎€€Never use second-hand hoses.
๎€๎€€Use the ones supplied with the machine.
3
GB
Connecting the drain hose
Connect the drain hose,
without bending it, to a
drain duct or a wall drain
situated between 65 and
100 cm from the floor;
alternatively, place it
over the edge of a
basin, sink or tub,
fastening the duct
supplied to the tap (see
figure). The free end of
the hose should not be
underwater.
๎€ We advise against the use of hose extensions; if it is
absolutely necessary, the extension must have the
same diameter as the original hose and must not
exceed 150 cm in length.
Electrical connections
Before plugging the appliance into the electricity
socket, make sure that:
๎€บ the socket is earthed and complies with all
applicable laws;
๎€บ the socket is able to withstand the maximum
power load of the appliance as indicated in the
Technical data table (see opposite);
๎€บ the power supply voltage falls within the values
indicated in the Technical data table (see opposite);
๎€บ the socket is compatible with the plug of the
washer-dryer. If this is not the case, replace the
socket or the plug.
๎€ The washer-dryer must not be installed outdoors,
even in covered areas. It is extremely dangerous to
leave the appliance exposed to rain, storms and
other weather conditions.
๎€ When the washer-dryer has been installed, the
electricity socket must remain within easy reach.
๎€ Do not use extension cords or multiple sockets.
65 - 100 cm
๎€ The cable should not be bent or compressed.
๎€ The power supply cable must only be replaced by
authorised technicians.
Warning! The company shall not be held responsible
in the event that these standards are not observed.
The first wash cycle
Once the appliance has been installed, and before you
use it for the first time, run a wash cycle with
detergent and no laundry, using wash cycle number 2.
Technical data
Model PWDE 7145 W
Dimensions
width 59,5 cm
height 85 cm
depth 55 cm
Capacity from 1to 7 kg for wash programme
from 1 to 5 kg for the drying programme
Electrical
connections
please refer to the technical data
plate fixed to the machine
Water connections
maximum pressure 1 MPa (10 bar)
minimum pressure 0.05 MPa (0.5 bar)
drum capacity 52 litres
Spin speed up to 1400 rotations per minute
Energy rated
programmes
according to
regulation
EN 50229
Wash: programme 2; temperature
60ยฐC; using a load of 7 kg.
Drying:๎€€
๎€€
๎€€
๎€€๎€€first drying cycle performed
with a 2 kg load, by selecting the
drying level "A1" (IRON);
Second drying cycle performed with a
5 kg load, selecting the maximum
drying level "A4" (EXTRA).
This appliance conforms to the
following EC Directives:
- 89/336/EEC dated 03/05/89
(Electromagnetic Compatibility) and
subsequent modifications
- 2006/95/EC (Low Voltage)
- 2002/96/EC


Product specificaties

Merk: Indesit
Categorie: Was/Droogcombi
Model: pwde 7145 w

Heb je hulp nodig?

Als je hulp nodig hebt met Indesit pwde 7145 w stel dan hieronder een vraag en andere gebruikers zullen je antwoorden