Indesit IWDE 7145 Handleiding
Indesit
Was/Droogcombi
IWDE 7145
Lees hieronder de π handleiding in het Nederlandse voor Indesit IWDE 7145 (60 pagina's) in de categorie Was/Droogcombi. Deze handleiding was nuttig voor 55 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/60
GB
1
Contents
Installation, 2-3
Unpacking and levelling
Connecting the electricity and water supplies
The first wash cycle
Technical data
Description of the Washer-dryer, 4-5
Control panel
Display
How to run a wash cycle or a drying cycle, 6
Wash cycles and options, 7
Table of wash cycles
Wash options
Detergents and laundry, 8
Detergent dispenser drawer
Preparing the laundry
Special wash cycles
Load balancing system
Precautions and tips, 9
General safety
Disposal
Opening the porthole door manually
Care and maintenance, 10
Cutting off the water or electricity supply
Cleaning the Washer-dryer
Cleaning the detergent dispenser drawer
Caring for the door and drum of your appliance
Cleaning the pump
Checking the water inlet hose
Troubleshooting, 11
Service, 12
IWDE 7145
Instructions for use
WASHER-DRYER
Nederlands,49
NL
ξ This symbol reminds you to read this instruction manual.
English,1
GB
Français,13
F
Deutsch,25
DE
EspaΓ±ol,37
ES
2
GB
Installation
ξ This instruction manual should be kept in a safe
place for future reference. If the Washer-dryer is sold,
transferred or moved, make sure that the instruction
manual remains with the machine so that the new
owner is able to familiarise himself/herself with its
operation and features.
ξ Read these instructions carefully: they contain vital
information relating to the safe installation and
operation of the appliance.
Unpacking and levelling
Unpacking
1. Remove the Washer-dryer from its packaging.
2. Make sure that the Washer-dryer has not been
damaged during the transportation process. If it has
been damaged, contact the retailer and do not
proceed any further with the installation process.
3. Remove the 4
protective screws (used
during transportation) and
the rubber washer with
the corresponding
spacer, located on the
rear part of the appliance
(see figure).
4. Close off the holes using the plastic plugs provided.
5. Keep all the parts in a safe place: you will need
them again if the Washer-dryer needs to be moved to
another location.
ξ Packaging materials should not be used as toys for
children.
Levelling
1. Install the Washer-dryer on a flat sturdy floor,
without resting it up against walls, furniture cabinets
or anything else.
2. If the floor is not
perfectly level, compen-
sate for any unevenness
by tightening or loosening
the adjustable front feet
(see figure); the angle of
inclination, measured in
relation to the worktop,
must not exceed 2Β°.
Levelling the machine correctly will provide it with
stability, help to avoid vibrations and excessive noise
and prevent it from shifting while it is operating. If it is
placed on carpet or a rug, adjust the feet in such a
way as to allow a sufficient ventilation space
underneath the Washer-dryer.
Connecting the electricity and water
supplies
Connecting the water inlet hose
1. Connect the supply
pipe by screwing it to a
cold water tab using a ΒΎ
gas threaded connection
(see figure).
Before performing the
connection, allow the
water to run freely until it
is perfectly clear.
2. Connect the inlet hose
to the Washer-dryer by
screwing it onto the
corresponding water inlet
of the appliance, which is
situated on the top right-
hand side of the rear part
of the appliance (see
figure).
3. Make sure that the hose is not folded over or bent.
ξ The water pressure at the tap must fall within the
values indicated in the Technical details table (see
next page).
ξ If the inlet hose is not long enough, contact a
specialised shop or an authorised technician.
ξ Never use second-hand hoses.
ξ Use the ones supplied with the machine.
GB
3
Technical data
Model IWDE 7145
Dimensions
width 59.5 cm
height 85 cm
depth 53,5 cm
Capacity from 1 to 7 kg for the wash programme;
from 1 to 5 kg for the drying programme
Electrical
connections
please refer to the technical data plate
fixed to the machine
Wate r
connections
maximum pressure 1 MPa (10 bar)
minimum pressure 0.05 MPa (0.5 bar)
drum capacity 52 litres
Spin speed up to 1400 rotations per minute
Energy rated
programmes
according to
regulation
EN 50229
Wash: programme 2; temperature 60Β°C;
using a load of 7 kg.
Drying: first drying cycle performed with
a 2 kg load, selecting drying level "A1"
(IRON DRY); second drying cycle
performed with a 5 kg load, selecting
drying level "A4" (EXTRA DRY).
This appliance conforms to the following
EC Directives:
- 89/336/EEC dated 03/05/89
(Electromagnetic Compatibility) and
subsequent modifications
- 2002/96/EC
- 2006/95/EC (Low Voltage)
65 - 100 cm
Connecting the drain hose
Connect the drain hose,
without bending it, to a
drainage duct or a wall
drain located at a height
between 65 and 100 cm
from the floor;
alternatively, rest it on
the side of a washbasin
or bathtub, fastening the
duct supplied to the tap
(see figure). The free end
of the hose should not
be underwater.
ξ We advise against the use of hose extensions; if it is
absolutely necessary, the extension must have the
same diameter as the original hose and must not
exceed 150 cm in length.
Electrical connections
Before plugging the appliance into the electricity
socket, make sure that:
ξ
the socket is earthed and complies with all
applicable laws;
ξ
the socket is able to withstand the maximum power
load of the appliance as indicated in the Technical
data table (see opposite);
ξ
the power supply voltage falls within the values
indicated in the Technical data table (see opposite);
ξ
the socket is compatible with the plug of the
Washer-dryer. If this is not the case, replace the
socket or the plug.
ξ The Washer-dryer must not be installed outdoors,
even in covered areas. It is extremely dangerous to
leave the appliance exposed to rain, storms and other
weather conditions.
ξ When the Washer-dryer has been installed, the
electricity socket must be within easy reach.
ξ Do not use extension cords or multiple sockets.
ξ The cable should not be bent or compressed.
ξ The power supply cable must only be replaced by
authorised technicians.
Warning! The company shall not be held responsible
in the event that these regulations are not respected.
The first wash cycle
Once the appliance has been installed, and before
you use it for the first time, run a wash cycle with
detergent and no laundry, using the wash cycle 2.
Product specificaties
| Merk: | Indesit |
| Categorie: | Was/Droogcombi |
| Model: | IWDE 7145 |
Heb je hulp nodig?
Als je hulp nodig hebt met Indesit IWDE 7145 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Was/Droogcombi Indesit
16 Februari 2022
16 Augustus 2022
16 Augustus 2022
16 Augustus 2022
6 April 2022
5 Maart 2022
19 Maart 2022
17 Augustus 2022
15 Augustus 2022
3 Maart 2022
Handleiding Was/Droogcombi
- Was/Droogcombi Electrolux
- Was/Droogcombi Bosch
- Was/Droogcombi Candy
- Was/Droogcombi Bauknecht
- Was/Droogcombi BEKO
- Was/Droogcombi Grundig
- Was/Droogcombi Siemens
- Was/Droogcombi Whirlpool
- Was/Droogcombi Zanussi
- Was/Droogcombi Zanker
- Was/Droogcombi Hoover
- Was/Droogcombi Hotpoint-Ariston
- Was/Droogcombi Luxor
- Was/Droogcombi Privileg
- Was/Droogcombi Zanussi-electrolux
Nieuwste handleidingen voor Was/Droogcombi
1 April 2023
20 Augustus 2023
18 Augustus 2023
18 Juli 2023
9 Februari 2023
18 Juli 2023
18 Juli 2023
4 Februari 2023
9 Februari 2023
4 Februari 2023