Icom AT-141 Handleiding

Icom Receiver AT-141

Lees hieronder de 📖 handleiding in het Nederlandse voor Icom AT-141 (11 pagina's) in de categorie Receiver. Deze handleiding was nuttig voor 42 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/11
HF AUTOMATIC
ANTENNA TUNER
AT-141
INSTRUCTION MANUAL
i
FOREWORD
Thank you for purchasing the AT-141 HF AUTO-
MATIC ANTENNA TUNER.
The AT-141 is designed, primarily for use with Icom HF
transceivers.
Refer to your HF transceiver instruction manual for op-
eration. If you have any questions, contact your dealer.
IMPORTANT
READ ALL INSTRUCTIONS carefully and com-
pletely before using the AT-141.
SAVE THIS INSTRUCTION MANUAL. This in-
struction manual contains important safety and instal-
lation instructions.
EXPLICIT DEFINITIONS
PRECAUTIONS
RDANGER HIGH VOLTAGE! NEVER touch
the antenna terminal, ground terminal, antenna or
counterpoise while transmitting. Place the AT-141, an-
tenna and counterpoise in positions where no one can
touch them.
NEVER use without a ground connection.
NEVER transmit during internal adjustment. This may
cause an electric shock.
USE the ground terminal for ground connection.
The mounting plate is not connected internally.
DO NOT operate your HF marine transceiver without
running the boat’s engine.
AVOID using the AT-141 in areas where the temper-
ature is below –30°C or above +60°C.
Ground terminal
Mounting plate
Word Definition
RWARNING Personal injury, re hazard or electric
shock may occur.
CAUTION Equipment damage may occur.
NOTE
If disregarded, inconvenience only. No
personal injury, re hazard or electric
shock.
SUPPLIED ACCESSORIES
The following accessories are supplied with the AT-141. Qty.
qU-bolts ……………………………………………… 2
wU-bolt plates ……………………………………2
eFlat washers (M6 large) ………………………… 8
rFlat washers (M6 small) ………………………… 4
tSpring washers (M6) ……………………………… 8
yNuts (M6) …………………………………………… 8
uHex head bolts (M6×50) ………………………… 4
iSelf-tapping screws (A0 6×30) …………………… 4
oWeatherproof cap ………………………………… 1
!0 4-pin connector …………………………………… 1
!1 Connector pins …………………………………… 4
!2 Ground cable (OPC-412) ………………………… 1
q
w
e
r
t
y
u
i
o
!0 !1
!2
Icom, Icom Inc. and the logo are registered trademarks of Icom Incorporated (Japan) in the United States, the United King-
dom, Germany, France, Spain, Russia and/or other countries.
ii
MISCELLANEOUS ITEMS
The following parts are additionally required for instal-
lation, but are not supplied with the AT-141.
Purchase these parts locally.
qAWG 14×4-conductor shielded cable
*Icom offers an optional OPC-1465
CONTROL CABLE
.
Length: 10 m; 32.8 feet
w50 coaxial cable
ePL-259 connectors
FEATURES
Matches all bands
The AT-141 matches any frequency on every HF ma-
rine band. For example, the tuner matches a 7 m; 23 ft
long-wire antenna across 1.6 30 MHz.
Full automatic tuning
Just push the [TUNE] key on the transceiver, and the
AT-141 adjusts immediately to the minimum SWR of
any frequency on any HF marine band.
HF operation on any size ship
The AT-141 allows you HF operation where antenna
element length is restricted due to space.
Weather resistant
The AT-141 is housed in a durable, completely weather
resistant ASA case with a rubber gasket. The antenna
tuner can be conveniently installed both on the deck or
in the cabin near the antenna element.
Simple installation
Installation is simple. Just connect the control and an-
tenna cables. You never need to open the cover.
45 memories for shorter tuning time
To decrease the tune-up time, the AT-141 automatically
stores the matching conditions for up to 45 frequencies.
Re-tuning for a memorized frequency takes approx. 1
sec.
Super capacitor for memory backup
Even if the AT-141 is not used for approx. 1 week, the
built-in super capacitor backs up contents of the 45
memories.
Low power tune up
The AT-141 emits low output power during tuning. This
feature reduces the possibility of causing interference
to other stations.
Tuner through function
The tuner through function is built into the AT-141. This
function helps improve receiver gain, depending on the
antenna element length used, and operating fre-
quency.
TABLE OF CONTENTS
FOREWORD …………………………………………… i
IMPORTANT …………………………………………… i
EXPLICIT DEFINITIONS ………………………… i
PRECAUTIONS ……………………………………… i
SUPPLIED ACCESSORIES ……………………… i
MISCELLANEOUS ITEMS ……………………… ii
FEATURES …………………………………………… ii
TABLE OF CONTENTS ………………………… ii
1 ANTENNA SYSTEM ………………………… 1–2
Antenna for ship ………………………………… 1
Coaxial cable …………………………………… 2
Ground and counterpoise ……………………… 2
2 INSTALLATIONS …………………………3–5
Installation outline ……………………………… 3
Control cable……………………………………3
PL-259 connector………………………………… 4
Mounting ………………………………………… 4
Cable connections ……………………………… 5
3 CONTROL CABLE SIGNALS ……………… 6
Terminal information …………………………… 6
4 UNIT DESCRIPTION AND SPECIFICATIONS … 7
Unit description…………………………………… 7
Speci 7cations ……………………………………


Product specificaties

Merk: Icom
Categorie: Receiver
Model: AT-141

Heb je hulp nodig?

Als je hulp nodig hebt met Icom AT-141 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Receiver Icom

Handleiding Receiver

Nieuwste handleidingen voor Receiver