HP Aruba IAP-304 Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor HP Aruba IAP-304 (11 pagina's) in de categorie Wifi. Deze handleiding was nuttig voor 88 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/11
Aruba 300 Series Wireless Access Point
Installation Guide
Rev03 | August 2018 1
The Aruba 300 Series wireless access points (APs) support IEEE802.11ac standards for high-performance WLAN, and are
equipped with two radios, which provide network access and monitor the network simultaneously. These access points deliver
high-performance 802.11n 2.4 GHz and 802.11ac 5 GHz functionality, while also supporting 802.11a/b/g wireless services.
Multi-user Multiple-in, Multiple-output (MU-MIMO) is enabled when operating in 5GHz mode for optimal performance.
The AP-304 and AP-305 access points work in conjunction with an Aruba controller, while the IAP-304 and IAP-305 access point
can be configured using a built-in virtual controller.
The 300 Series wireless access points provide the following capabilities:
IEEE 802.11a/b/g/n/ac operation as a wireless access point
IEEE 802.11a/b/g/n/ac operation as a wireless air monitor
IEEE 802.11a/b/g/n/ac spectrum monitor
Compatible with IEEE 802.3at PoE+ and IEEE 802.3af PoE
Centralized management configuration and upgrade
Integrated Bluetooth Low Energy (BLE) Radio
Package Contents
(I)AP-304 or (I)AP-305 access point
Ceiling Rail Adapter (spare: AP-220-MNT-C1)
Startup Guide
Software
The AP-304 and AP-305 access points require ArubaOS 6.5.1.0 or higher. For additional information, refer to the ArubaOS User
Guide and ArubaOS Quick Start Guide.
The IAP-304 and IAP-305 access points require Aruba Instant 4.3.1.0 or higher. For additional information, refer to the Aruba
Instant User Guide and Aruba Instant Quick Start Guide.
This device must be professionally installed and serviced by a trained ACMP or similar Aruba-certified technician. Aruba
access points are classified as radio transmission devices, and are subject to government regulations of the host country.
The network administrator(s) is/are responsible for ensuring that configuration and operation of this equipment is in
compliance with their country’s regulations. For complete list of approved channels in your country of the AP-304 and AP-305
access points, refer to the Aruba Downloadable Regulatory Table at support.arubanetworks.com.
Inform your supplier if there are any incorrect, missing, or damaged parts. If possible, retain the carton, including the original
packing materials. Use these materials to repack and return the unit to the supplier if needed.
2Aruba 300 Series Wireless Access Point | Regulatory Compliance and Safety Information Guide
300 Series Hardware Overview
Figure 1 Status LEDs on AP Front (305 shown)
LEDs
The 300 Series access points have two LEDs that indicate the system and radio status of the device. These two LEDs can be
configured via ArubaOS (for AP-304 and AP-305) or Aruba Instant (for IAP-304 and IAP-305) software into three separate
modes:
Normal mode (by default): See Table 1
Both LEDs off
Blink mode: Both LEDs blink green (synchronized)
External Antenna Connectors
The AP-304 and IAP-304 access points are equipped with three external antenna connectors on the front corners of the access
point.
Table 1 300 Series LEDs Status in Normal Mode
LED Color/State Meaning
System Status
(Left)
Off Device powered off
Green- Blinking Device booting, not ready for use
Green- Solid Device ready for use, no restrictions
Green- Flashing Device ready for use, uplink negotiated in sub optimal speed
(<1Gbps)
Amber- Solid Device ready for use; power-save mode (802.3af PoE)
Amber- Flashing Device ready for use; power-save mode (802.3af PoE), uplink
negotiated in sub optimal speed (<1Gbps)
Red- Solid System error condition
Radio Status
(Right)
Off Device powered off, or both radios disabled
Green- Solid Both radios enabled in access mode
Green- Blinking One radio enabled in access mode
Amber- Solid Both radios enabled in monitor mode
Amber- Blinking One radio enabled in monitor mode
Alternating One radio enabled in access mode, other in monitor mode
System
Radio
Aruba 300 Series Wireless Access Point | Regulatory Compliance and Safety Information Guide 3
Figure 2 External Antenna Connector
USB Interface
The 300 Series is equipped with a USB port for connectivity with cellular modems and other USB client devices. When powered
by an 802.3at or DC power source, the USB port can supply power up to 5W/1A. The USB interface is disabled when the access
point is powered by an 802.3af PoE source (power-save mode).
Console Port
The serial console port is located at the back of the device and is a 4-pin connector covered by a dust cover. An optional serial
adapter cable (AP-CBL-SER) is sold separately to connect the device to a serial terminal or a laptop for direct local
management.
Ethernet Port
The 300 Series access points are equipped with one 10/100/1000Base-T auto-sensing MDI/MDX Ethernet port. This port
supports wired-network connectivity, in addition to Power over Ethernet (PoE) from IEEE 802.3af and 802.3at compliant power
sources.
This device accepts 56V DC (802.3at), or 48V DC (802.3af) nominal as a standard powered device (PD) from power sourcing
equipment, including PoE midspan injector or a PoE-sourcing network infrastructure.
Figure 3 Back Panel
Kensington Lock Slot
The 300 Series access points are equipped with a Kensington lock slot for additional security.
ANT0 ANT1
ANT2
External antennas for this device must be installed by an Aruba Certified Mobility Professional (ACMP) or other
Aruba-certified technician, using manufacturer-approved antennas only.
The Equivalent Isotropically Radiated Power (EIRP) levels for all external antenna devices must not exceed the regulatory
limit set by the host country/domain.
Installers are required to record the antenna gain for this device in the system management software.
CONSOLE
12V 1A
Console Port
Ethernet Port
USB Port
Reset Button
DC Power Socket
Kensington Lock
Product specificaties
| Merk: | HP |
| Categorie: | Wifi |
| Model: | Aruba IAP-304 |
Heb je hulp nodig?
Als je hulp nodig hebt met HP Aruba IAP-304 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Wifi HP
23 December 2022
23 December 2022
Handleiding Wifi
- Wifi Panasonic
- Wifi Huawei
- Wifi Quintezz
- Wifi Siemens
- Wifi Akasa
- Wifi AVM
- Wifi Belkin
- Wifi D-Link
- Wifi Devolo
- Wifi DKT
- Wifi Draytek
- Wifi Easypix
- Wifi Edimax
- Wifi Eminent
- Wifi Envivo
- Wifi Fantec
- Wifi Gembird
- Wifi Google
- Wifi Grixx
- Wifi ICIDU
- Wifi Iiyama
- Wifi KlikaanKlikuit
- Wifi Lab 31
- Wifi Maginon
- Wifi Mercku
- Wifi Netgear
- Wifi PENTAGRAM
- Wifi Premier
- Wifi Proximus
- Wifi Sitecom
- Wifi SolarNRG
- Wifi Strong
- Wifi Sungevity
- Wifi T-Mobile
- Wifi Telenet
- Wifi Telfort
- Wifi Tenda
- Wifi Trendnet
- Wifi Ubee
- Wifi Ubiquiti
- Wifi Verizon
- Wifi Ziggo
- Wifi ZyXEL
- Wifi On Networks
- Wifi Dartwood
- Wifi Ryoko
Nieuwste handleidingen voor Wifi
28 September 2023
21 September 2023
13 September 2023
13 September 2023
13 September 2023
13 September 2023
13 September 2023
26 Juli 2023
22 Augustus 2023