Hotpoint HSIC 3M19 C UK N Handleiding
Hotpoint
lave-vaisselle
HSIC 3M19 C UK N
Lees hieronder de đ handleiding in het Nederlandse voor Hotpoint HSIC 3M19 C UK N (8 pagina's) in de categorie lave-vaisselle. Deze handleiding was nuttig voor 23 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/8
EN
1
Before using the appliance carefully read Health and Safety guide.
APPLIANCE
PRODUCT DESCRIPTION
THANK YOU FOR BUYING A HOTPOINT ARISTON
PRODUCT. In order to receive a more complete assistan-
ce, please register your appliance on:
www.hotpoint.eu/register
You can download the Safety Instructions and
the Use and Care Guide, by visiting our website
docs.hotpoint.eu and following the Instructions on
the back of this booklet.
1. Upper rack
2. Foldable îaps
3. Upper rack height adjuster
4. Upper spray arm
5. Lower rack
6. Cutlery basket
7. Lower spray arm
8. Filter Assembly
9. Salt reservoir
10. Detergent and Rinse Aid dispensers
11. Rating plate
12. Control panel
0000 000 00000
Service:
1
2
3
4
5
6
7
9
8
1011
12
1 2 3 4 5 6 7 8 9 10 11
1. ON-OFF/Reset button with indicator light
2. Program selection button
3. Salt reîll indicator light
4. Rinse Aid reîll indicator light
5. Program number and delay time indicator
6. Tablet indicator light
DAILY REFERENCE
GUIDE
CONTROL PANEL
7. Display
8. Half Load indicator lights
9. Half Load button
10. Delay button
11. START/Pause button with indicator light / Tab
2
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the reta-
ining elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and
on the machineâs functional components.
âą It is important that the salt reservoir be never empty.
âą It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher
(see PRODUCT DESCRIPTION) and should be îlled when the SALT REFILL
indicator light in the control panel is lit .
1. Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2. -Only the îrst time you do this: îll the salt re
servoir with water.
3. Position the funnel (see îgure) and îll the salt
reservoir right up to its edge (approximately
1 kg); it is not unusual for a little water to leak
out.
4. Remove the funnel and wipe any salt residue
away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get
into the container during the wash program (this could damage the
water softener beyond repair).
Whenever you need to add salt, we recommend carrying out the
procedure before the washing cycle is started.
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that
the water hardness setting is based on the actual water hardness in
your house. This information can be obtained from your local water
supplier.
The factory setting is for average (3) water hardness.
âą Switch on the appliance by pressing the button.ON/OFF
âą Switch oî the appliance by pressing the button.ON/OFF
âą Hold down button for 5 seconds, until you hear a beep.P
âą Switch on the appliance by pressing the button.ON/OFF
âą The current selection level number and the salt indicator light both îash.
âą Press button P to select the desired hardness level (see WATER
HARDNESS TABLE).
âą Switch oî the appliance by pressing the button.ON/OFF
Setting is complete!
As soon as this procedure is complete, run a program without loading.
Only use salt that has been speciîcally designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL indi-
cator light switches oî.
If the salt container is not îlled, the water softener and the
heating element may be damaged as a result.
Water Hardness Table
Level °dH
German degrees
°fH
French degrees
1 Soft 0 - 6 0 - 10
2 Medium 7 - 11 11 - 20
3 Average 12 - 17 21 - 30
4 Hard 17 - 34 31 - 60
5 Very hard 35 - 50 61 - 90
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dispenser should A
be îlled when the indicator light in the control RINSE AID REFILL
panel is lit.
1. Open the dispenser B by pressing and pulling up the tab on the lid.
2. Pour in the rinse aid (max.110 ml), making sure it does not overîow
from the dispenser. If this happens, clean the spill immediately with
a dry cloth.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the appliance tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satisîed with the drying results, you can ad-
just the quantity of rinse aid used.
âą Switch the dishwasher on using the button.ON/OFF
âą Switch it oî using the button.ON/OFF
âą Press button three times - a beep will be heard.P
âą Switch it on using the button.ON/OFF
âą The current selection level number and rinse aid indicator light îash.
âą Press button P to select the level of rinse aid quantity to be supplied.
âą Switch it oî using the buttonON/OFF
Setting is complete!
If the rinse aid level is set to ZERO (ECO), no rinse aid will be supplied.
The LOW RINSE AID indicator light will not be lit if you run out of rinse
aid.
A maximum of 4 levels can be set according to the dishwasher model.
The factory setting is speciîc to the model, please follow instruction
above to check this for your machine.
âą If you see bluish streaks on the dishes, set a low number (1-2).
âą If there are drops of water or limescale marks on the dishes, set a
mid-range number (3-4).
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser use the opening device A.
Introduce the detergent into the dry dispenser B only. Place the
amount of detergent for pre-washing directly inside the tub.
1. When measuring out the detergent
refer to the mentioned earlier infor-
mation to add the proper quantity.
Inside the dispenser there are B
indications to help the detergent
dosing.
2. Remove detergent residues from
the edges of the dispenser and clo-
se the cover until it clicks.
3. Close the lid of the detergent
dispenser by pulling it up until the
closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the program.
If all-in-one detergents are used, we recommend using the TABLET
button, because it adjusts the program so that the best washing and
drying results are always achieved.
A
B
A
B
EN
3
Program
Drying
phase
Available
options *)
Detergent
container Duration of
wash program
(h:min)**)
Water
consumption
(litres/cycle)
Energy
consumption
(kWh/cycle)
Tub B
1Eco 50° 4:00 11.5 0.83
2Intensive 65° - 2:30 15.0 1.50
3Normal 55° - 2:30 15.0 1.30
4Daily 50° - 1:20 11.5 1.10
5Delicates
45°
- 1:40 11.5 1.00
6Express 30â 50° - - 0:30 8.5 0.50
7Soak - - --0:10 4.5 0.01
PROGRAMS TABLE
ECO program data is measured under laboratory conditions according to European Standard EN 50242.
Note for Test Laboratories:
For information on comparative EN testing conditions, please send an email to the following address: assistenza_en_lvs@indesitcompany.com
Pre-treatment of the dishes is not needed before any of the programs.
*) Not all options can be used simultaneously.
**) The duration of the program shown on the display or in the booklet is an estimate calculated on standard conditions. The actual time may vary
depending on many factors such as temperature and pressure of the incoming water, room temperature, amount of detergent, quantity and type of load,
load balancing, additional selected options and sensor calibration. The sensor calibration can increase program duration up to 20 min.
Standby consumption: Left-on mode consumption: 5 W - Oî mode consumption: 0.5 W
PROGRAMS DESCRIPTION
Instructions on wash cycle selection.
1 ECO
Normally soiled crockery. Standard program, the most eîcient in
terms of its combined energy and water consumption.
2 INTENSIVE
Program recommended for heavily soiled crockery, especially suitable
for pans and saucepans (not to be used for delicate items).
3 NORMAL
Mixed soil. For normally soiled dishes with dried food residues.
4 DAILY
Normally soiled crockery. Everyday cycle, that ensures optimal cleaning
and drying performance in shorter time.
5 DELICATES
Program for delicate items, which are more sensitive to high tempera-
tures, for example glasses and cups.
6 EXPRESS 30â
Program to be used for lightly-soiled dishes with no dried food
residues.
7 SOAK
Use to refresh crockery planned to be washed later. No detergent to be
used with this program.
Notes:
Please note that cycles like Express or Fast are most eîective for lightly
soiled dishes.
To reduce consumption even further, only run the dishwasher
when it is full.
Product specificaties
| Merk: | Hotpoint |
| Categorie: | lave-vaisselle |
| Model: | HSIC 3M19 C UK N |
| Longueur du cĂąble: | 1.3 m |
| Tension d'entrée AC: | 230-240 V |
| Poids du paquet: | 31600 g |
| Largeur: | 448 mm |
| Profondeur: | 555 mm |
| Hauteur: | 820 mm |
| Ăcran integrĂ©: | Oui |
| Type de commande: | Boutons |
| Fréquence d'entrée AC: | 50 Hz |
| Classe d'efficacité énergétique: | F |
| Poids: | 29600 g |
| Placement de l'appareil: | EntiÚrement intégré |
| Taille du produit: | Taille maximum (60 cm) |
| Panneaux personnalisĂ©s prĂȘt Ă l'emploi: | Oui |
| Couleur de la porte: | Argent |
| Couleur de panneau de commande: | Argent |
| Longueur du tuyau d'alimentation: | 1.55 m |
| Longueur du tuyau d'Ă©vacuation: | 1.5 m |
| Hauteur du panier supérieur réglable: | Oui |
| Type d'Ă©cran: | LED |
| Plage dâefficacitĂ© Ă©nergĂ©tique: | A Ă G |
| Consommation d'Ă©nergie pour 100 cycles: | 84 kWh |
| Consommation d'Ă©nergie par cycle: | 0.84 kWh |
| Consommation d'eau par cycle: | 11.5 L |
| Charge connectée: | 1900 W |
| Actuel: | 13 A |
| Nombre de couverts: | 10 couverts |
| Classe d'Ă©mission sonore: | C |
| Niveau sonore: | 49 dB |
| Durée de cycle: | 240 min |
| Nombre de programmes de lavage: | 7 |
| Température (max): | - °C |
| Température d'alimentation en eau chaude maximum: | 60 °C |
| Minuterie, départ différé: | Oui |
| SystÚme de séchage: | Statique |
| Programmes de lavage: | Eco, Glass/delicate, Mixed, Quick, Soak |
| Demi-charge: | Oui |
| Autonettoyant: | Oui |
| Départ différé: | 12 h |
| Profondeur de compartiment d'installation: | 560 mm |
| La hauteur des compartiments d'installation (min): | 820 mm |
| La hauteur des compartiments d'installation (max): | 900 mm |
| Largeur de compartiment d'installation: | 600 mm |
| Classe de séchage: | A |
| Classe de lavage: | A |
| Indicateur de sel: | Oui |
| Rincer indicateur de l'aide: | Oui |
Heb je hulp nodig?
Als je hulp nodig hebt met Hotpoint HSIC 3M19 C UK N stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding lave-vaisselle Hotpoint
25 Mei 2023
Handleiding lave-vaisselle
Nieuwste handleidingen voor lave-vaisselle
14 Juni 2023