Hotpoint BHWDD 74 (UK) Handleiding
Hotpoint
Was-droog combinaties
BHWDD 74 (UK)
Lees hieronder de đź“– handleiding in het Nederlandse voor Hotpoint BHWDD 74 (UK) (20 pagina's) in de categorie Was-droog combinaties. Deze handleiding was nuttig voor 39 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/20
GB
1
English,1
Contents
Installation, 2-3-4-5-6-7
Unpacking and levelling
Connecting the electricity and water supplies
The first wash cycle
Technical data
Instructions for the fitter
Care and maintenance, 8
Cutting off the water or electricity supply
Cleaning the washer dryer
Cleaning the detergent dispenser drawer
Caring for the door and drum of your appliance
Cleaning the pump
Checking the water inlet hose
Precautions and tips, 9
General safety
Disposal
Description of the washer dryer, 10-11
Control panel
Display
How to run a wash cycle or a drying cycle, 12
Wash cycles and functions, 13
Table of wash cycles
Wash functions
Detergents and laundry, 14
Detergent dispenser drawer
Preparing the laundry
Special wash cycles
Load balancing system
Troubleshooting, 15-16
Product Guarantee and Repair Information, 17
GB
BHWDD 74
Instructions for use
WASHER DRYER
! This symbol reminds you to read this instruc-
tion manual.
2
GB
Installation
Levelling your appliance correctly will provide
it with stability and avoid any vibrations, noise
and shifting during operation. If it is placed on
a fitted or loose carpet, adjust the feet in such
a way as to allow enough room for ventilation
beneath the washing machine.
Electric and water connections
Connecting the water inlet hose
1. Connect the supply
pipe by screwing it to
a cold water tap using
a 3/4 gas threaded
connection (see figu-
re).
Before performing the
connection, allow the
water to run freely un-
til it is perfectly clear.
2. Connect the other
end of the water inlet
hose to the washing
machine,
screwing it onto the
appliance’s cold water
inlet, situated on the
top right-hand side on
the rear of the ap-
pliance (see figure).
3. Make sure there are no kinks or bends in the
hose.
! The water pressure at the tap must be within
the values indicated in the Technical details
table (on the page 5).
! If the water inlet hose is not long enough,
contact a specialist store or an authorised
serviceman.
! Ensure that the supply taps are allowing wa-
ter through. Old taps may seize in the closed
position and thus prevent water reaching the
machine.
! Keep this instruction manual in a safe place for
future reference. Should the appliance be sold, tran-
sferred or moved, make sure the instruction manual
accompanies the washing machine to inform the
new owner as to its operation and features.
! Read these instructions carefully: they contain
vital information on installation, use and safety.
Unpacking and levelling
Unpacking
! This is a separate part
of the polystyrene base
and should be remo-
ved with the base.
! IMPORTANT check
when unpacking your
machine.
1. Unpack the washing machine.
2. Check whether the washing machine has
been damaged during transport. If this is the
case, do not install it and contact your retailer.
3. Remove the 4 pro-
tective screws and the
rubber bush with the
respective spacer, si-
tuated on the rear of the
appliance (see also the
installation leaflet).
4. Seal the gaps using the plastic plugs provided.
5. Keep all the parts: you will need them again
if the washing machine needs to be moved to
another location.
! Packaging materials are not children’s toys.
Levelling
Your machine may make a considerable amount
of noise if the two front feet have not been adju-
sted correctly.
1. Install the washing
machine on a flat sturdy
floor, without resting it up
against walls, furniture
cabinets or other.
2. If the floor is not perfectly level, compensate
for any unevenness by tightening or loosening
the adjustable front feet ; the an- (see figure)
gle of inclination, measured according to the
worktop, must not exceed 2°.
GB
3
Connecting the drain hose
Connect the drain
hose, without bending
it, to a draining duct or
a wall drain situated
between 65 and 100
cm from the floor;
The drain hose may
be connected to an
under-sink trap. Be-
fore connecting the
drain hose from the
machine ensure that
any blanks or remo-
vable ends have been
taken off the spigot.
If it is placed over the
edge of a basin or sink
be sure the free end of
the hose should not
be underwater.
! We advise against the use of hose extensions; in
case of absolute need, the extension must have
the same diameter as the original hose and must
not exceed 150 cm in length.
Ensure that if the drain hose is pushed into a stan-
dpipe, that the end does not go down more than
15cms (6 inches). If the hose is pushed down too
far, this may cause the machine to self -syphon
ie. continuously empty as it is filling.
Electric connection
Before plugging the appliance into the mains
socket, make sure that:
• the socket is earthed and in compliance with
the applicable law;
• the socket is able to sustain the appliance’s
maximum power load indicated in the Technical
details table;
• the supply voltage is included within the values
indicated on the Technical Data Plate fixed on
the machine.
• the socket is compatible with the washing
machine’s plug. If this is not the case, replace
the socket or the plug.
Your appliance is now supplied with a 13 amp fu-
sed plug it can be plugged into a 13 amp socket
for immediate use. Before using the appliance
please read the instructions below.
WARNING - THIS APPLIANCE MUST BE EAR-
THED.
THE FOLLOWING OPERATIONS SHOULD BE
CARRIED OUT BY A QUALIFIED ELECTRICIAN.
Replacing the fuse:
When replacing a faulty fuse, a 13 amp ASTA
approved fuse to BS 1362 should always be
used, and the fuse cover re-fitted. If the fuse
cover is lost, the plug must not be used until a
replacement is obtained.
Replacement fuse covers:
If a replacement fuse cover is fitted, it must be of
the correct colour as indicated by the coloured
marking or the colour that is embossed in words
on the base of the plug. Replacements can be
obtained directly from your nearest Service Depot.
Removing the plug:
If your appliance has a non-rewireable moulded
plug and you should wish to re-route the mains
cable through partitions, units etc., please en-
sure that either:
the plug is replaced by a fused 13 ampere rewi-
reable plug bearing the BSI mark of approval.
or:
the mains cable is wired directly into a 13 amp
cable outlet, controlled by a switch, (in complian-
ce with BS 5733) which is accessible without
moving the appliance.
Disposing of the plug:
Ensure that before disposing of the plug itself,
you make the pins unusable so that it cannot be
accidentally inserted into a socket.
Instructions for connecting cable to an alterna-
tive plug:
Important: the wires in the mains lead are co-
loured in accordance with the following code:
Green & Yellow Earth
Blue Neutral
Brown Live
65 - 100 cm
Where it connects to
the waste water pipe
cut end off spigot or
remove the blanking cap
Product specificaties
| Merk: | Hotpoint |
| Categorie: | Was-droog combinaties |
| Model: | BHWDD 74 (UK) |
Heb je hulp nodig?
Als je hulp nodig hebt met Hotpoint BHWDD 74 (UK) stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Was-droog combinaties Hotpoint
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
Handleiding Was-droog combinaties
- Was-droog combinaties Electrolux
- Was-droog combinaties Bosch
- Was-droog combinaties Candy
- Was-droog combinaties Samsung
- Was-droog combinaties Indesit
- Was-droog combinaties LG
- Was-droog combinaties Bauknecht
- Was-droog combinaties BEKO
- Was-droog combinaties Miele
- Was-droog combinaties Siemens
- Was-droog combinaties Whirlpool
- Was-droog combinaties Zanussi
- Was-droog combinaties Hoover
- Was-droog combinaties Amica
- Was-droog combinaties Belling
- Was-droog combinaties Blomberg
- Was-droog combinaties Brandt
- Was-droog combinaties Edy
- Was-droog combinaties Fagor
- Was-droog combinaties Frilec
- Was-droog combinaties Haier
- Was-droog combinaties Hotpoint-Ariston
- Was-droog combinaties Neff
- Was-droog combinaties Nordland
- Was-droog combinaties Philco
- Was-droog combinaties Rosieres
- Was-droog combinaties Sanyo
- Was-droog combinaties Sharp
- Was-droog combinaties Zanussi-electrolux
- Was-droog combinaties Elba
- Was-droog combinaties Euromaid
- Was-droog combinaties Infiniton
- Was-droog combinaties Servis
- Was-droog combinaties Summit
- Was-droog combinaties Tricity Bendix
- Was-droog combinaties Voltas BEKO
- Was-droog combinaties Lamona
- Was-droog combinaties Creda
Nieuwste handleidingen voor Was-droog combinaties
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022
3 Oktober 2022