Hotpoint-Ariston WDG 862 EU Handleiding

Hotpoint-Ariston Wasmachine WDG 862 EU

Lees hieronder de 📖 handleiding in het Nederlandse voor Hotpoint-Ariston WDG 862 EU (84 pagina's) in de categorie Wasmachine. Deze handleiding was nuttig voor 16 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/84

English,1

WASHER-DRYER

! This symbol reminds you to read this instruction manual.

Contents

Installation, 2-3

Unpacking and levelling

Connecting the electricity and water supplies

The first wash cycle

Technical data

Care and maintenance, 4

Cutting off the water and electricity supplies

Cleaning the washer-dryer

Cleaning the detergent dispenser drawer

Caring for the door and drum of your appliance

Cleaning the pump

Checking the water inlet hose

Precautions and advice, 5

General safety

Disposal

Opening the porthole door manually

Description of the washer-dryer, 6-7

Control panel

Display

How to run a wash cycle or a drying cycle, 8

Wash cycles and options, 9

Table of programmes and wash cycles

Wash options

Detergents and laundry, 10

Detergent dispenser drawer

Preparing the laundry

Special wash cycles

Troubleshooting, 11

Service, 12

WDG 862

Instructions for use

Magyar,13

Česky,25

Slovensky,37

Română,49

RO UA

Українська,61

Русский,73

CIS

Installation

Levelling the machine correctly will provide

it with stability, help to avoid vibrations and

excessive noise and prevent it from shifting

while it is operating. If it is placed on carpet or

a rug, adjust the feet in such a way as to allow

a sufficient ventilation space underneath the

washer-dryer.

Connecting the electricity and

water supplies

Connecting the water inlet hose

1. Connect the supply

pipe by screwing it to

a cold water tap using

a ¾ gas threaded

connection (see

figure).

Before performing the

connection, allow the

water to run freely until

it is perfectly clear.

2. Connect the

inlet hose to the

washer-dryer by

screwing it onto the

corresponding water

inlet of the appliance,

which is situated on

the top right-hand

side of the rear part

of the appliance (see

figure).

3. Make sure that the hose is not folded over

or bent.

! The water pressure at the tap must fall within

the values indicated in the Technical details

table (see page 3).

! If the inlet hose is not long enough, contact a

specialised shop or an authorised technician.

! Never use second-hand hoses.

! Use the ones supplied with the machine.

! This instruction manual should be kept in a

safe place for future reference. If the washer-

dryer is sold, transferred or moved, make

sure that the instruction manual remains with

the machine so that the new owner is able to

familiarise himself/herself with its operation

and features.

! Read these instructions carefully: they

contain vital information relating to the safe

installation and operation of the appliance.

Unpacking and levelling

Unpacking

1. Remove the washer-dryer from its packaging.

2. Make sure that the washer-dryer has not

been damaged during the transportation

process. If it has been damaged, contact the

retailer and do not proceed any further with

the installation process.

3. Remove the 4

protective screws

(used during

transportation)

and the rubber

washer with the

corresponding

spacer, located on

the rear part of the

appliance ( ).see figure

4. Close off the holes using the plastic plugs

provided.

5. Keep all the parts in a safe place: you will

need them again if the washer-dryer needs to

be moved to another location.

! Packaging materials should not be used as

toys for children.

Levelling

1. Install the washer-dryer on a flat sturdy floor,

without resting it up against walls, furniture

cabinets or anything else.

2. If the floor is not

p e r f e c t l y l e v e l ,

c o m p e n s a t e f o r

any unevenness by

tightening or loosening

the adjustable front

feet ( ); the see figure

angle of inclination,

measured in relation to

the worktop, must not

exceed 2°.

Technical data

Model WDG 862

Dimensions

width 59.5 cm

height 85 cm

depth 60,5 cm

Capacity

from 1 to 8 kg for the wash

programme

from 1 to 6 kg for the drying

programme

Electrical

connections

please refer to the technical

data plate fixed to the machine

Water con-

nections

maximum pressure

1 MPa (10 bar)

minimum pressure

0.05 MPa (0.5 bar)

drum capacity 62 litres

Spin speed up to 1200 rotations per

minute

Energy ra-

ted

programmes

according to

regulation

EN 50229

Wash: programme 4; tem-

perature 60°C; using a load

of 8 kg.

Drying: the smaller load

must be dried by selecting

the “A1” (IRON) dryness le-

vel. The load must consist of

2 sheets, 1 pillowcase and 1

hand towel;

the remainder of the load must

be dried by selecting the “A4”

(EXTRA) dryness level.

This appliance conforms to

the following EC Directives:

- 2004/108/EC (Electromagne-

tic Compatibility)

- 2006/95/EC (Low Voltage)

- 2002/96/EC

65 - 100 cm

Connecting the drain hose

Connect the drain

hose, without bending

it, to a drainage duct

or a wall drain located

at a height between

65 and 100 cm from

the floor;

alternatively, rest

it on the side of

a washbasin or

bathtub, fastening

the duct supplied to

the tap ( ). see figure

The free end of the

hose should not be

underwater.

! We advise against the use of hose

extensions; if it is absolutely necessary, the

extension must have the same diameter as the

original hose and must not exceed 150 cm in

length.

Electrical connections

Before plugging the appliance into the

electricity socket, make sure that:

• the socket is earthed and complies with all

applicable laws;

• the socket is able to withstand the maximum

power load of the appliance as indicated on

the Technical Data Plate fixed on the machine;

• the power supply voltage falls within the

values indicated on the Technical Data Plate

fixed on the machine;

• the socket is compatible with the plug of the

washer-dryer. If this is not the case, replace

the socket or the plug.

! The washer-dryer must not be installed

outdoors, even in covered areas. It is extremely

dangerous to leave the appliance exposed to

rain, storms and other weather conditions.

! When the washer-dryer has been installed, the

electricity socket must be within easy reach.

! Do not use extension cords or multiple sockets.

! The cable should not be bent or compressed.

! The power supply cable must only be

replaced by authorised technicians.

Warning! The company shall not be held

responsible in the event that these regulations

are not respected.

The first wash cycle

Once the appliance has been installed, and

before you use it for the first time, run a wash

cycle with detergent and no laundry, using the

wash cycle “Auto Clean”.

Product specificaties

Merk:	Hotpoint-Ariston
Categorie:	Wasmachine
Model:	WDG 862 EU
Apparaatplaatsing:	Vrijstaand
Kleur van het product:	Wit
Deurscharnieren:	Links
Ingebouwd display:	Ja
Breedte:	595 mm
Diepte:	605 mm
Hoogte:	850 mm
Type lader:	Voorbelading
Deurkleur:	Wit
Uitgestelde start timer:	Ja
Energie-efficiëntieklasse (oud):	B
Energieverbruik wassen:	- kWu
Waterconsumptie per cyclus:	62 l
Wasklasse:	A
Centrifuge-droger klasse:	A
Maximale centrifugesnelheid:	1200 RPM
Deur openingshoek:	180 °
Nominale capaciteit:	8 kg
Wasprogramma's:	Hygiene/anti-allergy, Baby care, Black, Cotton, Hand/wool, Intensive/outdoor, Quick, Synthetics, White, Delicate/silk