Hotpoint-Ariston SWD107617C Handleiding

Hotpoint-Ariston Wasmachine SWD107617C

Lees hieronder de 📖 handleiding in het Nederlandse voor Hotpoint-Ariston SWD107617C (16 pagina's) in de categorie Wasmachine. Deze handleiding was nuttig voor 9 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/16

! This symbol reminds you to read this instruc-

tion manual.

Contents

Installation, 2-3-4-5

Unpacking and levelling

Connecting the electricity and water supplies

The first wash cycle

Technical data

Care and maintenance, 6

Cutting off the water or electricity supply

Cleaning the washer-dryer

Cleaning the detergent dispenser drawer

Caring for the door and drum of your appliance

Cleaning the pump

Checking the water inlet hose

Precautions and tips, 7

General safety

Disposal

Opening the porthole door manually

Description of the washer-dryer, 8-9

Control panel

Display

How to run a wash cycle or a drying cycle, 10

Wash cycles and functions, 11

Table of wash cycles

Wash functions

Detergents and laundry, 12

Detergent dispenser drawer

Preparing the laundry

Special wash cycles

Load balancing system

Troubleshooting, 13-14

Assistance, 15-16

SWD 107617

Instructions for use

WASHER-DRYER

English,1

Installation

inclination, measured according to the worktop,

must not exceed 2°.

Levelling your appliance correctly will provide

it with stability and avoid any vibrations, noise

and shifting during operation. If it is placed on

a fitted or loose carpet, adjust the feet in such

a way as to allow enough room for ventilation

beneath the washing machine.

Electric and water connections

Connecting the water inlet hose

1. Connect the sup-

ply pipe to the water

mains using a gas 3/4

attachment, fitting the

rubber gasket and

the filter supplied with

the appliance and

ensuring that they are

fimly tightened to the

taps. The water supply

marked must be connected to the cold water C

tap; the pipe marked H must be connected

to the hot water tap (max. temperature 60°C).

Both pipes may be connected to the cold water

tap using the special connection with multiple Y

attachments, supplied with the appliance (see

figure). Before making the connection, allow the

water to run freely until it is perfectly clear.

2. Connect the inlet

hose to the machine

by screwing it onto

the cold water inlet of

the appliance, which

is situated on the top

right-hand side of the

rear part of the ap-

pliance . (see figure)

3. Make sure there are no kinks or bends in

the hose.

! The water pressure at the tap must be within

the values indicated in the Technical details

table (on the page 5).

! If the water inlet hose is not long enough,

contact a specialist store or an authorised

serviceman.

! Ensure that the supply taps are allowing wa-

ter through. Old taps may seize in the closed

position and thus prevent water reaching the

machine.

! Never use second-hand or old inlet hoses;

use the products supplied with the machine.

! Keep this instruction manual in a safe place

for future reference. Should the appliance be

sold, transferred or moved, make sure the

instruction manual accompanies the washing

machine to inform the new owner as to its

operation and features.

! Read these instructions carefully: they contain

vital information on installation, use and safety.

Unpacking and levelling

Unpacking

! This is a separate

part of the polystyre-

ne base and should

be removed with the

base.

! IMPORTANT check

when unpacking

your machine.

1. Unpack the washing machine.

2. Check whether the washing machine has

been damaged during transport. If this is the

case, do not install it and contact your retailer.

3. Remove the 4

protective screws and

the rubber bush with

the respective spacer,

situated on the rear of

the appliance (see also

the installation leaflet).

4. Seal the gaps

using the plastic plugs

provided.

5. Keep all the parts:

you will need them again if the washing machine

needs to be moved to another location.

! Packaging materials are not children’s toys.

Levelling

Your machine may make a considerable

amount of noise if the two front feet have not

been adjusted correctly.

1. Install the washing

machine on a flat sturdy

floor, without resting it up

against walls, cabinets or

anything else.

2. If the floor is not per-

fectly level, compensate

for any unevenness by

tightening or loosening

the adjustable front feet

(see figure); the angle of

Connecting the drain hose

Connect the drain

hose, without ben-

ding it, to a draining

duct or a wall drain

situated between 65

and 100 cm from the

floor;

The drain hose may

be connected to

an under-sink trap.

Before connecting

the drain hose from

the machine ensure

that any blanks or

removable ends have

been taken off the

spigot.

If it is placed over

the edge of a basin

or sink be sure the

free end of the hose

should not be under-

water.

! We advise against the use of hose extensions;

in case of absolute need, the extension must

have the same diameter as the original hose

and must not exceed 150 cm in length.

Ensure that if the drain hose is pushed into

a standpipe, that the end does not go down

more than 15cms (6 inches). If the hose is pu-

shed down too far, this may cause the machine

to self -syphon ie. continuously empty as it is

filling.

Electric connection

Before plugging the appliance into the mains

socket, make sure that:

• the socket is earthed and in compliance with

the applicable law;

• the socket is able to sustain the appliance’s

maximum power load indicated on the Tech-

nical Data Plate fixed on the machine;

• the supply voltage is included within the

values indicated on the Technical Data Plate

fixed on the machine.

• the socket is compatible with the washer-

dryer’s plug. If this is not the case, replace

the socket or the plug.

Your appliance is now supplied with a 13 amp

fused plug it can be plugged into a 13 amp

socket for immediate use. Before using the

appliance please read the instructions below.

WARNING - THIS APPLIANCE MUST BE

EARTHED.

THE FOLLOWING OPERATIONS SHOULD

BE CARRIED OUT BY A QUALIFIED ELECTRI-

CIAN.

Replacing the fuse:

When replacing a faulty fuse, a 13 amp ASTA

approved fuse to BS 1362 should always be

used, and the fuse cover re-fitted. If the fuse

cover is lost, the plug must not be used until a

replacement is obtained.

Replacement fuse covers:

If a replacement fuse cover is fitted, it must be

of the correct colour as indicated by the colou-

red marking or the colour that is embossed in

words on the base of the plug. Replacements

can be obtained directly from your nearest

Service Depot.

Removing the plug:

If your appliance has a non-rewireable moul-

ded plug and you should wish to re-route the

mains cable through partitions, units etc.,

please ensure that either:

the plug is replaced by a fused 13 ampere

rewireable plug bearing the BSI mark of ap-

proval.

or:

the mains cable is wired directly into a 13

amp cable outlet, controlled by a switch, (in

compliance with BS 5733) which is accessible

without moving the appliance.

Disposing of the plug:

Ensure that before disposing of the plug itself,

you make the pins unusable so that it cannot

be accidentally inserted into a socket.

Instructions for connecting cable to an alternati-

ve plug:

Important: the wires in the mains lead are co-

loured in accordance with the following code:

Green & Yellow Earth

Blue Neutral

Brown Live

65 - 100 cm

Where it connects to

the waste water pipe

cut end off spigot or

remove the blanking cap

Product specificaties

Merk:	Hotpoint-Ariston
Categorie:	Wasmachine
Model:	SWD107617C

Heb je hulp nodig?

Als je hulp nodig hebt met Hotpoint-Ariston SWD107617C stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Wasmachine Hotpoint-Ariston

Hotpoint-Ariston ac 128 l Handleiding

1 April 2023

Hotpoint-Ariston aq 8 l 49 u Handleiding

1 April 2023

Hotpoint-Ariston AQ102F 49H EU AQUALTIS Handleiding

1 April 2023

Hotpoint-Ariston al 109 sl Handleiding

1 April 2023

Hotpoint-Ariston aq9d69uv Handleiding

1 April 2023

Hotpoint-Ariston WMG 722B EU Handleiding

18 Juni 2023

Hotpoint-Ariston SWD107617C Handleiding

16 Juni 2023

Hotpoint-Ariston aqgl 129 Handleiding

1 April 2023

Hotpoint-Ariston aq9d49uh va Handleiding

1 April 2023

Hotpoint-Ariston ARTL 82 (EU) Handleiding

2 Juni 2023

Handleiding Wasmachine

Nieuwste handleidingen voor Wasmachine

Whirlpool FFB 108 SILVER IT Handleiding

2 November 2024

Whirlpool W6 88 SILENCE PL Handleiding

2 November 2024

Whirlpool TDLR6253BFR Handleiding

2 November 2024

Whirlpool FFS 9269 SB Handleiding

2 November 2024

Whirlpool FFSP 9269 W FR Handleiding

2 November 2024

Whirlpool MMFFD 9489 BSV PL Handleiding

2 November 2024

Whirlpool TDLR55140SFR Handleiding

2 November 2024

Candy CTT 148W-OMKW Handleiding

2 November 2024

Candy CTT 127W-OMKW Handleiding

2 November 2024

Candy CTT 95W- OMKW Handleiding

2 November 2024