Hotpoint-Ariston AQM8F 49 U EU Handleiding

Hotpoint-Ariston Wasmachine AQM8F 49 U EU

Lees hieronder de đź“– handleiding in het Nederlandse voor Hotpoint-Ariston AQM8F 49 U EU (48 pagina's) in de categorie Wasmachine. Deze handleiding was nuttig voor 31 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/48
EN
1
English,1 Contents
Installation, 2-3
Unpacking and levelling
Connecting the electricity and water supplies
Technical data
Description of the machine, 4-5
Control panel
How to run a wash cycle or a drying
cycle, 6
Wash cycles and options, 7
Table of wash cycles
Wash options
Detergents and laundry, 8
Detergent
Preparing the laundry
Washing recommendations
Load balancing system
Precautions and advice, 9
General safety
Disposal
Opening the porthole door manually
Care and maintenance, 10
Cutting off the water and electricity supplies
Cleaning the machine
Cleaning the detergent dispenser drawer
Caring for your appliance drum
Cleaning the pump
Checking the water inlet hose
Trouble shooting, 11
Assistance, 12
EN
WASHER-DRYER
AQUALTIS
AQM8F 49 U
Instructions for
installation and use
ES
Español,13 Nederlands,25
NL
! This symbol reminds you to read this instruction manual.
I
Italiano,37
EN
2
Installation
! This instruction manual should be kept in a safe place for
future reference. If the washer-dryer is sold, given away or
moved, please ensure the manual is kept with the machine,
so that the new owner may benefit from the advice
contained within it.
! Read these instructions carefully: they contain vital
information relating to the safe installation and operation of
the appliance.
! Inside the pack containing this manual, you will also find
the guarantee and all the details necessary for installation.
Unpacking and levelling
Unpacking
1. Once you have removed all the packaging from the
washer-dryer, make sure it has not been damaged during
transportation.
If it has been damaged, contact the retailer and do not
proceed any further with the installation process.
2. Remove the 4 protective
screws (used during
transportation) and the
corresponding spacer,
located on the rear part of
the appliance ( ). see figure
3. Close off the holes using the plastic plugs supplied in the
pack.
4. Keep all the parts in a safe place; they will be needed
again if the washer-dryer is moved to another location, to
prevent the inside of the appliance being damaged.
! Packaging materials should not be used as toys for
children.
Levelling
1. Place the washer-dryer on a flat sturdy floor, without
resting it up against walls or cabinets.
2. If the floor is uneven, the
front feet of the machine
may be adjusted until
it reaches a horizontal
position (the angle of
inclination must not exceed
2 degrees).
! If the appliance is levelled correctly, it will be more stable
and much less likely to cause vibrations and noise while it
is operating, particularly during the spin cycle.
! If it is placed on carpet or a rug, adjust the feet in such a
way as to allow a sufficient ventilation space underneath
the washer-dryer.
Connecting the electricity and water
supplies
Connecting the water inlet hose
! Before connecting the inlet hose to the water supply, run
the water until it is perfectly clear.
1. Connect the inlet hose
to the machine by screwing
it onto the cold water inlet
of the appliance, which is
situated on the top right-
hand side of the rear part of
the appliance . (see figure)
2. Connect the inlet hose
by screwing it to a cold
water tab using a 3/4 gas
threaded connection (see
figure).
3. Make sure that the hose is not folded over or bent.
! The water pressure at the tap must fall within the values
indicated in the Technical data table (see next page).
! If the inlet hose is not long enough, contact a specialised
shop or an authorised technician.
! Never use second-hand or old inlet hoses; use the
products supplied with the machine.
EN
3
65 - 100 cm
Connecting the drain hose
Connect the drain hose to
drain duct piping or a wall
drain located between 65
and 100 cm above the floor,
making sure it is not bent
at all.
Alternatively, rest the
drain hose on the side of
a washbasin or bathtub,
fastening the duct supplied
to the tap (see figure).
The free end of the hose
should not be underwater.
! We advise against the use of hose extensions; if it is
absolutely necessary, the extension must have the same
diameter as the original hose and must not exceed 150 cm
in length.
Electrical connections
Before plugging the appliance into the electricity socket,
make sure that:
• the socket is earthed and complies with all applicable
laws;
• the socket is able to withstand the maximum power load
of the appliance as indicated in the Technical data table
(see opposite);
• the power supply voltage falls within the values indicated
in the Technical data table (see opposite);
• the socket is compatible with the plug of the appliance.
If this is not the case, have the socket or the plug
replaced.
! The machine must not be installed outdoors, even in
covered areas. It is extremely dangerous to leave the
appliance exposed to rain, storms and other weather
conditions.
! The mains socket must remain within easy reach after the
washer-dryer has been installed.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable and plug must only be replaced
by authorised technicians.
Warning! The company shall not be held responsible in the
event that these regulations are not respected.
Technical data
Model AQM8F 49 U
Dimensions
width 59.5 cm
height 85 cm
depth 64.5 cm
Capacity from 1 to 8 kg for the wash programme
from 1 to 6 kg for the drying programme
Electrical
connections
please refer to the technical data plate
fixed to the machine
Water connections
maximum pressure 1 MPa (10 bar)
minimum pressure 0.05 MPa (0.5 bar)
drum capacity 62 litres
Spin speed up to 1400 rotations per minute
Energy rated
programmes
according to
regulation
EN 50229
Wash: programme ; temperature 60°C;
using a load of 8 kg.
Drying: the smaller load must be dried by
selecting the “L1” dryness level. The load
must consist of 2 sheets, 1 pillowcase and
1 hand towel;
the remainder of the load must be dried by
selecting the “L4” dryness level.
This appliance conforms to the following
EC Directives:
- 2004/108/EC (Electromagnetic Compatibility)
- 2006/95/EC (Low Voltage)
- 2002/96/EC

Product specificaties

Merk: Hotpoint-Ariston
Categorie: Wasmachine
Model: AQM8F 49 U EU

Heb je hulp nodig?

Als je hulp nodig hebt met Hotpoint-Ariston AQM8F 49 U EU stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Wasmachine Hotpoint-Ariston

Hotpoint-Ariston

Hotpoint-Ariston ac 128 l Handleiding

1 April 2023
Hotpoint-Ariston

Hotpoint-Ariston aq 8 l 49 u Handleiding

1 April 2023
Hotpoint-Ariston

Hotpoint-Ariston AQ102F 49H EU AQUALTIS Handleiding

1 April 2023
Hotpoint-Ariston

Hotpoint-Ariston al 109 sl Handleiding

1 April 2023
Hotpoint-Ariston

Hotpoint-Ariston aq9d69uv Handleiding

1 April 2023
Hotpoint-Ariston

Hotpoint-Ariston WMG 722B EU Handleiding

18 Juni 2023
Hotpoint-Ariston

Hotpoint-Ariston SWD107617C Handleiding

16 Juni 2023
Hotpoint-Ariston

Hotpoint-Ariston aqgl 129 Handleiding

1 April 2023
Hotpoint-Ariston

Hotpoint-Ariston aq9d49uh va Handleiding

1 April 2023
Hotpoint-Ariston

Hotpoint-Ariston ARTL 82 (EU) Handleiding

2 Juni 2023

Handleiding Wasmachine

Nieuwste handleidingen voor Wasmachine

Bosch

Bosch WGB256040 Handleiding

23 November 2024
Bosch

Bosch WNG24400IT Handleiding

23 November 2024
Bosch

Bosch WAN28094 Handleiding

23 November 2024
Electrolux

Electrolux EW7T3722AF Handleiding

23 November 2024
Bosch

Bosch WGG244120 Handleiding

23 November 2024
Bosch

Bosch WNG24441 Handleiding

23 November 2024
Bosch

Bosch WGB254A0IT Handleiding

23 November 2024
Bosch

Bosch WGG142Z6IT Handleiding

23 November 2024
Bosch

Bosch WGG142Z8IT Handleiding

23 November 2024
Bosch

Bosch WGG254Z7IT Handleiding

23 November 2024