Hoover HDO725 W Handleiding

Hoover Oven HDO725 W

Lees hieronder de 📖 handleiding in het Nederlandse voor Hoover HDO725 W (16 pagina's) in de categorie Oven. Deze handleiding was nuttig voor 25 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/16
INSTRUCTIONS FOR USE
INSTALLATION
ELECTRICAL CONNECTION
BEFORE USING THE OVEN
SAFEGUARDING THE ENVIRONMENT
PRECAUTIONS AND GENERAL RECOMMENDATIONS
OVEN ACCESSORIES
CARE AND CLEANING
TROUBLE-SHOOTING GUIDE
AFTER SALES SERVICE
DECLARATION OF CONFORMITY CE
CONTROL PANEL
ELECTRONIC PROGRAMMER
OVEN FUNCTIONS
Technical information for the installer
The oven has been designed to be installed under a worktop surface.
Do not lift the oven by the handle, but hold it by the sides.
Make sure that the appliance was not damaged during transport.
The oven and unit dimensions are shown in the below figures.
The units in contact with the oven must be heat-resistant (min. 85°C).
If the plastic laminates or the sealing material are not sufficiently heat resistant, this may result in the formation
of bubbles, deformation of the surface or detachment of the coating.
Insert the oven in the unit cavity, lifting it by the sides and being careful not to trap the power cable.
The oven and housing dimensions are illustrated in the below figures.
For correct ventilation, follow the ventilation opening directions shown in the figure 1.
Two systems can be used to fit your appliance to a chosen furniture layout:
A. Between two side panels of two distinct cabinet units without the aid of a support shelf, by fitting four support
steel brackets provided with the product. (fig. 3).
B. Between two side panels each fixed to the side of a cabinet unit without the aid of a support shelf. In this case
only the two lower support brackets will be necessary (fig. 4).
Note: In both of the above cases you must measure 717 mm from the underside of the worktop and mark the correct
position of the lower support brackets before fixing them to the sides. With reference to (fig. 3), ensure the side
support brackets are positioned 40 mm from the front of the cabinet door exterior surface, as illustrated, before
securing them to the cabinet sides. If necessary, this product can be installed in a housing unit (fig. 2). The housing
unit will not be a standard one but will have to be of a size that can accommodate the full height of the oven -
minimum height 717 mm. This housing unit will need to fulfil the ventilation requirements.
Fasten the oven using the screws.
Fig. 1 Fig. 2
Fig. 3 Fig. 4
NOTE:
3
INSTALLATION


Product specificaties

Merk: Hoover
Categorie: Oven
Model: HDO725 W

Heb je hulp nodig?

Als je hulp nodig hebt met Hoover HDO725 W stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Oven Hoover

Handleiding Oven

Nieuwste handleidingen voor Oven