Hooker 5198-30310 Handleiding

Hooker Bureaustoel 5198-30310

Lees hieronder de 📖 handleiding in het Nederlandse voor Hooker 5198-30310 (2 pagina's) in de categorie Bureaustoel. Deze handleiding was nuttig voor 32 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
1/2
ASSEMBLY INSTRUCTION
Item#:5198-30310 desk chair (one per carton)
** Please make sure you have all parts indicated below prior to assembly.
Assembly Steps:
1. Place back frame (E) on a clean surface.
2. Tighten seat frame(F) to back legs of frame(E) by using bolt(G), lock washer(B) and flat washer(A)
at the center location (see diagram 2). Using bolts (C), lock washers (B) and flat washers (A),
tighten the corners of seat frame (F) to back legs of frame (E). (See diagram 1)
3. Install front legs (H) onto seat frame (F) using bolts (G), lock washers (B) and flat washers (A).
Tighten all bolts by hand. (See diagram 2)
4. After all bolts are attached and hand tightened, turn the chair upright.
5. Level the chair following the “chair leveling instruction” as below.
6. Make sure the chair is level and then tighten all bolts completely by using the allen wrench (D).
DIAGRAM 1
DIAGRAM 2
2/2
PLEASE READ THESE INSTRUCTIONS PRIOR TO ASSEMBLING THE
CHAIRS
CHAIR LEVELING INSTRUCTION SUPPLEMENT
Chair leveling procedures:
To make the assembly process easy and efficient, please read the entire instruction sheet prior to
assembling of the chair. Make sure all hardware listed is included. To properly assemble the chair, none of
the bolts should be fully tightened until all components are attached to the chair. This will allow an
opportunity to level the chair and prevent any unnecessary “rocking”.
1. Place the loosely assembled chair on a hard flat surface.
2. Apply gentle downward pressure on the seat. This step eliminates rocking and ensures the chair to
be level.
3. Once the chair is level, tighten all bolts and nuts.
Note:
Most floors have slight irregularities that can affect chair leveling. If your chair is uneven when placed
in its desired location, perform the following steps:
1. Loosen front legs to finger tight.
2. Extend both front legs upward to their fullest length.
3. Gently push downward on the front edge of the seat until all four legs rest on the floor.
4. Re-tighten all bolts and nuts.
Cleaning Instruction: Clean finished parts with a damp cloth using a mild dishwashing liquid and water solution.
Polish the finish with soft cloth and an industry recognized furniture polish.


Product specificaties

Merk: Hooker
Categorie: Bureaustoel
Model: 5198-30310

Heb je hulp nodig?

Als je hulp nodig hebt met Hooker 5198-30310 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Bureaustoel Hooker

Handleiding Bureaustoel

Nieuwste handleidingen voor Bureaustoel