Honeywell HZ-980 Handleiding

Honeywell Heater HZ-980

Lees hieronder de πŸ“– handleiding in het Nederlandse voor Honeywell HZ-980 (24 pagina's) in de categorie Heater. Deze handleiding was nuttig voor 15 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/24
IMPORTANT SAFETY
INSTRUCTIONS
WARNING – READ AND SAVE THESE
OPERATING AND SAFETY INSTRUCTIONS
BEFORE USING THIS HEATER. IF YOU DO
NOT UNDERSTAND THESE INSTRUCTIONS OR
PRODUCT LABELS PLEASE CALL
OUR CUSTOMER REPRESENTATIVES AT
(800) 477-0457 FOR ASSISTANCE BEFORE
USING THIS PRODUCT.
Warning – Failure to follow any of these safety
instructions could result in fire, injury or death.
YOUR RESPONSIBILITIES
Electrical appliances may expose people to
hazards that can cause severe injury as well
as death. The use of electrical products may
create hazards that include, but are not limited
to, injury, fire, electrical shock and electrical
system damage. These instructions are intended
to provide you with the information you need to
use the product and to avoid such hazards.
When using electrical appliances, basic
precautions should always be followed to
reduce risk of fire, electric shock, and injury to
persons including the following:
1. Warning – Read all instructions before using
this heater.
2. Warning – This heater is hot when in use.
To avoid burns, do not let bare skin touch
hot surfaces. Use handles when moving this
heater. Keep combustible materials, such as
furniture, pillows, bedding, papers, clothes,
and curtains at least 3 feet (0.9 m) from the
front of the heater and keep them away from
the sides and rear.
3. Warning – Extreme caution is necessary
when any heater is used by or near children
or invalids, and whenever the heater is left
operating and unattended.
4. Warning – Always unplug heater when not
in use.
5. Warning – Do not operate any heater with
a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged
in any manner. Discard heater or return
heater to authorized service facility for
examination and/or repair.
6. Warning – For residential use only.
7. Warning – Do not use outdoors.
8. Warning – This heater is not intended for
use in bathrooms, laundry areas and similar
indoor locations. Never locate heater where
it may fall into a bathtub or other water
container.
9. Warning – Do not run cord under carpeting.
Do not cover cord with throw rugs, runners,
or similar coverings. Do not route cord
under furniture or appliances. Arrange cord
away from traffic area and where it will not
be tripped over.
I Hnfrared eater
M HZ-960 S odel erIeS
M HZ-970 S odel erIeS
M HZ-980 Sodel erIeS
The Honeywell Trademark is used by Kaz USA, Inc. under license from Honeywell International Inc.
Honeywell International Inc. makes no representation or warranties with respect to this product.
2
IMPORTANT SAFETY INSTRUCTIONS REGARDING THE PLUG ON YOUR PRODUCT
10. Warning – This heater is for use on 120
volts. The cord has a plug as shown in Fig.
1, and an adapter, as shown, is available
for connecting three-blade grounding-type
plugs to two-slot receptacles. The green
grounding lug extending from the adapter
must be connected to a permanent ground
such as a properly grounded outlet box.
The adapter should not be used if a three-
slot grounded receptacle is available. Do
not circumvent the safety features of the
grounding-type plug. Do not modify the
power cord.
11. Warning – This heater draws 12.5 amps
during operation. To prevent overloading a
circuit, do not plug the heater into a circuit
that already has other appliances working.
12. Warning – It is normal for the plug to feel
warm to the touch; however, a loose fit
between the AC outlet (receptacle) and plug
may cause overheating and distortion of
the plug. Contact a qualified electrician to
replace loose or worn outlet.
13. Warning – To disconnect the heater, first
turn off the product, then grip the plug body
and pull it from the wall outlet. Never pull by
the cord.
14. Warning – Do not insert or allow foreign
objects to enter any ventilation or exhaust
opening as this may cause an electric shock
or fire, or damage the heater.
15. Warning – To prevent a possible fire, do not
block air intakes or exhaust in any manner.
Do not use on soft surfaces, like a bed, or
where openings may become blocked.
16. Warning – A heater has hot and arcing or
sparking parts inside. Do not use it in areas
where gasoline, paint or flammable liquids
are used or stored.
17. Warning – Use this heater only as described
in this manual. Any other use not
recommended by the manufacturer may
cause fire, electric shock, or injury to persons.
18. Warning – Always plug heater directly into
a wall outlet/receptacle. Never use with an
extension cord or relocatable power tap
(outlet/power strip).
19. Warning – Never tamper with this product
or attempt to fix it. Any tampering with, or
modification of this product can result in
serious injury, death, or fire. Risk of electric
shock. Do not open. No user serviceable
parts inside.
20. Warning – Do not remove product labels
that contain warnings or safety instruction.
21. Caution – The output of this heater may vary
and its temperature may become intense
enough to burn exposed skin. Use of this
heater is not recommended for persons with
reduced sensitivity to heat or an inability to
react to avoid burns.
22. Caution – Before cleaning, or storage, or
when not in use, turn the product’s controls
to the OFF position and unplug the heater
from the electrical outlet and allow to cool.
23. Caution – Place the heater on a firm, level,
open surface free from obstructions and
at least 3 feet (0.9 m) away from any
combustible materials. DO NOT use on an
unstable surface such as bedding or deep
carpeting. Be sure the heater is not in a
position where it may be tripped over by
small children or pets.
24. Caution – If your home has aluminum
wiring have a licensed electrician check
your receptacle’s connections. When
using a 1500 watt heater, aluminum wire
connections can cause a safety issue.
25. SAVE THESE
INSTRUCTIONS
Product Specifications
This product is rated 12.5 Amps (1500 Watts) at
120 VAC, 60 Hz.
Fig. 1
3
ABOUT INFRARED TECHNOLOGY
SET UP
GETTING STARTED
MOVING THE HEATER
β€’ Infrared energy is light within the spectrum that cannot be seen but can be detected by heat.
β€’ Infrared heaters use quartz lamps to generate such spectrum of light. In the Honeywell Infrared Heater, six long-lasting quartz
elements heat the inner metal chamber. Air is drawn into the back of the heater by a fan, it passes through the warmed copper
reξ€Ÿectors and out the front of the heater to gently introduce soothing, warm air into the room.
β€’ This type of heating technology provides comfortable, eξ€žcient and even heating. It is designed with fan power to improve
convection in order to provide core comfort to you and in extra large spaces.
β€’ The Honeywell Infrared Heater requires no assembly. Simply unpack the heater and save all packaging materials for o-season
storage.
β€’ Place the heater on a ξ€œrm, level, open surface free from obstructions and at least 3 feet (0.9m) away from any wall or
combustible material.
β€’ use on an unstable surface such as bedding or deep carpeting.DO NOT
β€’ BE SURE THE HEATER IS NOT IN A POSITION WHERE IT MAY BE TRIPPED OVER BY CHILDREN OR PETS.
Register your heater online and extend your warranty by six additional months.
Log on to www.honeywellheatsavings.com/registration/ and simply ξ€œll out the registration form to register your product.
β€’ This heater is equipped with a large Cool Touch handle and easy glide caster wheels for your convenience.
β€’ To move, turn the heater o.
β€’ Allow it to cool for ten minutes.
β€’ Unplug heater and simply lift by the handle or roll to move.
β€’ NOTE: NEVER LEAVE AN OPERATING UNIT UNATTENDED
β€’ Plug the heater into a 3 prong or grounded 120V outlet. DO NOT FORCE THE 3 PRONG PLUG INTO THE OUTLET;
it will only ξ€œt one way.
β€’ The Honeywell Infrared Heater is versatile and designed to be placed in the center of the room or closer to the wall (at least 3
feet way) for maximum safe and eξ€žcient room heating.
OPERATION
REMOTE CONTROL
The Honeywell Infrared Heater can be controlled with the remote. This remote uses a button cell type battery which comes
included in the remote.
β€’ To activate the battery, simply pull the plastic tab.
β€’ Place remote control in the holder under the handle of the heater when not in use.

Product specificaties

Merk: Honeywell
Categorie: Heater
Model: HZ-980

Heb je hulp nodig?

Als je hulp nodig hebt met Honeywell HZ-980 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Heater Honeywell

Honeywell

Honeywell VersaHeat HHF260 Handleiding

18 December 2023
Honeywell

Honeywell EnergySmart HZ-7300 Handleiding

21 November 2023
Honeywell

Honeywell Thermawave 6 HCE870 Handleiding

8 November 2023
Honeywell

Honeywell Thermawave 6 HCE870C Handleiding

8 November 2023
Honeywell

Honeywell HHF175 Handleiding

8 November 2023
Honeywell

Honeywell ComfortTemp 4 HCE640 Handleiding

8 November 2023
Honeywell

Honeywell ComfortTemp 4 HCE645 Handleiding

8 November 2023
Honeywell

Honeywell Home Comfort+ HR30 Handleiding

26 Oktober 2023
Honeywell

Honeywell HWLHHF360VV2 Handleiding

8 Augustus 2023
Honeywell

Honeywell EnergySmart HZ-970 Handleiding

7 Juni 2023

Handleiding Heater

Nieuwste handleidingen voor Heater

Omega Altise

Omega Altise OABRFLPSD Handleiding

20 November 2024
Reer

Reer Viera TX-49FSW504 Handleiding

19 November 2024
Sonnenkonig

Sonnenkonig OFR5A Mini Handleiding

19 November 2024
Yamazen

Yamazen DC-X071 Handleiding

19 November 2024
Yamazen

Yamazen YDH-M10 Handleiding

19 November 2024
Cecotec

Cecotec ReadyWarm 1800 Thermal Connected Handleiding

19 November 2024
Cecotec

Cecotec ReadyWarm 1500 Max Ceramic Handleiding

18 November 2024
Cecotec

Cecotec ReadyWarm 2500 Thermal Connected Handleiding

18 November 2024
Yamazen

Yamazen DBC-L0952 Handleiding

18 November 2024
Yamazen

Yamazen HF-D12 Handleiding

18 November 2024