Honeywell COB02 Handleiding

Honeywell Niet gecategoriseerd COB02

Lees hieronder de 📖 handleiding in het Nederlandse voor Honeywell COB02 (9 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 206 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/9

Charge-Only Base

COB02

Installation Guide

Rev B

9/15

Introduction

Honeywell’s Charge-Only Base can fully charge an industrial

wireless area-imaging scanner in 5 hours, maximizing uptime in any

application.

Note: When a scanner is placed into the Charge-Only Base, the

battery will charge. Please note that the Charge-Only Base

will not facilitate communication with the host system or other

scanners.

Installation

Connect the power adapter to the Charge-Only Base, then plug the

power supply into an AC power outlet. Make sure the AC power

outlet voltage is the same as the power supply.

Use only a Listed Limited Power Source (LPS) or Class 2 type

power supply with output rated 5 to 5.2Vdc, 1A. We recommend

use of Honeywell power adapters. Use of any non-Honeywell

power adapters may cause damage not covered by the

warranty.

Mounting a COB02 Base

The COB02 Base can be mounted on either a horizontal or vertical

surface. The cable can be routed through either the top or the bottom

of the base.

The cable can be routed down through the bottom of the base,

securing the cable in the wireway.

The cable can also be routed up through the top of the base, but must

be crossed over and secured in the wireway.

When routing the cable up through the top of the base, be sure to

cross the cable over before placing in the wireway. If not, too much

strain is placed on the cable connector.

Product specificaties

Merk:	Honeywell
Categorie:	Niet gecategoriseerd
Model:	COB02
Kleur van het product:	Grey, Orange
Materiaal:	Kunststof
Aantal per verpakking:	1 stuk(s)
Compatibiliteit:	Granit 191Xi
Type product:	Houder
Code geharmoniseerd systeem (HS):	84733020