Hitec LASER_6 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Hitec LASER_6 (4 pagina's) in de categorie Radio controll. Deze handleiding was nuttig voor 38 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
www.hitecrcd.com
www.hitecrcd.com
Austria, Belgium, Denmark, Finland,
France, Germany, Greece, Iceland,
Ireland, The Netherland, Italy, Spain,
Norway, Portugal, United Kingdom,
Luxembourg, Sweden, Switzerland
LASER 4&6
8
SYSTEM INTRODUCTION MANUAL
LASER 4&6 SYSTEM INTRODUCTION MANUAL
Madein Philippines
ATV
CH1 CH2
Digital Proportional FM Radio Control System
FM
V-tailMixing
ElevonMixing
LowBatteryAlarm
5. Product Service Information ( for USA & Canada only )
In the event you would require service to your radios, please send the parts to ::
Hitec RCD USA, Inc. Service Department
12115 Paine St.
Poway, CA 92064
Please include your name address and telephone number along
with a brief description of the failure or the work that you are requesting to be done.
6. Precautions
- Always turn your transmitter on first and off last.
- Never operate your system without first performing a proper range check.
- FCC regulation in the USA prohibits changing the crystal in your transmitter.
For channel changes send your system to an authorized service/repair center.
- Never fly around or over houses, people or power lines.
- Always charge your batteries before you fly.
- It's a good idea to check your receiver batteries with a tester like the Hitec
Power Mate II (part# 44110). This will verify the charge level in your receiver batteries.
- Always fly responsibly and respect the rights of others.
- Make sure your frequency is clear before turning on your system.
Congratulations again and have fun!
SYSTEM
INTRODUCTION
MANUAL
Made in Philippines
ATV
CH1 CH2
Digital Proportional FM Radio Control System
FM
V-tailMixing
ElevonMixing
LowBattery Alarm
Made in Philippines
ATV EPA AT V
AIL ELEV THRO RUDD
FM
Digital Proportional FM Radio Control System
ELEV
D/R
AIL
D/R
V-tail Mixing
ElevonM
ixing
Ixoo
Fkdujh
Madein Philippines
ATV EPA ATV
AIL ELEV THRO RUDD
FM
Digital Proportional FM Radio Control System
ELEV
D/R
AIL
D/R
V-tailMixing
ElevonMixing
Ixoo
Fkdujh
LASER 4&6
3
LASER 4&6
2
LASER 4&6 SYSTEM INTRODUCTION MANUAL
LASER 4&6 SYSTEM INTRODUCTION MANUAL
3
3
5
5
4
4
6
6
7
7
8
8
1. Transmitter
a. Features
b. Layout
c. Specifications
d. Servo Reversing
e. Servo A.T.V. (Adjustable Travel Volume)
f. Mixing
g. Control Stick adjustment
h. Stick Lever tension adjustment
i. Trim levers
j. Dual Rates
k. Landing Gear Switch
l. CH. 3 Throttle E.P.A. (End Point Adjustment )
2. Battery Management
a. Transmitter and Receiver battery
b. Transmitter Batteries
3. Operation
a. Trainer system
b. Range checking
4. Replacement Parts & Accessories
5. Product Service Information
6. Precautions
sdjh
sdjh
sdjh
sdjh
sdjh
sdjh
Table of Contents
Introduction
Thank you for purchasing the Hitec Laser digital proportional radio control system.
The Laser is loaded with features, easy to use and utilizes the latest in solid-state components for
unsurpassed reliability and performance. It is important that you read and understand this manual
before you attempt to operate your system.
www.hitecrcd.com
SYSTEM INTRODUCTION MANUAL
System Specifications
1. Transmitter
A. Features( common for Laser 4 and Laser 6 )
- Ergonomically designed 4 or 6 channel FM transmitter.
- High quality precision gimbals with adjustable stick length and tension.
- Servo reversing on all channels.
- ATV (Adjustable Travel Volume) CH 1 and CH 2.
- V-tail and Elevon mixing.
- Trainer system.
- Premium 9.6v 600mA Nicad rechargeable battery pack.(Nicad version only)
- Neck strap attachment.
- Metal carrying handle.
~Feature only for Laser 4
- Easy to read 5 LED battery indicators.
- Low Battery Alarm
~
Feature only for Laser 6
- Transmitter battery voltage meter.
- EPA (End Point Adjustment) on CH 3.
- Dual rates on CH 1 Aileron and CH 2 Elevator
- ATV on CH 4
B. Layout (LASER 4 front)
1. Aileron/Elevator stick in MODE II
2. Throttle/Rudder stick in MODE II
3. Aileron trim
4. Elevator trim
5. Throttle trim
6. Rudder trim
7. Trainer ON-OFF switch
8. LED indicator
9. Power switch
10. Rod antenna
11. Neck-strap connector
12. Recharge Jack
13. Crystal
14. Handle
15. Aileron & elevator adjustable
travel volume(A.T.V)
16. Screw Driver
1
8
3
9
10
11
16
12
13
14
15
4
2
5
6
7
Made in Philippines
ATV
CH1 CH2
Digital Proportional FM Radio Control System
FM
V-tail Mixing
ElevonMixing
LowB
atteryAlarm
LASER 4&6
4
www.hitecrcd.com
SYSTEM INTRODUCTION MANUAL
LASER 4&6 SYSTEM INTRODUCTION MANUAL
LASER 4&6 SYSTEM INTRODUCTION MANUAL
LASER 4&6
5
E. Adjustable Travel Volume (A.T.V.)
- CH 1 & CH 2 for Laser 4&6, CH4 for only Laser 6.
- This function adjusts the servo overall travel on CH 1 and CH 2.
- The rate setting is adjustable from 30% to 110%.
F. Mixing
- The Laser series transmitters are equipped with a switch that will mix ch.2 & ch.4
for V-tail aircraft or ch.1 and ch.2 for Elevon, or common flying wing type aircraft.
G. Control Stick Adjustment
- The length of the non-slip control sticks can be adjusted to suit the requirements of the user.
H. Stick Lever Tension Adjustment
- The unique open-stick assembly provides fully adjustable stick tension to adjust
the "feel" of the sticks in your hands.
- You may adjust the stick tension of your sticks to provide the "feel" that you like
for flying. To adjust your springs, you'll have to remove the rear case of the
transmitter. Using a screwdriver, remove the six screws that hold the
transmitter's rear cover into position, and put them in a safe place. Gently ease
off the transmitter's rear cover and move it to the right side of the transmitter,
carefully turning it as you would turn the page of a book. Now you'll see the view
shown in the illustration. Using a small Philips screwdriver, rotate the adjusting
screw for each stick for the desired spring tension. The tension increases when
the adjusting screw is turned clockwise, and decreases for counterclockwise
motion. When you are satisfied with the spring tensions, you may close the transmitter.
Very carefully reinstall the rear cover. When the cover is properly in place, tighten the six screws.
C. Specifications
- Power supply : 9.6V (8 cell) Nicad battery or 12V 8cell Dry battery
- Current drain : 150mA
- Output power : 500mw
- Modulation : PPM (FM)
D. Servo Reversing
- The Laser 4/6 FM transmitter is equipped with servo reversing on all channels.
- Leaving the switch in the middle will cause the radio to work erratically so please
make sure the switches are all pushed to the furthest end.
Layout (LASER 6 front)
Made in Philippines
ATV
CH1 CH2
Digital Proportional FM Radio Control System
FM
Layout (LASER 4&6 back)
Layout (LASER 4&6 bottom)
1.Trainer Jack
2.Nicad-battery
1
Made in Philippines
ATV EPA AT V
AIL ELEV THRO RUDD
FM
Digital Proportional FM Radio Control System
2
1. Aileron/Elevator stick in MODE II
2. Throttle/Rudder stick in MODE II
3. Aileron trim
4. Elevator trim
5. Throttle trim
6. Rudder trim
7. Landing gear switch
8. Flap variable switch
9. Trainer ON-OFF switch
10. Voltage meter
11. Power switch
12. Rod antenna
13. Neck-strap connector
14. Recharge Jack
15. Crystal
16. Handle
17. Aileron & elevator and rudder
adjustable travel volume(A.T.V)
18. Throttle end point adjustment
high & low(E.P.A)
19. Screw Driver
20.Aileron & dual rate S/W
21.Elevator dual rate S/W
RII
QRU UHY
Y
0
WDLO HOHYRQ
QLFDG#SDFN
GU\#SDFN
[0WDO
VWRUDJH
FK7 FK6 FK5 FK4 PL[LQJ
VHUYR#UHYHUVH
RII
QRU UHY
Y
0
WDLO HOHYRQ
QLFDG#SDFN
GU\#SDFN
[0WDO
VWRUDJH
FK9 FK8 FK7 FK6 FK5 FK4 PL[LQJ
VHUYR#UHYHUVH
LASER 4
LASER 6
CH2 CH4 CH2 CH4
Up Elevator Left Rudder (view from rear)
V-Tail MIXING Elevon MIXING
CH1 CH2
Aileron Operation
Elevator Operation
AB
Made in Philippines
ATV EPA AT V
AIL ELEV THRO RUDD
FM
Digital Proportional FM Radio Control System
ELEV
D/R
AIL
D/R
V-tail Mixing
ElevonM
ixing
1
10
2
5
14
18
17
19
16
12
8
20
7
21
9
13
4
3
11
15
Ixoo
Fkdujh


Product specificaties

Merk: Hitec
Categorie: Radio controll
Model: LASER_6

Heb je hulp nodig?

Als je hulp nodig hebt met Hitec LASER_6 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden