Hikvision DS-QAE0420G1-V Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Hikvision DS-QAE0420G1-V (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 16 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
Appearance
1
Interface
2
Note
+ indicates a constant voltage of 100 V, - indicates COM.
This installation should be made by a qualified service person and should
conform to all the local codes.
Note
Caution
Warning
Refer to the device label for the standard power supply. Please make sure your
power supply matches with your device.
In the use of the product, you must be in strict compliance with the electrical
safety regulations of the nation and region.
CAUTION: If the fuse of the device can be replaced, replace it only with the
same model to reduce the risk of fire or electric shock.
CAUTION: If the device needs to be installed with a specific bracket of our
company, use the corresponding bracket only. Use others (such as carts, stands,
and carriers) may result in instability and cause injury. Refer to the device
datasheet for bracket model details. Refer to datasheet for details.
For the device with sound playing function, to prevent possible hearing
damage, do not listen at high volume levels for long periods. Refer to the user
manual for details.
Refer to the device label for the standard power supply. Please make sure your
power supply matches with your device.
Make sure that the power has been disconnected before you wire, install, or
disassemble the device.
To avoid heat accumulation, good ventilation is required for a proper operating
environment.
If smoke, odor, or noise arises from the device, immediately turn off the power,
unplug the power cable, and contact the service center.
If the product does not work properly, please contact your dealer or the
nearest service center. Never attempt to disassemble the product yourself. We
shall not assume any responsibility for problems caused by unauthorized repair or
maintenance.
For the battery with + and - signs, + identifies the positive terminals of the
device which is used with or generates direct current, and - identifies the negative
terminals of the device which is used with or generates direct current.
No naked flame sources, such as lighted candles, should be placed on the
equipment.
If the serial port of the device is used for debugging only, it is reserved only for
professionals or technical support for device maintenance. Refer to the document
for details.
Attach the device properly to the floor/wall in accordance with the installation
instructions to prevent injury. Refer to the document for details.
DO NOT drop the product or subject it to physical shock. Do not install the
product on vibratory surface or places.
DO NOT expose the device to high electromagnetic radiation.
DO NOT expose the device to extremely hot, cold, dusty, corrosive, saline-
alkali, or damp environments. For temperature and humidity requirements, refer
to the datasheet for details.
DO NOT install indoor product where it may get wet by water or other liquid.
To avoid fire hazard or electric shock, DO NOT expose the device to rain or
extremely damp environments.
Accessing to the Internet may cause network security problems. Please
strengthen the protection of your personal information and data security. When
you find that the device may have network security risks, please contact us in
time.
Proper configuration of all passwords and other security settings is the
responsibility of the installer and/or end-user.
Keep all wrappers after unpacking them for future use. In case of any failure
occurred, you need to return the device to the factory with the original wrapper.
Transportation without the original wrapper may result in damage on the device
and the company shall not take any responsibilities.
Column Speaker
Quick Start Guide
UD34437B
Note
The appearance varies with the models. The actual device prevails.
©2023 Hangzhou Hikvision Digital Technology Co., Ltd. All rights reserved.
About this Manual
The Manual includes instructions for using and managing the Product. Pictures,
charts, images and all other information hereinafter are for description and
explanation only. The information contained in the Manual is subject to change,
without notice, due to firmware updates or other reasons. Please find the latest
version of this Manual at the Hikvision website (https://www.hikvision.com/).
Please use this Manual with the guidance and assistance of professionals trained
in supporting the Product.
Trademarks
and other Hikvision’s trademarks and logos are the properties of
Hikvision invarious jurisdictions.
Other trademarks and logos mentioned are the properties of their respective
owners.
Disclaimer
TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THIS MANUAL AND
THE PRODUCT DESCRIBED, WITH ITS HARDWARE, SOFTWARE AND FIRMWARE,
ARE PROVIDED “AS IS” AND “WITH ALL FAULTS AND ERRORS”. HIKVISION MAKES
NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION,
MERCHANTABILITY, SATISFACTORY QUALITY, OR FITNESS FOR A PARTICULAR
PURPOSE. THE USE OF THE PRODUCT BY YOU IS AT YOUR OWN RISK. IN NO EVENT
WILL HIKVISION BE LIABLE TO YOU FOR ANY SPECIAL, CONSEQUENTIAL,
INCIDENTAL, OR INDIRECT DAMAGES, INCLUDING, AMONG OTHERS, DAMAGES
FOR LOSS OF BUSINESS PROFITS, BUSINESS INTERRUPTION, OR LOSS OF DATA,
CORRUPTION OF SYSTEMS, OR LOSS OF DOCUMENTATION, WHETHER BASED ON
BREACH OF CONTRACT, TORT (INCLUDING NEGLIGENCE), PRODUCT LIABILITY,
OR OTHERWISE, IN CONNECTION WITH THE USE OF THE PRODUCT, EVEN IF
HIKVISION HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES OR LOSS.
YOU ACKNOWLEDGE THAT THE NATURE OF THE INTERNET PROVIDES FOR
INHERENT SECURITY RISKS, AND HIKVISION SHALL NOT TAKE ANY
RESPONSIBILITIES FOR ABNORMAL OPERATION, PRIVACY LEAKAGE OR OTHER
DAMAGES RESULTING FROM CYBER-ATTACK, HACKER ATTACK, VIRUS INFECTION,
OR OTHER INTERNET SECURITY RISKS; HOWEVER, HIKVISION WILL PROVIDE
TIMELY TECHNICAL SUPPORT IF REQUIRED.
YOU AGREE TO USE THIS PRODUCT IN COMPLIANCE WITH ALL APPLICABLE LAWS,
AND YOU ARE SOLELY RESPONSIBLE FOR ENSURING THAT YOUR USE CONFORMS
TO THE APPLICABLE LAW. ESPECIALLY, YOU ARE RESPONSIBLE, FOR USING THIS
PRODUCT IN A MANNER THAT DOES NOT INFRINGE ON THE RIGHTS OF THIRD
PARTIES, INCLUDING WITHOUT LIMITATION, RIGHTS OF PUBLICITY, INTELLECTUAL
PROPERTY RIGHTS, OR DATA PROTECTION AND OTHER PRIVACY RIGHTS. YOU
SHALL NOT USE THIS PRODUCT FOR ANY PROHIBITED END-USES, INCLUDING THE
DEVELOPMENT OR PRODUCTION OF WEAPONS OF MASS DESTRUCTION, THE
DEVELOPMENT OR PRODUCTION OF CHEMICAL OR BIOLOGICAL WEAPONS, ANY
ACTIVITIES IN THE CONTEXT RELATED TO ANY NUCLEAR EXPLOSIVE OR UNSAFE
NUCLEAR FUEL-CYCLE, OR IN SUPPORT OF HUMAN RIGHTS ABUSES. IN THE EVENT
OF ANY CONFLICTS BETWEEN THIS MANUAL AND THE APPLICABLE LAW, THE
LATTER PREVAILS.
Audio in
161.9(6.37")
280(11.02")
119.8(4.72")
Complete wiring before installation. Refer to chapter 2 for wiring details.
Make sure all the related equipment is power-off during the installation.
Wall Mount
Vertical Pole Mount
Drill holes in the wall, and install the expansion bolts into the screw holes.
Fix the column speaker to the L-bracket with 2 screws.
1
1
2
2
3
3
3Installation
Fix the column speaker to the L-bracket with 2 screws.
Note
The wall must be a solid wall when you choose wall mounting, and the wall
thickness is recommended to be greater than 80 mm.
The recommended drilling distance is 237 mm.
Fix the L-bracket to the wall with 2 screws.
Note
Drill holes in the pole, and install the expansion bolts into the screw holes.
The recommended drilling distance is 237 mm.
Fix the L-bracket to the pole with 2 screws.
Note
These clauses apply only to the products bearing the corresponding
mark or information.
EU/UK Compliance Statement
This product and - if applicable - the supplied accessories too are
marked with "CE" and comply therefore with the applicable
harmonized European standards listed under the Directive
2014/30/EU (EMCD) and Directive 2011/65/EU (RoHS).
Note: The products with the input voltage of within 50 to 1000 VAC or 75
to 1500 VDC comply with Directive 2014/35/EU (LVD), and the rest
products comply with Directive 2001/95/EC (GPSD). Please check the
specific power supply information for reference.
The full text of the EU declaration of conformity is available at the
following internet address: https://www.hikvision.com/en/support/
compliance/declaration-of-conformity.
This product and - if applicable - the supplied accessories too are
marked with "UKCA" and comply therefore with the following
directives: Electromagnetic Compatibility Regulations 2016,
Electrical Equipment (Safety) Regulations 2016, the Restriction of
the Use of Certain Hazardous Substances in Electrical and Electronic
Equipment Regulations 2012.
Directive 2012/19/EU (WEEE Directive): Products marked with this
symbol cannot be disposed of as unsorted municipal waste in the
European Union. For proper recycling, return this product to your
local supplier upon the purchase of equivalent new equipment, or
dispose of it at designated collection points. For more information see:
www.recyclethis.info.
According to the Waste Electrical and Electronic Equipment Regulations
2013: Products marked with this symbol cannot be disposed of as
unsorted municipal waste in the United Kingdom. For proper recycling,
return this product to your local supplier upon the purchase of equivalent
new equipment, or dispose of it at designated collection points. For more
information see: www.recyclethis.info.
Directive 2006/66/EC and its amendment 2013/56/EU (Battery
Directive): This product contains a battery that cannot be disposed
of as unsorted municipal waste in the European Union. See the
product documentation for specific battery information. The
battery is marked with this symbol, which may include lettering to
indicate cadmium (Cd), lead (Pb), or mercury (Hg). For proper recycling,
return the battery to your supplier or to a designated collection point. For
more information see: www.recyclethis.info.
According to the Batteries and Accumulators (Placing on the Market)
Regulations 2008 and the Waste Batteries and Accumulators Regulations
2009: This product contains a battery that cannot be disposed of as
unsorted municipal waste in the United Kingdom. See the product
documentation for specific battery information. The battery is marked
with this symbol, which may include lettering to indicate cadmium (Cd),
lead (Pb), or mercury (Hg). For proper recycling, return the battery to your
supplier or to a designated collection point. For more information see:
www.recyclethis.info.
Industry Canada ICES-003 Compliance
This device meets the CAN ICES-003 (B) / NMB-003 (B) standards
requirements.
Conformité Industrie Canada ICES-003
Cette appareil répond aux exigences des normes CAN ICES-003 (B) /
NMB-003 (B).
KC
B급 기기: 이 기기는 가정용(B급) 전자파적합기기로써 주로 가정에서
사용하는 것을 목적으로 하며, 모든 지역에서 사용할 수 있습니다.
3
2
Recommended
Drilling Distance:
237 mm
Wall
L-Bracket
Screw
Screw
1
3
2
1
Recommended
Drilling Distance:
237 mm
Pole
L-BracketScrew
Screw


Product specificaties

Merk: Hikvision
Categorie: Niet gecategoriseerd
Model: DS-QAE0420G1-V

Heb je hulp nodig?

Als je hulp nodig hebt met Hikvision DS-QAE0420G1-V stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Hikvision

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd