Havis C-TSM-CHGR-P-1 Handleiding

Havis Carkit C-TSM-CHGR-P-1

Lees hieronder de πŸ“– handleiding in het Nederlandse voor Havis C-TSM-CHGR-P-1 (3 pagina's) in de categorie Carkit. Deze handleiding was nuttig voor 17 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/3
INSTALL INSTRUCTIONS C-TSM-CHGR-X-1
TRUNK SIDE MOUNT FOR 2011-2013 DODGE CHARGER
X = β€œD” DRIVERS SIDE OR β€œP” PASSENGER SIDE
TOOLS REQUIRED:
Phillips Screwdriver
Jig Saw
Powered drill with 5/32” drill bit
HARDWARE:
QTY DESCRIPTION PART #
5 #10 x ¾” Sheet metal screws GSM33195
Always!
 Read all instructions before installing any Havis, Inc. products.
 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
 Use hardware provided with install kit
C-TSM-CHGR-P-1 shown
Trunk Side Mount
(Passenger Side)
NOTE:
This instruction
shows the passenger side
installation. The Drivers side
will install the same way.
C-TSM-CHGR-X-1_INST_8-11
Make sure door has clearance at
rear trunk trim panel.
With Trunk Side Mount in
position, drill three 5/32”” holes
into floor.
Remove fender liner.
Run wiring as needed for
emergency equipment.
Unclip and move wiring at side floor
area. Make sure it is repositioned so
it will not get damaged.
Replace fender liner.
View of passenger side trunk
area prior to installation. Remove side cargo hook.
Mount screw to be reused later
(Phillips screwdriver)
Remove rear loop trim panel
fastener
Place Trunk Side Mount frame
assembly into position and attach to
inner fender with previously
removed Cargo hook screw into
original hole.
Attach lower frame to floor with
# 10 x 3/4” sheet metal screws.
C-TSM-CHGR-X-1_INST_8-11
Drill 5/32”holes at upper bracket
(next to OEM screw) and attach with
# 10 x 3/4” Sheet metal screws
Mount and wire equipment on
inside door panel.
Finished Passenger-Side Mount
shown with full width trunk tray
Finished C-TSM-CHGR-P-1 (Passenger Side Trunk Side Mount)
Shown with Full Size Spare Tire.
NOTE: If your vehicle has the small donut spare tire, the flip up trunk
liner should just clear the Trunk Side Mount.


Product specificaties

Merk: Havis
Categorie: Carkit
Model: C-TSM-CHGR-P-1
Kleur van het product: Zwart
Compatibele producten: 2011-2014 Dodge Charger

Heb je hulp nodig?

Als je hulp nodig hebt met Havis C-TSM-CHGR-P-1 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Carkit Havis

Handleiding Carkit

Nieuwste handleidingen voor Carkit

Metra

Metra 99-7339B Handleiding

17 November 2024
Scosche

Scosche HA1714B Handleiding

17 November 2024
Metra

Metra 99-7345B Handleiding

17 November 2024
Metra

Metra AX-ADCT4 Handleiding

17 November 2024
Metra

Metra 95-7883HG Handleiding

17 November 2024
Metra

Metra 95-5026 Handleiding

17 November 2024
Metra

Metra 99-7367HG Handleiding

23 Augustus 2024
Metra

Metra 99-8223 Handleiding

23 Augustus 2024