Hager WGDEDR500 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Hager WGDEDR500 (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 50 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
www.hager.com
Safety instructions
Electrical equipment must only be installed and assembled by a qualiîš¿ed
electrician in accordance with the relevant installation standards, regulations,
directives and safety and accident prevention directives of the country.
Failure to comply with these installation instructions may result in damage to
the device, îš¿re or other hazards.
Function
Switching and dimming of incandescent lamps, high-voltage halogen lamps as well as
dimmable electronic transformers (marked with L, C) with halogen lamps.
Recommendation: Use Osram transformator ET-PARROT 105/220…240 I.
Correct use
- For the ush-mounted installation in standard wall boxes
(recommended wall box depth ≥ 35 mm).
- Only suitable for use in indoor areas with no drip and no spray water.
Product characteristics
- Dimming principle: phase cut-on
- Change-over switch in combination with change-over switch possible.
- Short-circuit proof and overload proof
Technical data
Rated voltage: 230 V~
Frequency: 50/60 Hz
230 V incandescent and halogen lamps: 40 ... 500 W
Electronic transformers (marked with L,C): 40 ... 250 W
Conductor cross-section of screw terminals: max. 3 x 1.5 mm²
Distance of îš¿xing holes: 60.3 mm
Operating temperature: -5 ... +45 °C
Relative humidity (without condensation): 5 ... 95 % (at 25 °C)
Standards: BS EN 60669-2-1, IEC 60669-2-1
Mixed operation of 230 V incandescent and halogen lamps as well as electronic
transformers (marked with L,C until smallest maximum load possible.
40-500W Single dimmer
Hager Dream
Installation and operating
instructions
2
Operating the device
The switch-on brightness level depends on the position of the dimmer.
Information for electricians
Installation and electrical connection
DANGER!
Touching live parts can result in an electric shock.
An electric shock can lead to death.
Disconnect the connecting cables before working on the device and
cover all live parts in the area!
ç
Preparing the device for installation
Notches
Cover
1
Carefully loosen the cover on the notches with a at-blade screwdriver (1).
îš„Remove the cover.
3
Connecting the device
L1
L2
L
N
L1
L2
L
N
2A 2B
îš„Strip connection cables approx. 11 mm.
îš„Wire the dimmer according to the connection diagram (2A). Can be installed alter-
natively with a change-over switch ( ).2B
Installing the device into the wall box
3
îš„After wiring, îš¿x the dimmer with the two screws attached into the wall box (3).


Product specificaties

Merk: Hager
Categorie: Niet gecategoriseerd
Model: WGDEDR500

Heb je hulp nodig?

Als je hulp nodig hebt met Hager WGDEDR500 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Hager

Hager

Hager FN296E Handleiding

16 November 2024
Hager

Hager FN117E Handleiding

16 November 2024
Hager

Hager FN097E Handleiding

16 November 2024
Hager

Hager FN367E Handleiding

16 November 2024
Hager

Hager MZN131 Handleiding

16 November 2024
Hager

Hager EG203 Handleiding

16 November 2024
Hager

Hager GS11019016 Handleiding

16 November 2024
Hager

Hager JK132E Handleiding

5 Januari 2024
Hager

Hager JK101SE Handleiding

5 Januari 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd