GPX C253B Handleiding

GPX Radio C253B

Lees hieronder de 📖 handleiding in het Nederlandse voor GPX C253B (2 pagina's) in de categorie Radio. Deze handleiding was nuttig voor 23 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/2

Warning: Changes or modications to this unit not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

USER’S GUIDE

V: 805-01

C253B Clock Radio with Dual Alarm

FCC Warnings

Introduction and Setup

Plug the included AC/DC power adapter into

the on the dock and an AC DC POWER INPUT

power outlet to power the dock.

LINE IN

Power

The battery backup is intended for short

power outages only. The clock radio’s primary

functions cannot run off of the battery backup

alone.

Requires 2, AAA-size, batteries (not included)

Battery Backup

LINE IN

Dimmer

Press to dim the

display.

Tuning/Min/Hour

Press to tune the

radio.

Press to adjust the

minute or hour when

setting the clock or

alarm.

Clock/Mem

In Off mode, press

and hold to begin

setting the time.

In radio mode, press

to cycle through

preset stations.

LED Display

Line Input

Source/AL Off

Press repeatedly to switch

between Line in, FM, or AM

Radio modes. Press and

hold to turn off the radio.

Press to turn off the alarm.

Snooze/Sleep

Press to snooze the

alarm after it sounds.

In on mode, press

repeatedly to set the

sleep timer.

Alarm 1 Buzzer/

Radio Indicator

Lights when the

alarm 1 is on and set

to buzzer or radio.

Alarm 2 Buzzer/

Radio Indicator

Lights when the

alarm 2 is on and set

to buzzer or radio.

Volume/AL1/AL2

Press to adjust the volume.

Press to begin setting Alarm 1

or Alarm 2. Note: Volume will

not function in line in mode.

For Warranty Information and the most up-to-date version of this User’s Guide, go to www.gpx.com 1-888-999-4215Customer Service:

Email Support: Email Parts: prodinfo@dpiinc.com, partsinfo@dpiinc.com

Specications are subject to change without notice.

PM Indicator

Lights when the time is in

the PM.

1. If in radio mode, press and hold

the Source/Al Off button to turn

the unit off.

2. Press the or button.Al1 Al2

3. Press the button to adjust Hour

the hour.

The PM indicator will light when

the hour is set in the PM.

4. Press the button to adjust Min

the minute.

The Alarm 1 or Alarm 2 indicator

will come on.

5. Press the or buttons Al1 Al2

repeatedly to switch between

Radio, Buzzer or off.

If the alarm is set to Radio, use

the Vol+/- buttons to adjust the

volume of the alarm.

6. Once the set alarm time is

reached, the alarm will sound.

To set the other alarm, follow

the above steps and choose the

alarm not currently set.

1. Press the Source/Al Off button

to turn the clock radio on.

2. Press the Source/Al Off button

again to switch between the AM

and FM radio mode.

3. Press the Tun+ Tun-and

buttons to adjust the radio to

the desired frequency.

4. Press and hold the Tun+ and

Tun- buttons to search for the

next available frequency.

5. Press the Vol+/- buttons to

adjust the volume.

6. Press and hold the Source/Al

Off to turn the radio off.

Clock and Sleep Timer Alarm

Radio

1. If in radio mode, press and hold

the Source/Al Off button to turn

the unit off.

2. Press and hold the Clock/Mem

button until the display begins

to blink, then release the button.

3. Press the button to adjust Hour

the hour.

The PM indicator will light when

the hour is set in the PM.

4. Press the button to adjust Min

the minute.

5. Press the button to Clock/Mem

nish setting the time.

Setting the Clock

1. Press the button Snooze/Sleep

repeatedly to set the sleep timer

( 90, 80, 70, 60, 50, 40, 30, 20,

10 min or OFF ).

2. Once the set sleep time has

expired the clock radio will

automatically power off.

Setting the Sleep Timer

Setting the Alarm

1. Follow the instructions for

Setting the Alarm.

2. Press the or buttons Al1 Al2

repeatedly until the indicator is

no longer lit.

Cancelling the Alarm

After the alarm sounds:

Press the button to Snooze/Sleep

delay the alarm for an additional 9

minutes.

Press the Source/Al Off button to

turn the alarm off until the set alarm

time is reached again.

Snooze and Alarm Reset

Tuning the AM or FM Radio

1. Follow the instructions for

Tuning the AM or FM Radio.

2. Tune to the desired station.

3. Press and hold the Clock/Mem

button to save the current radio

station as a preset.

Saving a Station as a Preset

1. Follow the instructions for

Tuning the Radio and Saving a

Station as a Preset.

2. Press the button Clock/Mem

to cycle through preset radio

stations.

Tuning to a Preset Radio Station

Adjust the position of the FM

Antenna to improve FM radio

reception.

An AM antenna is built into the

clock radio. To improve AM radio

reception, adjust the position of the

clock radio.

Radio Reception

To download this User’s Guide in English, Spanish,

or French, or to get answers to frequently

asked questions, visit the support section at:

www.gpx.com

Para descargar este Manual del Usuario en

inglés, español y francés, o para obtener

respuestas a preguntas frecuentes,

visite la sección de apoyo en

www.gpx.com

Pour télécharger ce guide de l’utilisateur en

anglais, espagnol ou français, ou pour obtenir

des réponses à des questions fréquemment

posées, consultez la rubrique d’assistance sur

www.gpx.com

International Support

For Warranty Information and the most up-to-date version of this User’s Guide, go to www.gpx.com Customer Service: 1-888-999-4215

Email Support: Email Parts: prodinfo@dpiinc.com, partsinfo@dpiinc.com

Specications are subject to change without notice.

Requires a 3.5mm audio cable (not

included).

1. Connect a 3.5mm audio cable

to the and the audio Line Input

output on an MP3 player or

other audio device.

2. Press the Source/Al Off to

switch to Line in mode.

The display will show “AU”

3. Use the native controls on the

connected MP3 player or other

audio source to play your audio

through the unit. The volume

buttons on the unit will not

function in line in mode, so it is

necessary to use the controls

on the native device.

When not in use, make sure to

disconnect the 3.5mm audio

cable (not included).

Line Input

Using the Line Input

Product specificaties

Merk:	GPX
Categorie:	Radio
Model:	C253B
Kleur van het product:	Zwart
Ingebouwd display:	Ja
Geïntegreerde klok:	Ja
Beeldschermdiagonaal:	1.2 "
Type aansluitplug:	3,5 mm
Inclusief AC-adapter:	Ja
Waarschuwingssignaal:	Ja
Snooze functie:	Ja
Ingebouwde luidsprekers:	Ja
Gemiddeld vermogen:	- W
Ondersteund aantal accu's/batterijen:	2
Volumeregeling:	Digitaal
Hoofdtelefoonuitgangen:	1
FM-radio:	Ja
Soort tuner:	Digitaal
Wekker:	Ja
Klok functie:	Ja
Batterijen:	Nee
MP3 afspelen:	Nee
Ondersteunde frequentiebanden:	AM, FM
Aantal voorkeurszenders:	20
Radio:	Klok
Compatibele batterij grootte:	AAA
Apple docking-compatibiliteit:	Niet ondersteund
PLL-synthesizer:	Ja
Slaaptimer:	Ja
Type beeldscherm:	LED