GE GPF325W Handleiding

GE Vaatwasser GPF325W

Lees hieronder de đź“– handleiding in het Nederlandse voor GE GPF325W (8 pagina's) in de categorie Vaatwasser. Deze handleiding was nuttig voor 29 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
Installation
Instructions
GPF325 SERIES KITS
1/4" Custom Dishwasher Door
and Access Panel Kit
GPF325A, Almond Trim Kit
GPF325B, Black Trim Kit
GPF325C, Bisque Trim Kit
GPF325W, White Trim Kit
WARNING:
To prevent electric shock, disconnect electrical
power supply to dishwasher before changing
panels. Do not operate dishwasher while
changing panels or when lower access panel
assembly is removed.
TOOLS AND MATERIALS
REQUIRED:
• 1/4" socket driver
• Phillips screwdriver
• Electric drill
• 1/8" drill bit
• Masking tape
• Safety glasses
• Center punch
• Gloves to protect against sharp edges
The GPF325 trim kits provide for the installa-
tion of 1/4" thick custom door and access
panels.
KIT INCLUDES:
• Left, right and bottom door trim
• Top and bottom access panel trim
• Color matched screws
Before you begin
Read these instructions completely
and carefully.
IMPORTANT – Save these instructions
for local inspector’s use.
IMPORTANT – Observe all governing
codes and ordinances.
Note to Installer – Be sure to leave these
instructions with the Consumer.
Note to Consumer – Keep these instructions
with your Owner’s Manual for future
reference.
STOP
1 CUT 1/4" THICK CUSTOM
PANELS TO SIZE
• Cut door panel and access panel to the
dimensions shown.
NOTE: The trim provided will conceal the cut
edges of the panels.
1/4" Thick
Door Panel
23-9/16"
3-11/16"
18-7/8"
1/4" Thick Access Panel
2
AB
• Slide “Z” shaped trim under the
escutcheon.
• Place bottom trim against the bottom
of the door panel and drive center
screw, then left and right screws.
3 INSTALL DOOR PANEL TRIM
AND CUSTOM PANEL
• Remove the protective plastic covering
from side trim pieces.
2 RETIRE EL CONJUNTO DEL
PANEL DE ACCESO INFERIOR
• Remove the two screws below the access
panel. Retain screws.
• Loosen the two screws located between the
door and the access panel. Do not attempt
to remove these screws. They are secured
to the access panel with washers.
• Remove the access panel assembly from
the dishwasher.
• Remove the toekick and set aside.
NOTE: Do not remove the insulation behind
the access panel or toekick.
“Z” Trim
Loosen 2 Screws
Escutcheon
Door
Panel
Access Panel
Toekick
F
• Center punch and drill holes through the
holes in the side trim and into the dishwasher
door.
• Secure the trim to the door with color
matched screws provided. Remove tape.
E
• Use masking tape to hold trim tightly
against the custom panel.
3 INSTALL DOOR PANEL TRIM
AND CUSTOM PANEL (continued)
C
• Slide custom door panel under the
“Z” trim and bottom trim.
D
• The notch on the side trim pieces goes
towards the front. Slide side trim up and
under the escutcheon and over the edge
of the custom panel.
3
Tape Trim
to Custom
Panel on
Each Side
Drill Holes
and Install
Screws


Product specificaties

Merk: GE
Categorie: Vaatwasser
Model: GPF325W

Heb je hulp nodig?

Als je hulp nodig hebt met GE GPF325W stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Vaatwasser GE

Handleiding Vaatwasser

Nieuwste handleidingen voor Vaatwasser