GE DNCK440GAWC Handleiding

GE Wasdroger DNCK440GAWC

Lees hieronder de 📖 handleiding in het Nederlandse voor GE DNCK440GAWC (3 pagina's) in de categorie Wasdroger. Deze handleiding was nuttig voor 42 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/3
GE Appliances
DNCK440EA/GA—GE Commercial Smart Card Electric Dryer
R
Listed by
Underwriters
Laboratories
Specification Revised 2/02
Dryer Dimensions (in inches)
Exhaust Options:
Electric: 4-way via rear, right, left and bottom. Maximum recommended exhaust duct length
is 45 feet of 4” rigid ducting with two 90° elbows and a 4” dampered wall cap.
Gas: When viewed from the front of the unit, exhaust 3-way via rear, left and bottom.
Maximum recommended exhaust duct length is 15 feet of 4 rigid ducting with two 90” °
elbows and a 4 dampered wall cap.”
Circuit Requirements:
An individual, properly-grounded branch circuit, protected by a 30-amp circuit breaker or a
time-delay fuse, is required.
Electric Dryer Rating:
208/240V, 5600W, 24A, 60Hz
208V, 4400W, 22A, 60Hz
A special 208 volt heater, part # WE11X0101 is avaialable to reduce drying time in
208 volt installations.
Gas Circuit Requirements: An individual branch circuit fused for 15- or 20-amp is required
for each dryer.
Gas Dryer Rating: 115V; 60Hz
Gas (BTU/Hr): 22000. Factory equipped for natural gas. tested for LP gas. A conversion Kit is
required for LP gas.
Note: Dryer wall outlet must be located within 36" of service cord entry and accessible
when dryer is mounted in position.
Installation Information: For complete information, see installation instructions packed
with your dryer.
36 42
27
23-1/2
2-1/2
25-1/2*
Side View Rear View
5-1/4
25-3/4
23-1/2
11-1/2
*24-1/2" from the edge of the side panel to the front.
25-1/2" from front to edge of endcaps.
For answers to your Monogram,
® GE Profile™or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center®service, 800.626.2000.
GE Appliances
Specification Revised 2/02
DNCK440EA/GA—GE Commercial Smart Card Electric Dryer
Features and Benefits
•Super 7.0 Cu. Ft. Capacity
•3 Dry Cycles: High Heat; Medium Heat; Low Heat
•4 Heat Selections
•Cool Down (with High Heat Cycle)
•ESD Smart Card Reader with Alphanumeric Display and Control Card
• Digital Cycle Countdown with LED Indicators
•Quiet Package
• Lockable Lint Filter
• Reversable Door Swing
• DuraDrum™Interior
• Model DNCK440EAWC–White
• Model DNCK440GAWC–White
GE Appliances
Specification Revised 2/02
DNCK440EA/GA—GE Commercial Smart Card Electric Dryer
Dryer Exhausting Information Use Metal Duct Only—For complete information, see installation instructions packed with your dryer.
Ducting Materials:
For best performance, this dryer should be vented with 4 diameter all rigid metal exhaust duct. If ” “all rigid metal”
duct cannot be used, then flexible all metal“ ” venting can be used, but it will reduce the maximum recommended
duct length.
Exhaust Length Calculation:
1. Determine the number of 90°turns needed for your installation. If you exhaust to the side
or bottom of dryer, add one turn.
2. The maximum length of 4 rigid (aluminum or galvanized) duct which can be tolerated is shown ’
in the table. The maximum length for flexible ducts are less than for rigid duct.
A turn of 45°or less may be ignored. Two 45 elbow. A°turns within the duct length should be treated as a 90°
turn over 45 should be treated as a 90° ° elbow.
Exhausting the dryer to the outside is strongly recommended to prevent large amounts of moisture and
lint from being blown into the room. Gas dryers or any dryer located in a closet must be exhausted to the outside.
Caution: For personal safety do not terminate exhaust into a chimney, under any enclosed
house floor (crawl space), or into an attic, since the accumulated lint could create a fire hazard
or moisture could cause damage. Never terminate the exhaust into a common duct or plenum with a kitchen
exhaust, since the combination of lint and grease could create a fire hazard.
Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird nesting, etc. The wall
cap must also be located at least 12 above the ground or any other obstruction with the opening pointed Down.”
Other terminations, such as louvered wall boxes, are acceptable provided they are equivalent to a 4 opening”
dampered wall cap.
For more information on venting kits and accessories, please call 1-800-GE-CARES.
Special Installation Requirements
Alcove or Closet Installation:
•If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.
•The dryer MUST be exhausted to the outside.
•Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:
0” either side
3” front and rear
• ” Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52 .
•Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of open area
equally distributed. If this closet contains both a washer and a dryer, doors must contain a minimum of 120 sq. in.
of open area equally distributed.
•The closet should be vented to the outdoors to prevent gas pocketing in case of a gas leak in the supply line.
•No other fuel-burning appliance shall be installed in the same closet with the dryer.
Bathroom or Bedroom Installation:
•The dryer MUST be exhausted to the outdoors.
•The installation must conform with the local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI
Z223.
Minimum Clearances other than Alcove or Closet Installation:
•Minimum clearances to combustible surfaces
0” both sides
3” rear
R
Listed by
Underwriters
Laboratories
4
B
2-1/2
A
0 90 ft. 60 ft. 55 ft. 45 ft.
1 60 ft. 45 ft. 40 ft. 30 ft.
Super & Extra-Large 2 45 ft. 35 ft. 30 ft. 20 ft.
6.0 Capacity Models 3 35 ft. 25 ft. 20 ft. 15 ft.
All Electric Dryers 4 25 ft. 15 ft. 15 ft. 10 ft.
0 45 ft. 30 ft. 30 ft. 15 ft.
Super & Extra-Large 1 35 ft. 20 ft. 20 ft. 10 ft.
6.0 Capacity Models 2 25 ft. 10 ft. 10 ft. —
All Gas Dryers 3 15 ft. — — —
0 60 ft. 48 ft. 30 ft. 18 ft.
1 52 ft. 40 ft. 22 ft. 14 ft.
Extra-Large 5.7 2 44 ft. 32 ft. 14 ft. 10 ft.
Capacity Electric 3 32 ft. 24 ft. — —
and Gas Dryers 4 28 ft. 16 ft. — —
Number
of
90°
Turns
Maximum Length of 4"
Dia. Rigid Metal Duct
Maximum Length of 4"
Dia. Flexible Metal Duct
Exhaust Hood Type Exhaust Hood Type
Domestic
Dryer Models
A
4" Opening
B
2-1/2"
Opening
A
4" Opening
B
2-1/2"
Opening
Best Performance
For answers to your Monogram,
® GE Profile™or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center®service, 800.626.2000.

Product specificaties

Merk: GE
Categorie: Wasdroger
Model: DNCK440GAWC

Heb je hulp nodig?

Als je hulp nodig hebt met GE DNCK440GAWC stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Wasdroger GE

GE

GE FPDW1 Handleiding

7 December 2024
GE

GE SBSD137HMS Handleiding

7 December 2024
GE

GE GFD40ESCMWW Handleiding

30 November 2024
GE

GE PFD95ESPWGN Handleiding

23 September 2024
GE

GE SPLK10N01A Handleiding

23 September 2024
GE

GE ETD48EASWWB Handleiding

27 Juni 2024
GE

GE GTD48GASWWB Handleiding

16 April 2024
GE

GE GTD48EASWWB Handleiding

16 April 2024
GE

GE GTD38EASWWS Handleiding

16 Maart 2024
GE

GE Profile PFD87GSPVRS Handleiding

16 Maart 2024

Handleiding Wasdroger

Nieuwste handleidingen voor Wasdroger

Svan

Svan SSB800A2DB Handleiding

21 December 2024
Haier

Haier HD100-A3959E-IT Handleiding

20 December 2024
Haier

Haier HD100-A3959RE-IT Handleiding

20 December 2024
Bosch

Bosch WTN832M1NL Handleiding

17 December 2024
Ufesa

Ufesa Pro Ionic-Shine Handleiding

17 December 2024
Ufesa

Ufesa Pro Ionic Style Handleiding

17 December 2024
Altus

Altus ADP80W Handleiding

17 December 2024
BEKO

BEKO B5T69233MG Handleiding

15 December 2024
AEG

AEG T65170AV Handleiding

12 December 2024
Haier

Haier HD90-A3979NU1 Handleiding

10 December 2024