Gasmate Column Outdoor CH205MB Handleiding

Gasmate Heater Column Outdoor CH205MB

Lees hieronder de 📖 handleiding in het Nederlandse voor Gasmate Column Outdoor CH205MB (8 pagina's) in de categorie Heater. Deze handleiding was nuttig voor 11 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
03432 07/16
Important: Retain these instructions for future use.
FOR YOUR SAFETY
If you smell gas:
1. Shut off the gas to the appliance.
2. Extinguish any open flame.
3. If odour continues, immediately call
your gas supplier.
Do not store or use gasoline or other flammable
vapour and liquids in the vicinity of this or any other
appliance.
FOR OUTDOOR USE ONLY
PROPANE GAS
WARNING
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
Read the instructions thoroughly before installing or
servicing this equipment.
Model No. CH205MBODS
The ideal solution for extending the season of
outdoor entertaining
Creates a stylish and attractive ambience
Rotary piezo ignition
Includes a safety ‘tip-over’ switch that halts supply of
gas to the unit should it be accidently knocked over
Oxygen depletion system for enhanced safety
Stainless steel burner for extra long-term reliability
Complete with hose and POL regulator
Efficient and powerful 35MJ/h output
Adjustable heat output
Operates for approximately 10 hours on a properly
filled 9Kg Propane cylinder
For outdoor use only
Gas certified to Australian standards
22
INSTALLATION, OPERATION & MAINTENANCE INSTRUCTIONS
This appliance must only be used in a well
ventilated area.
1. This appliance shall not be installed or
used indoors, in buildings, garages or
any other enclosed area.
2. place articles on or against this DO NOT
appliance.
3. use or store flammable DO NOT
materials near this appliance.
4. Children and adults should be
alerted to the hazards of high surface
temperatures, burns and clothing
ignition.
5. Children should be carefully supervised
when they are in the area of the
appliance.
6. hang anything including NEVER
clothes or other flammable items on the
appliance.
7. operate this appliance unless DO NOT
it is fully assembled with burner guard in
place.
8. DO NOT SPRAY AEROSOLS IN THE
VICINITY OF THIS APPLIANCE WHILE
IT IS IN OPERATION.
9. Installation and repair should be done
by a qualified service person. The
appliance must be inspected before
use and at least annually by a qualified
service person. It is imperative that
control compartment, burners and
circulating air passages of the heater be
kept clean.
IMPORTANT SAFETY RULES
Prior to assembling your appliance, the following
must be reviewed. Compliance with the following
should result in satisfactory heater operation.
This instruction manual should be retained for
future reference. The installation must conform
with local codes or authority having jurisdiction.
1. The appliance is intended for heating
residential and non-residential outdoor
spaces. The installation must conform with
local codes or, in the absence of local codes,
with the Australian Standard AS 5601.
2. Adequate clearance around air openings
into the combustion chamber, clearances
from combustible materials, provisions for
accessibility and for combustion and
ventilating air supply must be maintained at
all times when the appliance is operating.
3. Proper clearance from combustible materials
must be maintained at all times.
The minimum clearances are as follows:
Minimum Clearance from Combustibles
Side Rear 500mm 500mm
Ceiling Below 500mm 500mm
Combustible materials are considered to be
wood, compressed paper, plant fibres, plastic,
plexiglas or other materials capable of being
ignited and burned. Such materials shall be
considered combustible even though flame
proofed, fire-retardant treated or plastered.
Additional clearance may be required for glass,
painted surfaces and other materials which may
be damaged by radiant or convection heat.
4. Heaters must be placed on a level and
adequate footing and be readily accessible.
5. The gas manifold supply pressure must
be regulated at 2.75 kPa utilising an AGA
approved regulator (supplied with heater).
6. The appliance must be inspected before
each use, and at least annually by a qualified
service person.
a. The appliance area must be kept clear
and free of combustible materials,
gasoline and other flammable vapours
and liquids.
b. Gas orifices and burner must be kept
clear of dirt and cobwebs. Flow of and
ventilation air through the perforated
portions of the heater must not be
obstructed. Cleaning with a soft brush
before use and at least every six months
is recommended.
c. All gas connections should be checked
for leaks utilising a soap solution. NEVER
use a flame for this purpose.
3
INSTALLATION - OUTDOOR USE ONLY
d. The flame pattern at the emitter grid
should be visually checked whenever
heater is operated. If flames extend
beyond surface of the emitter grid or
black spot is accumulating on the emitter
grid or reflector, the heater should be
turned off immediately. The heater should
not be operated again until the unit is
serviced and or repaired.
e. Any cleaning agent used on the heater
should be of a non-combustible and non-
corrosive nature.
f. The stainless steel emitter grid normally
does not require cleaning and should
NEVER be painted.
7. The hose must be protected from contact
with hot or sharp surfaces both during use
and while in storage. The hose assembly
should be visually inspected prior to each
use of the heater. If excessive abrasion or
wear is evident, or the hose is cut, it must
be replaced prior to operating the heater.
The replacement hose assembly may be
obtained from the manufacturer.
8. use any pressure regulator or hose DO NOT
assembly other than those supplied with the
appliance. Replacement pressure regulator
and hose assembly must be those specified.
Replacement parts may be obtained from
the manufacturer or your local sales
representative.
9. Installation and use of this heater must
conform with local codes or, in the
absence of local codes, with the Standards
of Storage and Handling of Liquefied
Petroleum Gases.
10. This heater is designed to operate with
a standard 9Kg propane cylinder with
Approved Cylinder Connection.
11. The valve outlet must be maintained in good
condition. When the cylinder is not in
use, be sure to cover it with a dust cap. A
leak test should be performed with soapy
water whenever connecting a new cylinder.
NEVER use a match to test for leaks.
12. The gas cylinder must be turned off
whenever the heater is not in use. When
the heater is to be stored indoors, the
propane cylinder and the heater must be
disconnected and the cylinder stored in
accordance with the Standard for Storage
and Handling of Liquefied Gases.
13. The heater has been designed with several
safety features which include a tip over
switch.
Screw the coupling nut of regulator into the
cylinder valve outlet.
POL CYLINDER CONNECTION DEVICE
Type of Gas Propane
Consumption 35 MJ/h
Operating Pressure 2.75 kPa
Injector Size 1.9 mm
Heater specifications can be found on the data
label.
Any modification to the heater not described in
the installation instructions may compromise the
safety of this appliance. Special concern is as
follows:
(1) shorten post length;DO NOT
(2) bypass thermocouple safety;DO NOT
(2) operate heater without the reflector;DO NOT
Clothing or other flammable materials should not
be hung from the heater, or placed on or near
the heater. The area above the burner may be
extremely hot. Direct contact with these metal
surfaces should be avoided in order to prevent
burns or clothing ignition.


Product specificaties

Merk: Gasmate
Categorie: Heater
Model: Column Outdoor CH205MB

Heb je hulp nodig?

Als je hulp nodig hebt met Gasmate Column Outdoor CH205MB stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Heater Gasmate

Handleiding Heater

Nieuwste handleidingen voor Heater