Garmin Nüvi 260 Handleiding

Garmin Navigator Nüvi 260

Lees hieronder de 📖 handleiding in het Nederlandse voor Garmin Nüvi 260 (28 pagina's) in de categorie Navigator. Deze handleiding was nuttig voor 22 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/28
vi® 200-Series Bicycle Mount
Instructions 2–3 ………………………
Instructions (Français) 4–5 ………….
Istruzioni 6–7 ………………………
Anweisungen 8–9 ……………………
Instrucciones 10–11 ………………….
Instruções 12–13 ……………………..
Instructies 14–15 ……………………..
Instruktioner 16–17 …………………..
Ohjeet 18–19 ………………………
Instruksjoner 20–21 ………………….
Instruktioner 22–23 …………………..
Инструкции………… ……… 24–25
2-EN
InstructIons
The nüvi
®
200-series bicycle mount allows
you to attach your nüvi to your bicycle.
Garmin
®
s standard Limited Warranty
applies to this accessory. Refer to the limited
warranty and safety warnings in your nüvi Set
Up and Go guide before installing the bicycle
mount.
Do not expose the nüvi to caution:
water. Contact with water can cause the
nüvi to malfunction.
warning: You are responsible for
obeying all trafc laws when using your
nüvi on your bicycle, scooter, or other
vehicle with handlebars.
You can install the bicycle mount to the stem
or handlebars. The stem installation (shown
here) provides a more sturdy location. The
optional wedge should be used under the
mount for a better viewing angle.
To attach the bicycle mount to your
bicycle stem:
1. Insert the hard plastic half of the bicycle
mount into the half with the rubber
backing.
Release lever
Bike mount
Wedge (optional)
EN-3
For horizontal bars: Separate and
remove the top part of the mount, turn it
90 degrees, and replace. Continue with
step 2.
2. Place the wedge on the bicycle stem,
and then place the bicycle mount on
the wedge. Make sure the release lever
is on the left.
3. Thread the two cable ties through the
two slots on the bicycle mount. Position
the mount on your bicycle and attach
using the cable ties.
Release
lever
Cable ties
To attach the cradle to the bicycle
mount:
1. Fit the bottom of the nüvi in the cradle,
and snap the top of the nüvi into place.
2. Align the cradle with the bicycle mount.
3. Slide the cradle left onto the bicycle
mount until it snaps into place.
Change the Usage Mode on your TIP:
nüvi. Touch > > > Settings System
Usage Mode Bicycle > .
To release the cradle:
1. Remove the nüvi from the cradle.
2. Press down on the release lever, and
slide the cradle to the right.


Product specificaties

Merk: Garmin
Categorie: Navigator
Model: Nüvi 260
Kleur van het product: Zwart
Gewicht: 147.42 g
Breedte: 97 mm
Diepte: 71 mm
Hoogte: 20 mm
Bluetooth: Nee
Resolutie: 320 x 240 Pixels
Touchscreen: Ja
Vormfactor: Handheld
Levensduur accu/batterij: 5 uur
Maat: 3.5 "
Batterijtechnologie: Lithium-Ion (Li-Ion)
Water: Nee
Sport (fitness, hardlopen): Nee
Outdoor: Nee
Geocaching: Nee
Auto: Ja
Vliegen: Nee
Herkenningspunten in 3D: Ja
Voice maps: Ja
Aantal Waypoints: 500
Map view opties: 2D/3D
MP3-speler: Nee
Kaart geheugenopslag: Interne opbeging
Image viewer: Ja
Aantal nuttige plaatsen: 500

Heb je hulp nodig?

Als je hulp nodig hebt met Garmin Nüvi 260 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Navigator Garmin

Handleiding Navigator

Nieuwste handleidingen voor Navigator