Frigidaire PL36WC41EC Handleiding

Frigidaire Ventilator PL36WC41EC

Lees hieronder de đź“– handleiding in het Nederlandse voor Frigidaire PL36WC41EC (8 pagina's) in de categorie Ventilator. Deze handleiding was nuttig voor 48 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
1
!
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer. If you
have questions, contact the manufacturer at the address or telephone
number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service panel and
lock the service disconnecting means to prevent power from being
switched on accidentally. When the service disconnecting means can-
not be locked, securely fasten a prominent warning device, such as a
tag, to the service panel.
3. Installation work and electrical wiring must be done by a qualified
person(s) in accordance with all applicable codes and standards, in-
cluding fire-rated construction codes and standards.
4. Sufficient air is needed for proper combustion and exhausting of gases
through the flue (chimney) of fuel burning equipment to prevent
backdrafting. Follow the heating equipment manufacturer’s guideline
and safety standards such as those published by the National Fire Pro-
tection Association (NFPA), and the American Society of Heating, Re-
frigeration and Air Conditioning Engineers (ASHRAE), and the local code
authorities.
5. When cutting or drilling into wall or ceiling, do not damage electrical
wiring and other hidden utilities.
6. To reduce the risk of fire or electric shock, do not use this range hood
with an additional speed control device.
7. Ducted fans must always be vented to the outdoors.
8. To reduce the risk of fire, use only metal ductwork.
9. Use with approved cord-connection kit only.
10. This unit must be grounded.
TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
1. Never leave surface units unattended at high settings. Boilovers cause
smoking and greasy spillovers that may ignite. Heat oils slowly on low or
medium settings.
2. Always turn hood ON when cooking at high heat or when cooking flaming
foods.
3. Clean ventilating fans frequently. Grease should not be allowed to
accumulate on fan or filter.
4. Use proper pan size. Always use cookware appropriate for the size of
the surface element.
TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A
RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:*
1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray,
then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the
î‹‹ames do not go out immediately, EVACUATE AND CALL THE FIRE
DEPARTMENT.
2. NEVER PICK UP A FLAMING PAN — You may be burned.
3. DO NOT USE WATER, including wet dishcloths or towels - violent steam
explosion will result.
4. Use an extinguisher ONLY if:
A. You know you have a Class ABC extinguisher and you already
know how to operate it.
B. The fire is small and contained in the area where it started.
C. The fire department is being called.
D. You can fight the fire with your back to an exit.
* Based on “Kitchen Fire Safety Tips” published by NFPA.
READ AND SAVE THESE INSTRUCTIONS
Installer: Leave this manual with
the homeowner.
Homeowner: Operating and
Cleaning information on page 6.
CAUTION
1. For general ventilating use only. Do not use to exhaust hazardous or
explosive materials and vapors.
2. To avoid motor bearing damage and noisy and/or unbalanced impel-
lers, keep drywall spray, construction dust, etc. off power unit.
3. For best capture of cooking impurities, your range hood should be
mounted so that the top of the hood is 24-30” above the cooking sur-
face.
4. Please read specification label on product for further information and
requirements.
TABLE OF CONTENTS
This manual is divided into sections as follows:
• “PREPARE HOOD LOCATION”
Run ductwork from roof or wall cap, and electrical wiring from service
panel - to installation location
• “PREPARE THE HOOD”
Get your hood ready for installation
• “CONNECT WIRING”
Make electrical wiring connections to hood
• “INSTALL HOOD”
Secure hood to cabinet and ductwork - install bulbs and filters
• “OPERATION”
How to use the hood controls
• “CLEANING”
Keep your hood in top working condition
• “SERVICE PARTS”
Key numbers and exploded view of hood components
• “WARRANTY”
One-year limited warranty and how to contact us
NOTE If hood is to be installed Non-Ducted:
• Purchase a set of (2) non-ducted filters from your
local distributor or retailer and attach them to the
aluminum mesh filters.
Patent No.: US D450, 829 S
!!
FOR DOMESTIC COOKING ONLY
!
PROFESSIONAL SERIES MODELS
PL30WC4IEC
PL36WC4IEC
GALLERY SERIES MODELS
GL30WC4IES
GL36WC4IES
GL30WC4IEB
GL36WC4IEB
2
CABINET
BOTTOM
CABINET FRONT
HORIZONTAL DUCT
ACCESS HOLE
5ÂĽ"5ÂĽ"
7½"
1/8" Âľ"
1315/16" (30" hood)
1615/16" (36" hood) 13 15/16" (30" hood)
HOOD
MOUNTING
SCREWS (4)
ELECTRICAL
ACCESS HOLE
(in wall)
3Âľ"
16 15/16" (36" hood)
CENTER
LINE
WOOD SHIMS
(recessed-bottom
cabinets only)
)
SOFFIT
24" - 30" ABOVE
COOKING SURFACE
CABINET
3ÂĽ" X 10" DUCT
(For horizontal discharge)
WALL CAP
ROOF CAP 3ÂĽ" X 10" or
7" ROUND DUCT
(For vertical
discharge)
HOUSE WIRING
(Top or Back of hood)
HOOD
HOOD
HOOD
HOOD
HOOD
HOOD
PREPARE HOOD LOCATION
PREPARE THE HOOD
1 Remove 7” Round Duct Plate from top of hood. Set duct
plate aside - with mounting screws.
2 Remove tape holding Filters in place. Pull down on filter
tabs or finger holes and lift filters out. Set filters aside.
7” ROUND
DUCT PLATE
FILTERS
1 Determine whether hood will discharge vertically (3¼” x 10”
or 7” Round), or horizontally (3¼” x 10” only). For vertical or
horizontal discharge, run ductwork between the hood loca-
tion and a roof cap or wall cap. For best results, use a mini-
mum number of transitons and elbows.
2 Use diagrams, below, for proper placement of ductwork and
electrical cutout in cabinet or wall. For a non-ducted installa-
tion, DO NOT cut a duct access hole.
3 Run house wiring between service panel and hood
location.
VERTICAL DUCT
ACCESS HOLE
1¼" 1½"
10½"
5ÂĽ"5ÂĽ"
CENTER
LINE
HOOD MOUNTING SCREWS (4)
ELECTRICAL
ACCESS HOLE
(in cabinet bottom)
WOOD SHIMS
(recessed-bottom
cabinets only)
CABINET FRONT
CABINET BOTTOM
1315/16" (30" hood)
1615/16" (36" hood)
7½"
5"
2"
15 )
1315/16" (30" hood)
16
15 /16" (36" hood)
PREPARE HOOD LOCATION
3¼” X 10”
VERTICAL DUCTING
7” ROUND
VERTICAL DUCTING
3¼” X 10”
HORIZONTAL DUCTING
3
PREPARE THE HOOD PREPARE THE HOOD
4 Remove
Damper/Duct
Connector
from inside
the hood. Set
connector
aside - with
mounting
screws and
parts bag.
3 Remove
Teflon®-coated
bottom cover
from hood. Set
cover and
mounting screws
aside.
5 Remove
either top or
back wiring
knockout and
install
approved
Electrical
Cable Clamp.
DAMPER/
DUCT
CONNECTOR
ELECTRICAL CABLE CLAMP
TEFLON®-COATED BOTTOM COVER
(Held in place with 2 screws)
Teflon® is a registered
trademark of DuPont.
Non-Ducted Installation - Skip to Step 15.
6 Remove Light Panel - held in place with (3) #8 screws and
(2) #8 screws. Disconnect light assembly wire harness
(white connector).
(3) #8 SCREWS LIGHT
PANEL
(2) #8 SCREWS
The following
Steps (6 thru
14) are for
DUCTED
INSTALLATION
ONLY.
âž 
âž 
BAFFLE
7 Remove Air
Chute - held in
place with one
(1) screw.
NOTE: Be
careful not to
disconnect any
wires.
9 Rotate bae.
Reinsert baffle into
air chute (as
shown) so that
baffle tabs fit all the
way into slots in air
chute. An audible
“click” will be heard
when fully installed.
This will close off
the air flow through
the non-ducted
slots on top of
hood.
10
Re-install air chute, re-connect wire
harness, and replace light panel.
NOTE: Be careful not to trap wires
between support fin and light panel.
AIR CHUTE
SLOTS
âž 
âž 
8 Remove Baffle
from air chute.
âž 
BAFFLE
SUPPORT FIN
TABS


Product specificaties

Merk: Frigidaire
Categorie: Ventilator
Model: PL36WC41EC

Heb je hulp nodig?

Als je hulp nodig hebt met Frigidaire PL36WC41EC stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Ventilator Frigidaire

Handleiding Ventilator

Nieuwste handleidingen voor Ventilator

Livoo

Livoo DOM510 Handleiding

20 December 2024
Orava

Orava SF-13 Handleiding

18 December 2024
EMOS

EMOS P56PR2 Handleiding

14 December 2024
Midea

Midea FTS30-13AR Handleiding

14 December 2024
Midea

Midea FTS35-9AR Handleiding

14 December 2024
Midea

Midea FTS30-9AR Handleiding

14 December 2024