Frigidaire GL30WC41EB Handleiding

Frigidaire Ventilator GL30WC41EB

Lees hieronder de 📖 handleiding in het Nederlandse voor Frigidaire GL30WC41EB (8 pagina's) in de categorie Ventilator. Deze handleiding was nuttig voor 46 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/8

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO

PERSONS, OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manufacturer. If you

have questions, contact the manufacturer at the address or telephone

number listed in the warranty.

2. Before servicing or cleaning unit, switch power off at service panel and

lock the service disconnecting means to prevent power from being

switched on accidentally. When the service disconnecting means can-

not be locked, securely fasten a prominent warning device, such as a

tag, to the service panel.

3. Installation work and electrical wiring must be done by a qualified

person(s) in accordance with all applicable codes and standards, in-

cluding fire-rated construction codes and standards.

4. Sufficient air is needed for proper combustion and exhausting of gases

through the flue (chimney) of fuel burning equipment to prevent

backdrafting. Follow the heating equipment manufacturer’s guideline

and safety standards such as those published by the National Fire Pro-

tection Association (NFPA), and the American Society of Heating, Re-

frigeration and Air Conditioning Engineers (ASHRAE), and the local code

authorities.

5. When cutting or drilling into wall or ceiling, do not damage electrical

wiring and other hidden utilities.

6. To reduce the risk of fire or electric shock, do not use this range hood

with an additional speed control device.

7. Ducted fans must always be vented to the outdoors.

8. To reduce the risk of fire, use only metal ductwork.

9. Use with approved cord-connection kit only.

10. This unit must be grounded.

TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

1. Never leave surface units unattended at high settings. Boilovers cause

smoking and greasy spillovers that may ignite. Heat oils slowly on low or

medium settings.

2. Always turn hood ON when cooking at high heat or when cooking flaming

foods.

3. Clean ventilating fans frequently. Grease should not be allowed to

accumulate on fan or filter.

4. Use proper pan size. Always use cookware appropriate for the size of

the surface element.

TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A

RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:*

1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray,

then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the

ames do not go out immediately, EVACUATE AND CALL THE FIRE

DEPARTMENT.

2. NEVER PICK UP A FLAMING PAN — You may be burned.

3. DO NOT USE WATER, including wet dishcloths or towels - violent steam

explosion will result.

4. Use an extinguisher ONLY if:

A. You know you have a Class ABC extinguisher and you already

know how to operate it.

B. The fire is small and contained in the area where it started.

C. The fire department is being called.

D. You can fight the fire with your back to an exit.

* Based on “Kitchen Fire Safety Tips” published by NFPA.

READ AND SAVE THESE INSTRUCTIONS

Installer: Leave this manual with

the homeowner.

Homeowner: Operating and

Cleaning information on page 6.

CAUTION

1. For general ventilating use only. Do not use to exhaust hazardous or

explosive materials and vapors.

2. To avoid motor bearing damage and noisy and/or unbalanced impel-

lers, keep drywall spray, construction dust, etc. off power unit.

3. For best capture of cooking impurities, your range hood should be

mounted so that the top of the hood is 24-30” above the cooking sur-

face.

4. Please read specification label on product for further information and

requirements.

TABLE OF CONTENTS

This manual is divided into sections as follows:

• “PREPARE HOOD LOCATION”

Run ductwork from roof or wall cap, and electrical wiring from service

panel - to installation location

• “PREPARE THE HOOD”

Get your hood ready for installation

• “CONNECT WIRING”

Make electrical wiring connections to hood

• “INSTALL HOOD”

Secure hood to cabinet and ductwork - install bulbs and filters

• “OPERATION”

How to use the hood controls

• “CLEANING”

Keep your hood in top working condition

• “SERVICE PARTS”

Key numbers and exploded view of hood components

• “WARRANTY”

One-year limited warranty and how to contact us

NOTE If hood is to be installed Non-Ducted:

• Purchase a set of (2) non-ducted filters from your

local distributor or retailer and attach them to the

aluminum mesh filters.

Patent No.: US D450, 829 S

FOR DOMESTIC COOKING ONLY

PROFESSIONAL SERIES MODELS

PL30WC4IEC

PL36WC4IEC

GALLERY SERIES MODELS

GL30WC4IES

GL36WC4IES

GL30WC4IEB

GL36WC4IEB

CABINET

BOTTOM

CABINET FRONT

HORIZONTAL DUCT

ACCESS HOLE

5¼"5¼"

7½"

1/8" ¾"

1315/16" (30" hood)

1615/16" (36" hood) 13 15/16" (30" hood)

HOOD

MOUNTING

SCREWS (4)

ELECTRICAL

ACCESS HOLE

(in wall)

3¾"

16 15/16" (36" hood)

CENTER

LINE

WOOD SHIMS

(recessed-bottom

cabinets only)

)

SOFFIT

24" - 30" ABOVE

COOKING SURFACE

CABINET

3¼" X 10" DUCT

(For horizontal discharge)

WALL CAP

ROOF CAP 3¼" X 10" or

7" ROUND DUCT

(For vertical

discharge)

HOUSE WIRING

(Top or Back of hood)

HOOD

PREPARE HOOD LOCATION

PREPARE THE HOOD

1 Remove 7” Round Duct Plate from top of hood. Set duct

plate aside - with mounting screws.

2 Remove tape holding Filters in place. Pull down on filter

tabs or finger holes and lift filters out. Set filters aside.

7” ROUND

DUCT PLATE

FILTERS

1 Determine whether hood will discharge vertically (3¼” x 10”

or 7” Round), or horizontally (3¼” x 10” only). For vertical or

horizontal discharge, run ductwork between the hood loca-

tion and a roof cap or wall cap. For best results, use a mini-

mum number of transitons and elbows.

2 Use diagrams, below, for proper placement of ductwork and

electrical cutout in cabinet or wall. For a non-ducted installa-

tion, DO NOT cut a duct access hole.

3 Run house wiring between service panel and hood

location.

VERTICAL DUCT

ACCESS HOLE

1¼" 1½"

10½"

5¼"5¼"

CENTER

LINE

HOOD MOUNTING SCREWS (4)

ELECTRICAL

ACCESS HOLE

(in cabinet bottom)

WOOD SHIMS

(recessed-bottom

cabinets only)

CABINET FRONT

CABINET BOTTOM

1315/16" (30" hood)

1615/16" (36" hood)

7½"

15 )

1315/16" (30" hood)

15 /16" (36" hood)

PREPARE HOOD LOCATION

3¼” X 10”

VERTICAL DUCTING

7” ROUND

VERTICAL DUCTING

3¼” X 10”

HORIZONTAL DUCTING

PREPARE THE HOOD PREPARE THE HOOD

4 Remove

Damper/Duct

Connector

from inside

the hood. Set

connector

aside - with

mounting

screws and

parts bag.

3 Remove

Teflon®-coated

bottom cover

from hood. Set

cover and

mounting screws

aside.

5 Remove

either top or

back wiring

knockout and

install

approved

Electrical

Cable Clamp.

DAMPER/

DUCT

CONNECTOR

ELECTRICAL CABLE CLAMP

TEFLON®-COATED BOTTOM COVER

(Held in place with 2 screws)

Teflon® is a registered

trademark of DuPont.

Non-Ducted Installation - Skip to Step 15.

6 Remove Light Panel - held in place with (3) #8 screws and

(2) #8 screws. Disconnect light assembly wire harness

(white connector).

(3) #8 SCREWS LIGHT

PANEL

(2) #8 SCREWS

The following

Steps (6 thru

14) are for

DUCTED

INSTALLATION

ONLY.

➠

BAFFLE

7 Remove Air

Chute - held in

place with one

(1) screw.

NOTE: Be

careful not to

disconnect any

wires.

9 Rotate bae.

Reinsert baffle into

air chute (as

shown) so that

baffle tabs fit all the

way into slots in air

chute. An audible

“click” will be heard

when fully installed.

This will close off

the air flow through

the non-ducted

slots on top of

hood.

Re-install air chute, re-connect wire

harness, and replace light panel.

NOTE: Be careful not to trap wires

between support fin and light panel.

AIR CHUTE

SLOTS

➠

8 Remove Baffle

from air chute.

➠

BAFFLE

SUPPORT FIN

TABS

Product specificaties

Merk:	Frigidaire
Categorie:	Ventilator
Model:	GL30WC41EB

Heb je hulp nodig?

Als je hulp nodig hebt met Frigidaire GL30WC41EB stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Ventilator Frigidaire

Frigidaire FCVW3062AS Handleiding

26 December 2023

Frigidaire FCVW3062AD Handleiding

26 December 2023

Frigidaire F36WC19EC Handleiding

4 Juni 2023

Frigidaire PLHV36W7CC Handleiding

18 Mei 2023

Frigidaire UCVH2001AS Handleiding

14 Mei 2023

Frigidaire F30WV16EC Handleiding

2 Mei 2023

Frigidaire PLHV36W6CC Handleiding

29 April 2023

Frigidaire PLHV42P8CC Handleiding

25 April 2023

Frigidaire F30WV16EB Handleiding

24 April 2023

Frigidaire F30WR01ES Handleiding

16 April 2023

Handleiding Ventilator

Nieuwste handleidingen voor Ventilator

Aerian MISTY100 Handleiding

17 November 2024

Tornado HI-FAN-24HVWM-1P Handleiding

17 November 2024

Tornado HI-FAN-24PF-1P Handleiding

17 November 2024

Tornado HI-FAN-24MOWF-A-1P Handleiding

17 November 2024

Tornado HI-FAN-20HVWM-A-1P Handleiding

17 November 2024

Tornado HI-FAN-20WMPRO-1P Handleiding

17 November 2024

Tornado HI-FAN-24MOWF-WR-1P Handleiding

17 November 2024

Tornado HI-FAN-30HVOF-1P Handleiding

17 November 2024

Tornado HI-FAN-30POF-WR-1P Handleiding

17 November 2024

Tornado HI-FAN-20POF-5BA-1P Handleiding

17 November 2024