Frigidaire CFPWD15 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Frigidaire CFPWD15 (12 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 205 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12
El no desconectar el suministro ectrico an-
tes de la instalación apilada puede ocasio-
nar lesiones personales o incluso la muerte.
La instalación inadecuada de la ventilación
de la secadora puede ocasionar lesiones
personales o daños a la propiedad.
Para evitar lesiones en la espalda u otro
tipo de lesiones, procure levantar o mover
la lavadora o secadora con la ayuda de
más de una persona.
No apile la secadora sobre la lavadora si
ya está instalada sobre un pedestal.
137333700 A (1002)
Installation Instructions
15” Pedestal
Instructions d’installation
Socle de 38 cm (15 po)
Instrucciones de Instalación
Pedestal de 15" (38,1 cm)
Adjustable wrench
Clé à molette
Llave ajustable
Carpenter’s level
Niveau de charpentier
Nivel de carpintero
Optional universal
wrench available
from dealer
Clé universelle
optionnelle (en vente
chez le détaillant)
Llave universal opcional
(disponible a través
de su distribuidor local)
Phillips screwdriver
Tournevis Phillips
Destornillador Phillips
OR
OU
O
OR
OU
O
AND
ET
Y
AND
ET
Y
9/16” or 14 mm box wrench
Clé polygonale de
9/16 po ou de 14 mm
Llave de cubo de
9/16 po o 14 mm
26.5”
(67 cm)
42.5”
(108 cm)
15
(38 cm)
27
(68.5 cm)
Failure to disconnect from power source
before stacking could result in personal
injury or even death.
Improper installation of dryer venting
could result in personal injury or damage
to property.
To avoid back or other injury, have more
than one person move or lift the washer
or dryer.
Do not stack a dryer on top of washer
already installed on pedestal.
Ne pas débrancher l’appareil de sa source
d’alimentation en électricité avant de le super-
poser peut causer des blessures, voire la mort.
Une installation inappropriée du système
de ventilation de lacheuse peut causer
des blessures ou des dommages matériels.
Pour éviter les blessures au dos ou
d’autres types de blessure, demandez
l’aide d’autres personnes pour déplacer
ou soulever la laveuse ou lacheuse.
Ne superposez pas une sécheuse sur
une laveuse installée sur un socle.
Le poids total DANS un tiroir fermé ou une com-
binaison du poids DANS et SUR le tiroir ouvert ne doit pas excéder
29,5 kg (65 lb).
Total weight IN closed drawer or combination of IN
and ON TOP OF open drawer should not exceed 65 lb. (29.5 kg).
El peso total DENTRO del can cerrado o el peso
combinado de los artículos que estén DENTRO y ENCIMA del can
abierto no debe exceder las 65 lb (29,5 kg).
English continued on page 2. Pour la suite de la version française,
reportez-vous à la page 5.
La versión en español continúa en lagina 8.
WARNING AVERTISSEMENT ADVERTENCIA
Tools needed: / Outils nécessaires: / Herramientas necesarias:
GREEN KIT COMPONENTS:
2 Front brackets.A
2 Rear brackets.B
COMPOSANTS DU NÉCESS. VERT:
2 supports avant.A
2 supports arrière.B
PIEZAS DEL KIT VERDE:
2 soportes delanteros.A
2 soportes traseros.B
A
B
C
SCREW KIT COMPONENTS:
14 #10 (16 x .500) screws.C
COMPOSANTS DU NÉCESSAIRE DE VIS:
14 vis n° 10 (16 x .500).C
PIEZAS DEL KIT (TORNILLOS):
14 tornillos n.º 10 (16 x .500).C
1
2
Allow for approximately 5 in. (12.5 cm) behind the
pedestal for clearance of back of washer or dryer to the wall.
Allow additional space if venting dryer upward or downward.
If locking nuts are not removed on units with
metal feet, mounting holes in appliance will not align to
mounting holes in brackets.
Due to higher center of gravity of appliance on ped-
estals, some side-to-side rocking is normal during operation.
Vibration can be minimized by assuring appliance is installed
properly, including being level and solid on all four (4) legs by
following these directions.
If washer or dryer is new and has not been installed yet, skip to 1.
step 4.
If dryer is already installed, disconnect dryer from electrical and 2.
gas connections and exhaust venting.
If washer is already installed, disconnect washer from electrical 3.
connection. Turn off hot and cold water supply and disconnect
hot and cold water supply hoses from water supply outlets.
Disconnect drain hose from drain pipe. Remove hole plugs from
back sheet and reinstall shipping braces and bolts.
Protect fl oor and unit with cardboard or rug and carefully lay the 4.
appliance on its side and screw each leg completely into the base.
Prepare appliance for mounting
Prepare pedestal before mounting
Locate pedestal 1.
to within a few
inches of its
nal location.
Level the pedestal 2.
front-to-back and
side-to-side by ad-
justing each leveling
leg. Keep leg exten-
sion to a minimum.
Rock the pedestal from corner-to-corner to check for stability. 3.
Repeat leveling and rocking until all four (4) feet are sturdy on the
oor and pedestal is level.
Without turning the rubber foot, lock each pedestal leg in place 4.
by tightening its lock nut tight against the pedestal base.
DO NOT remove foam!
lock nut
raise lower
adjustable
pliers
If appliance has metal feet with a locking nut, unscrew them, 5.
remove the locking nut and reinstall the feet fl ush to the base.
If feet are not completely screwed in, mounting
holes in appliance will not align to mounting holes in brackets.
DO NOT use open dispenser drawer of washer
or dispenser cavity as hand-hold location when tipping washer
on its side. Serious damage could occur to your washer.
To avoid back - EXCESSIVE WEIGHT HAZARD -
or other injury, have more than one person move or lift the
appliance.
3
Attach front mounting brackets
Attach rear mounting brackets
DRAWER
1 - Appliance 2 - Side panel style of your appliance 3 - Rear bracket orientation
DRYER 3 indents on side. Rear brackets from
GREEN kit
Tab A into
Slot 1
Arrow pointing to
back
DRYER 2 indents on
side and 4 inch
knockout for side
venting.
Rear brackets from
GREEN kit
Tab B into
Slot 3
Arrow pointing to
front
WASHER 3 indents on side. Rear brackets from
GREEN kit
Tab A into
Slot 2
Arrow pointing to
back
WASHER 3 indents on side
in shape of “lOl”. Rear brackets from
GREEN kit
Tab A into
Slot 1
Arrow pointing to
front
TAB A
TAB B
DIRECTION
INDICATOR
ARROWS
Attach each front clip to outer-most 1.
set of holes with 2 screws.
Determine your appliance type (washer or dryer) and style of side panel ac-1.
cording to columns 1 and 2 in table below.
Orient rear brackets according to column 3 for your particular model.2.
Attach each bracket with 2 screws through the holes that line up on pedestal.3.
Each rear bracket has tabs marked “A” and “B”.
Each pedestal has slots in the rear marked “1”, “2”
and “3”.
Each rear bracket also has 2 arrows indicating
bracket direction when mounted on the pedestal.
Front brackets from
GREEN kit.
SLOT 1
SLOT 2
SLOT 3


Product specificaties

Merk: Frigidaire
Categorie: Niet gecategoriseerd
Model: CFPWD15

Heb je hulp nodig?

Als je hulp nodig hebt met Frigidaire CFPWD15 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Frigidaire

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd