Fetco HWD-2102 Handleiding
Fetco
Water dispenser
HWD-2102
Lees hieronder de 📖 handleiding in het Nederlandse voor Fetco HWD-2102 (12 pagina's) in de categorie Water dispenser. Deze handleiding was nuttig voor 46 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/12
FETCO®, and Driven To Innovation™ are trademarks or trade names of Food Equipment Technologies Company.
© 2012 Food Equipment Technologies Company May-2012
NOTICE TO INSTALLER: Please leave this book with the machine.
www.fetco.com
www.fetco.com
www.fetco.com
www.fetco.com www.fetco.com
Model:
Model:
Model:
Model: Model:
f Hot Water Dispenser HWD_2102
Hot Water Dispenser HWD_2102
Hot Water Dispenser HWD_2102
Hot Water Dispenser HWD_2102 Hot Water Dispenser HWD_2102
With
With
With
With With Portion
Portion
Portion
Portion Portion Control
Control
Control
Control Control
USERS GUIDE-Preliminar
y
Edition
®
2
FETCO Hot Water Dispenser HWD_2102
FETCO Hot Water Dispenser HWD_2102
FETCO Hot Water Dispenser HWD_2102
FETCO Hot Water Dispenser HWD_2102 FETCO Hot Water Dispenser HWD_2102
Contact Information
FETCO ®
Food Equipment Technologies Company
600 Rose Road
Lake Zurich • IL USA • • 60047-0429
Internet: www.fetco.com
Phone: (800) 338-2699 (US & Canada)
(847) 719-3000
Fax: (847) 719-3001
Email: sales@fetco.com
techsupport@fetco.com
Description & Features
The following are the factory settings—and range of variables that are adjustable:
Temperature Control: Water temperature is factory set at maximum 97°C/208°F
(Temperature selectable 50-97°C/122°-208°F)
Portion Control: Delivery volume factory set to deliver up to maximum 21fl.oz/630cc.
(Portion control selectable 5-53fl.oz/158-1575cc by timer adjustment)
Operating Instructions
Operating Instructions
Operating Instructions
Operating Instructions Operating Instructions
To Start:
Follow installation and set up procedures. If desired, set custom dispense temperature; dispense time/volume interval.
1) Open water valve
2) Power unit “ON” from rear power switch. Unit will fill and heat (up to 20 minutes for a new unit).
-After unit is filled and heated
3) Ready Lamp will glow green
-Unit may be operated when Ready Lamp is “off” (after initial fill).
4) White colored backlight intensity of control panel slowly pulsates during “READY” condition
Æ the HWD_2102 should be left “ON”. The hot water tank is well insulated to control energy loss.
-The HWD_2102 is ready to dispense-
Refer to control panel layout diagram for HWD_2102 hot water dispenser on Page 3
To dispense
1) Touch UNLOCK/DISPENSE pad for 1-3 seconds to unlock and activate dispensing system
-Border of UNLOCK/DISPENSE pad will change: briefly turn pink and blink signaling activation
2) Remove finger from pad
-Border of UNLOCK/DISPENSE pad will glow steady red: ready to dispense
3) Touch center of UNLOCK/DISPENSE pad to dispense. Keep finger on pad until dispense is complete.
-Dispense automatically stops when time out is complete, or if finger is removed.
Æ Dispense is unlocked and functioning only when Border of UNLOCK/DISPENSE pad is steady red.
Multiple dispenses are possible when the light bordering the UNLOCK/DISPENSE pad is steady and red colored
Lift finger and reactivate after portion by retouching pad for next dispense portion. Finger must be on pad to dispense.
The UNLOCK/DISPENSE pad rapidly flashes red if finger remains on it after dispensing and no water is dispensed.
If finger remains on the UNLOCK/DISPENSE pad more than 10 seconds while rapidly flashing red-the controls “lock out”
and READY LIGHT & HEATING LIGHT will flash rapidly to show a fault state. All controls are disabled during fault state.
To clear Fault State:
Switch machine “OFF” for about ten seconds, and then toggle back “ON” (Control Reset)
After controls initiate, hot water tank level and temperature are checked- then the “READY” light will activate .
Æ This will take approximately 2 minutes for filled and heated unit; up to 20-30 minutes for a new and empty unit.
3
CONTROL PANEL LAYOUT DIAGRAM FOR HWD_2102 HOT WATER DISPENSER
Power Lamp
(Unit is energized)
Ready Lamp
-Dispense will operate when lit,
-Temperature is low when not lit
Heating Lamp
For hot water tank
(is “ON” when heater is activated)
Touch Function Selector
selects and activates selected option
Border of UNLOCK/DISPENSE pad will:
glow white when ready to unlock
-after unlocking by tap of finger-
glow steady red when ready to dispense
flash rapidly to show a fault state
Silicone Tap for hot water dispenser
t∫f Touch Function Selector Technology
Operating Principles
The HWD_2102 delivers precision temperature water at selected temperatures. The green “READY” lamp must
be lit. Unit will dispense water if green “READY” lamp ins not lit.
Unit is factory calibrated at the optimum dispense portion of 21.3fl.oz/630cc (16 sec).
Hot water is drawn from the faucet, the fill valve cycles on and off to replenish the hot water tank.
The dispense valve faucet e bumper over the tap. is protected by a silicon
When dispensing water at a rate that exceeds the unit’s capacity to heat, the ready light will go off to show that
the selected preset temperature is not available. Always observe the “READY” lamp
When the “READY” lamp is lit – proper dispense temperature is enabled.
When heating or reheating, the green “READY” light will turn off and the “HEATING” light will display
Æ After exceeding the maximum optimum dispense portion of 21.3fl.oz/630cc the water supply in the hot
water tank begins do become depleted. The “READY” lamp will turn off. Dispenser faucet does not “lockout”.
This may allow less heated water to dispense. For the highest selected dispense when “READY” lamp is lit.
Æ When the HWD_2102 is powered on (or controller reset)- the controls check and adjust tank level and temperature.
This will take approximately 2 minutes for filled and heated unit; up to 20-30 minutes for a new and empty unit.
Product specificaties
| Merk: | Fetco |
| Categorie: | Water dispenser |
| Model: | HWD-2102 |
Heb je hulp nodig?
Als je hulp nodig hebt met Fetco HWD-2102 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Water dispenser Fetco
18 Juni 2023
17 Juni 2023
10 Juni 2023
9 Juni 2023
4 Juni 2023
30 Mei 2023
23 Mei 2023
20 Mei 2023
16 Mei 2023
Handleiding Water dispenser
- Water dispenser Electrolux
- Water dispenser Philips
- Water dispenser Panasonic
- Water dispenser Honeywell
- Water dispenser Siemens
- Water dispenser Tefal
- Water dispenser Hoover
- Water dispenser Arcelik
- Water dispenser Avanti
- Water dispenser Bartscher
- Water dispenser Breville
- Water dispenser Brita
- Water dispenser Buffalo
- Water dispenser Bunn
- Water dispenser Emerio
- Water dispenser Franke
- Water dispenser GE
- Water dispenser Gude
- Water dispenser Haier
- Water dispenser Hitachi
- Water dispenser Igloo
- Water dispenser Klarstein
- Water dispenser Korona
- Water dispenser Midea
- Water dispenser Morphy Richards
- Water dispenser Primo
- Water dispenser Princess
- Water dispenser ProfiCook
- Water dispenser Royal Sovereign
- Water dispenser Sodastream
- Water dispenser Sogo
- Water dispenser SPT
- Water dispenser Tiger
- Water dispenser Westinghouse
- Water dispenser Omega
- Water dispenser Caso
- Water dispenser Elba
- Water dispenser Orbegozo
- Water dispenser True
- Water dispenser Nutrichef
- Water dispenser Waring Commercial
- Water dispenser Brentwood
- Water dispenser Aarke
- Water dispenser Oasis
- Water dispenser Elkay
- Water dispenser Avalon
- Water dispenser Dornbracht
- Water dispenser NewAir
- Water dispenser Petkit
- Water dispenser Hatco
- Water dispenser Bloomfield
- Water dispenser InSinkErator
- Water dispenser Crathco
- Water dispenser Waterdrop
- Water dispenser Hiberg
- Water dispenser Cal-Mil
- Water dispenser Primo Water
- Water dispenser Perlick
- Water dispenser Healthy Choice
- Water dispenser SodaKING
- Water dispenser BIBO
- Water dispenser Imarflex
Nieuwste handleidingen voor Water dispenser
10 December 2024
9 December 2024
9 December 2024
3 December 2024
30 November 2024
24 November 2024
24 November 2024
24 November 2024
23 November 2024
18 November 2024