Extron DA4 RGBHV Handleiding

Extron Receiver DA4 RGBHV

Lees hieronder de 📖 handleiding in het Nederlandse voor Extron DA4 RGBHV (1 pagina's) in de categorie Receiver. Deze handleiding was nuttig voor 10 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/1

Setup Guide — DA RGB/YUV Series

This card provides quick start instructions for an experienced

installer to set up and operate an Extron DA2/4/6 RGB

or DA 6 YUV A distribution ampliﬁer.

N The DA RGBHV models buffer and distribute

RGBHV, RGBS, RGsB, and RsGsBs video.

The buffers and distributes DA6 YUV A

component video and digital audio. The DA

can also buffer and distribute RGBS, RGsB,

and RsGsBs video. By using the digital audio connections for composite sync rather than

audio, the DA can distribute RGBS video.

Installation

Step 1 — Mounting

Turn off or disconnect all equipment power sources and mount the transmitter and receiver

as required.

Use an optional RSU 129 1U Rack Shelf for rack mounting.DA2 RGBHV —

Use an optional MBU 125 Under-Desk Mount Kit to mount the DA under

furniture.

Use an optional MBD 129 Thru-Desk Mount Kit to mount the DA through

furniture.

Use the included rack mounting bracket for rack or through-desk mounting.All other DAs —

Use an optional MBU 149 1U Enclosure Under-Desk Mount Kit to mount

the DA under furniture.

Step 2 — Video input (all models)

Connect the RGB or component video input as shown. You can connect RGsB or RsGsBs

video to a DA6 YUV A. You can also connect RGBS video to a DA6 YUV A by connecting the

composite sync (S) input to the digital audio input BNC.

RGsB,

RsGsBs

(or component

video)

Component

video (or

RGBS, RGsB,

RsGsBs

DA6 YUV A

RGBHV

video

RGBS

video

H/V

B R

H/V

DA2 / 4 / 6 RGBHV

DA6 YUV ADA2 / 4 / 6 RGBHV

R-Y B-Y

DIGITAL

AUDIO

Step 3 — Digital audio input (DA6 YUV A only)

Connect a digital audio source to the input Digital Audio connector.

DIGITAL

AUDIO

If you are using the DA to buffer RGBS video, connect the composite sync (S)

input to this connector in place of the digital audio.

Setup Guide — DA RGB/YUV Series, cont’d

68-512-50

Rev. A 01 10

Step 4 — Video outputs

(all models)

Connect RGB or component video

displays or other devices as shown.

Make connections as shown at right.

You can use a DA6 YUV A to buffer

RGsB or RsGsBs video. You can also

output RGBS video by connecting

the composite sync (S) plane on the

digital audio BNC to the composite

sync (S) input of the video displays

or other devices.

Step 5 — Digital audio

outputs (DA6 YUV A only)

Connect digital audio devices to the output Digital Audio connectors. If you

are using the DA to buffer RGBS video, connect this BNC to the composite

sync (S) input of the video displays or other devices.

Step 6 — Mute connector (all, excluding DA6 YUV A)

Each active pin of the 9-pin D

connector is assigned to one

output of the DA (pin 2 is

assigned to all DA outputs).

Short and latch an active pin

to ground to mute the R, G,

and B video planes of that

output.

Step 7 — DIP switches

The DAs have two rear panel DIP switches; one to turn gain and peaking

AC/DCGAIN/PEAK

on and off (Spare on the DA6 YUV A) and one to turn AC coupling on and off.

Gain/Peak (RGB units only) — On (up) applies gain and peaking. Use this

position for long cable runs (up to 200 feet using Extron MHR cable). Off

(down) turns off gain or peaking. Use this position for short cable runs.

AC/DC switch — On (up) when the signal source has a high DC offset. Off (down) is the

default position for the best picture quality.

Step 8 — Power

Plug in a standard IEC power cord from a 100 to 240 VAC, 50 - 60 Hz power source into this

receptacle.

Operation

After all devices are powered up, the system is fully operational. If any problems are

encountered, verify that the cables are routed and connected properly and that all display

devices have identical resolutions and refresh rates. If your problems persist, call the Extron

S3 Sales & Technical Support Hotline at the number shown below closest to you.

Extron USA - West

Headquarters

+800 .63 3.9876

Inside USA / Canada Only

+1.714.491.1500

+1.714.491.1517 FAX

Extron USA - East

+800 .63 3.9876

Inside USA / Canada Only

+1.919.86 3.1794

+1.919.86 3.1797 FAX

Extron Europe

+800 .39 87.6 67 3

Inside Europe Only

+31.33.45 3.4040

+31.33.45 3.4050 FAX

Extron Asia

+800 .73 39.8766

Inside Asia Only

+65.6 38 3.440 0

+65.6 38 3.466 4 FAX

Extron Japan

+81.3.3 511.765 5

+81.3.3 511.765 6 FAX

Extron China

+400 .8 83.1568

Inside China Only

+86.2 1.37 60 .1568

+86.2 1.37 60 .1566 FAX

Extron Middle East

+971.4.29 918 00

+971.4.29 918 80 FAX

Pin Contact closure Function

1 Out #1 Mute output #1

—

Out all Mute all outputs

3 Not used

4 Out #2 Mute output #2

5 Gnd Ground

6 Out #3

Out #4

Out #5

Out #6

Mute output #3

Mute output #6

Mute output #4

Mute output #5

Female

5 1

9 6

Male

1 5

6 9

RGBHV

video

RGBS

video

RGsB,

RsGsBs

(or component

video)

Component

video (or

RGBS, RGsB,

RsGsBs

DA6 YUV A

DA2 RGBHV, DA4 RGBHV, DA6 RGBHV

H/V

VR G B

H/V

VRG B

H/V

VRG B

DIGITAL

AUDIO

YR-Y B-Y

DIGITAL

AUDIO

Product specificaties

Merk:	Extron
Categorie:	Receiver
Model:	DA4 RGBHV
Kleur van het product:	Zwart
Gewicht:	1700 g
Breedte:	444 mm
Diepte:	216 mm
Hoogte:	44 mm
Stroom:	100-240 A
Temperatuur bij opslag:	-40 - 70 °C
Luchtvochtigheid bij opslag:	10 - 90 procent
BNC output ports:	20
Bandbreedte:	350 MHz
BNC input ports:	5
AC-ingangsfrequentie:	50 - 60 Hz
Bedrijfstemperatuur (T-T):	0 - 50 °C
Relatieve vochtigheid in bedrijf (V-V):	10 - 90 procent