EMOS ZN1310 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor EMOS ZN1310 (16 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 32 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/16
1548131000_31-ZN1310_00_01 74 × 105 mm
ZN1310
GB LED Emergency Downlight
CZ LED nouzové svítidlo
SK LED núdzové svietidlo
PL Oprawa awaryjna LED downlight
HU LED vészvilágító lámpatest
SI Zasilna LED svetilka
RS|HR|BA|ME Protupanična LED svjetiljka sa svjetlom
usmjerenim prema dolje
DE LED Notleuchte
UA Світлодіодний аварійний світильник
RO|MD LED lampă de urgență
LT LED avarinis šviestuvas
LV LED avārijas gaismeklis
EE Alla suunatud LED-avariivalgusti
BG LED aварийно осветително тяло
за вграждане
www.emos.eu
2
A
B
ø 120 mm
5
1 2
2
1 2
3
3
GB | LED Emergency Downlight
Voltage: 220–240 V AC
Power consumption: 3 W
Charge time: 24 hours
Emergency duration: 3 hours
Operation: Non-maintained
Lumen output: 240 lm
Ingress Protection: IP20
Normal Operation: The red LED indicator light on means battery charging. Green LED indicator on means
battery is fully charged. LED indicator will icker in red in battery is disconnected.
Battery: Battery should be replaced when the required duration is no longer achieved. To avoid any damage
to the xture and ensure its performance, the battery should be replaced with same brand and type.
Test Switch: Press the test button, LED indicator will turn oand the sign will be illuminate from its
battery pack. The light source of this luminaire is not replaceable; when the light source reaches its
end of life the whole luminaire shall be replaced.
Installation instructions
A
Switch o the mains supply before installation.
1. Make a ø 120 mm size cut out hole in the ceiling. Thickness of mounting plate can be in the range
10 to 20 mm.
2. Take o the front cover and change the lens if needed.
3. Take o the battery cover and connect the battery.
4. Connect power supply.
5. Rotate spring and recessed xture into the cut out hole.
Turn on power supply.
B
Switch o the mains supply before installation.
1. Screw the surface mounting kit ZN1311 to the ceiling and proceed as gure 2–4 in installation
method A.
2. Snap downlight in the surface mounting kit.
Turn on power supply.
WARNING
Luminaire is suitable entirely for xed mounting.
The luminaire can be connected only to the electric distribution network, whose installation and
protection complies with the applicable standards.
Before any manipulation or servicing of the luminaire disconnect the luminaire from AC power. This
operation can be carried out only by an authorized person.
In case of any damage to any part of the luminaire, don’t use it.
LED chips inside the luminaire are not replaceable.
Don’t change inner wiring of the luminaire.
EMOS spol. s r. o. declares that the ZN1310 is in compliance with the essential requirements and
other relevant provisions of Directive. The device can be freely operated in the EU. The Declaration of
Conformity can be found at http://www.emos.eu/download.
CZ | LED nouzové svítidlo
Napětí: 220–240 V AC
Příkon: 3 W
Doba nabíjení: 24 hodiny
Doba zálohy: 3 hodiny
Režim provozu: Pohotovostní
Světelný tok: 240 lm
Stupeň krytí: IP20


Product specificaties

Merk: EMOS
Categorie: Niet gecategoriseerd
Model: ZN1310

Heb je hulp nodig?

Als je hulp nodig hebt met EMOS ZN1310 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd EMOS

EMOS

EMOS DCAZ10 Handleiding

16 November 2024
EMOS

EMOS ZV1161 Handleiding

14 November 2024
EMOS

EMOS DCTW14 Handleiding

24 September 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd